A 1.92m C 55° ww 6101 290 E F 72° 72° G. www

Q: One spring is placed inside the other, not touching each other, and compressed between a pair of…

A: As per given question 1. The force applied to the spring assembly. 2. The shear stress induced in…

Q: • Dimensions: width, b = 54 mm, depth, d = 110 mm, and height, h = 284 mm. • The modulus of…

A: Given:b=54 mmd=110 mmh=284 mmE=3 GPav=0.45θ=70°∆d=0.40 mm

Q: A body (W = 120 Ilb) is supported by a flexible ca- The ble and a spring (k= 80 lb/in.) as shown in…

A: Given Data: The weight of the block A is: W=120 lb. The spring constant is: k=80 lb/in The force…

Q: For a thin-walled hydraulic cylinder (where pressure is retained by a movable piston), and a long…

A: As per given question  We have determine force due to longitudinal stress

Q: Given the force in spring AD (150N), final length of spring EC (0.8m), spring constant k = 9 N/cm,…

A:

Q: 29. A point mass of 100 kg is dropped onto a massless elastic bar (cross-sectional area = 100mm²,…

A:

Q: A 500N force is applied on a rod of length 10 m, cross sectional area 2 mm^2, and Young's modulus 5…

A: Given data,  P= 500 N  L= 10 m=10000 mm  Area =A= 2 mm²  E= 5*10¹⁰ N/m² = 50000 N/mm²

Q: Steel cable Q2/ Find the displacement of point B. E, = 200GPA A, = 400mm? L = 3m B Answer 45 dg =…

A: Given data: - The elastic constant for steel is Es = 200 GPa. The elastic constant for aluminium is…

Q: The bolt in the following figure when tightened, we measure a &13µm decrease in the bolt diameter d.…

A: Given data:-diameter of bolt, d=60mmchange in diameter of bolt, Δd=-13μm=-0.013mmModulus of…

Q: A brass bar having cross-sectional area of 1000 mm2 is subjected to axial forces shown in the Fig.…

A:

Q: The three-bar truss in Fig. a is subjected to a horizontal force of 5 kip. If the cross-sectional…

A:

Q: One end of a steel rod of radius R = 10mm and length L = 90 cm is held in a vise. A force of…

A: When an external force is applied to any body the body gets deformed. This deformation is resisted…

Q: A load weighing P kN as with AB, AC and AD cables such as are carried. Points A and B are x-axis, C…

A:

Q: Find the tension in the cord attached to a block A. Neglect the weight of the floating pulley…

A: given; lets take tansion in cord A=Tweight of block A (wA)=400lbcoefficient of friction (f)=0.20

Q: When a pressure of 20.7 MN/m² is applied to 100 litre of a liquid its volume decreases by 1 litre.…

A:

Q: A steel rod of circular section tapes from 2 cm diameter to 1 cm diameter over a length of 50 cm. If…

A: Find the change in length

Q: DOL V 12 A light elastic cord of length lo = 5.0 m and stiflness k= 50 N/m is inside o fixed box…

A:

Q: B/ A steel robotic arm carries a payload of (444.82 kg) has a dimension of (1.524 m) length, (0.1524…

A: A robotic arm is a very useful part of a robot that can move in multiple ways based on the…

Q: Given the force in spring AD (150N), final length of spring EC (0.8m), spring constant k = 9 N/cm,…

A:

Q: 1. A steel pipe of length 4 ft, outside diameter of 6.0 in., and inside diameter of 4.5 in., is…

A:

Q: A 40 kg-mass hangs from the end of a uniform beam. The beam is 6.0 m long and has a mass of 60 kg.…

A:

Q: A rigid beam is supported by a pin at A and two metallic wires at B and C. Determine the force P…

A:

Q: Figure Q2[a] shows a shaft supported by three smooth journal bearings at A, B, and C. Given: F,-923…

A:

Q: A brass rod (E 110 GPa) with cross sectional area of 250 mm2 is loaded by forces P =15 kN, P2 =10…

A: GIVEN DATA- E=110GPa A=250mm2 P1=15KN P2=10KN P3=8KN WE HAVE TO FIND CHANGE IN LENGTH OF BAR

Q: MECHANICS OF DEFORMABLE BODIES 1. In the figure shown, the rigid bar with negligible mass was…

A:

Q: A block (A) weighing 1 kN rests on a rough inclined plane whose inclina- tion to the horizontal is…

A: Draw the FBD for the given question and write the given values along with suitable variables.

