A 10 g sample of Mg504 · 7H₂0 (246.489/mol) was heated in an oven at 105 °C until evaporated all the waters of hydration was off to generate Mg504 (mhydrous). The sample was then dissolved in 250 mL of distilled and diluted to a final volume of amount of 504 Water 0.5l. The in ppm in the final solution is ? > motor masses in g/mol → Mg5o4 · 71/₂0 = 2006 = > 246.48 H/₂0 = 18.02 لا

A 10 g sample of Mg504 · 7H₂0 (246.489/mol) was heated in an oven at 105 °C until evaporated all the waters of hydration was off to generate Mg504 (mhydrous). The sample was then dissolved in 250 mL of distilled and diluted to a final volume of amount of 504 Water 0.5l. The in ppm in the final solution is ? > motor masses in g/mol → Mg5o4 · 71/₂0 = 2006 = > 246.48 H/₂0 = 18.02 لا

Chemistry: The Molecular Science

5th Edition

ISBN:9781285199047

Author:John W. Moore, Conrad L. Stanitski

Publisher:John W. Moore, Conrad L. Stanitski

Chapter13: The Chemistry Of Solutes And Solutions

Section: Chapter Questions

Problem 25QRT

See similar textbooks

Similar questions

When KNO3 is dissolved in water, the resulting solution is significantly colder than the water was originally. (a) Is the dissolution of KNO3 an endothermic or an exothermic process? (b) What conclusions can you draw about the intermolecular attractions involved in the process? (c) Is the resulting solution an ideal solution?
Hydrochloric acid is sold as a concentrated aqueous solution. If the concentration of commercial HCl is 12.0 M and its density is 1.18 g/cm3, calculate the following: (a) the molality of the solution (b) the weight percent of HCl in the solution
An aqueous solution of acetic acid with a richness of 80% by passage (ρ = 1.07 kg/dm3) is available.a) What is the molarity and molality of this solution?b) What is the percentage of acid in this solution? c) What volume of said solution should we use to prepare 1 liter of 2.14M solution?
If 124.4 mL of water is shaken with oxygen gas at 0.81atm, it will dissolve 0.0036 g O2. Estimate the Henry's law constant for the oxygen gas in water in units of g mL ^-1atm^-1.
Fluorocarbons (compounds that contain both carbonand fluorine) were, until recently, used as refrigerants.The compounds listed in the following table are all gasesat 25 °C, and their solubilities in water at 25 °C and 1atm fluorocarbon pressure are given as mass percentages.(a) For each fluorocarbon, calculate the molality of a saturatedsolution. (b) Which molecular property best predictsthe solubility of these gases in water: molar mass,dipole moment, or ability to hydrogen-bond to water?(c) Infants born with severe respiratory problems are sometimesgiven liquid ventilation: They breathe a liquid thatcan dissolve more oxygen than air can hold. One of theseliquids is a fluorinated compound, CF3(CF2)7Br. The solubilityof oxygen in this liquid is 66 mL O2 per 100 mL liquid.In contrast, air is 21% oxygen by volume. Calculate themoles of O2 present in an infant’s lungs (volume: 15 mL)if the infant takes a full breath of air compared to takinga full “breath” of a saturated solution of O2 in…
The maximum solid solubility of carbon in ferrite occurs at 0.022 wt% C and 727 ° C, the eutectoid composition is 0.76 wt% C, the maximum solid solubility of carbon in austenite occurs at 2.14 wt% C and 1147 ° C, and the cementite composition is 6.7 wt% C. For 2122 g of a 3.2134 wt% C steel at 726 ° C, what will be the mass of carbon present as part of a compound?(a) 67.9 g(b) 74.2 g(c) 58.7 g(d) 83.5 g
(a) Calculate the vapor pressure of water above a solutionprepared by adding 22.5 g of lactose (C12H22O11) to 200.0 gof water at 338 K. (Vapor–pressure data for water are givenin Appendix B.) (b) Calculate the mass of propylene glycol(C3H8O2) that must be added to 0.340 kg of water to reducethe vapor pressure by 2.88 torr at 40 °C.
The solubility of nitrogen in water at 0ºC and 1 atm pressure is 23.54 mL of N2/L.>At what valueWill the pressure of the nitrogen have to be raised to increase its solubility to 100.0 mL