Q: 2. Auniform bar 3.00 m long is held by ropes at the ends making angle 60.0° and 30.0°, respectively,…

A:

Q: Two somewhat heavy people enter an elevator. Based on their weight, the force that they exert on the…

A:

Q: Compound axial member ABC has a uniform diameter of d = 2.9 in. Segment (1) is an aluminum [E₁ =…

A: INTRODUCTION: A composite bar is constructed of two bars of different materials that are firmly…

Q: Given the force in spring AD (150N), final length of spring EC (0.8m), spring constant k = 9 N/cm,…

A: As per give condition,  For solution refer below images.

Q: A mechanism carries a constant load P applied to the seat as E shown. Calculate the forces, in…

A: Forces in mechanisms can be calculated by balancing them in particular directions.  The sum of all…

Q: From the figure shown, Material 1 (brown) is enclosed inside Material 2 (grey). If there would be a…

A: Given:P=357.5 KNd=88.75 mmμ=0.355E=88.56*109 N/m2

Q: A mechanism carries a constant load P applied to the seat as shown. For the angle 8, determine the…

A:

Q: A brass bar having cross-sectional area of 1000 mm2 is subjected to axial forces shown in the Fig.…

A: As the math tool is not working, we are providing handwritten for the given question.

Q: Given the force in spring AD (150N), final length of spring EC (0.8m), spring constant k = 9 N/cm,…

A:

Q: A brass bar having cross-sectional area of 1000 mm2 is subjected to axial forces shown in the Fig.…

A: When an external force is applied to anybody, the body gets deformed. This deformation is resisted…

Q: Q3A/ Composite of concrete rainforced by steel rods of 20%, modulus elasticity of concrete 30 Mpa ,…

A: Given:Vm=0.80Vf=0.20Em=30 MPaEf=210 MPa

Q: 3. A diver of weight W is springing on a rectangular cross-sectional diving board ABC. On a…

A: Given: weight of the diver→W=600 N height of the diver→h=500 mm = 0.5 m youngs modulus→E=12.6…

Q: n elevator weighs 1000 Ibs and is supported by a 5/16 inch diameter cable, 1500 ft long. When the…

A:

Q: Figure Q1(a) shows a fire truck system which consist of a bucket attached at the end of the…

A: For solution refer below images.

Q: Under non-uniform and slippery road conditions, two forces (u and w), shown in the figure (image 1),…

A: For the given truck, forces acting on the rear wheels are shown in the following model diagram.   As…

Q: Q2/ A force P = 1 KN applied to a right bar suspended by three wires, as shown below. all wires are…

A:

Q: 30cm 12 cm 10 ст 329 A – 15 cm 1800 N The rigid link is supported by a pin at A and two A-36 steel…

A:

Q: 1.17. An unknown weight falls by 30 mm onto a collar rigidly attached to the lower end of a vertical…

A:

Q: A string 2 m long is tied to the ends of a uniform rod that weighs 60 N and is 1.6 m long. The…

A: Data given-  W = 60 N  AC = CB = 1 m  AB = 1.6 M

Q: Ropes J, K, and L with their ends attached to each other as shown supports a downward force Q=100N.…

A:

Q: Q7. A 4.20 m long (L) steel pipe has a mass of 450 kg and is lifted by a crane attached to cable CD.…

A:

Q: An axial pull of 35000N is acting on a bar consisting of three lengths as shown in fig above. if…

A: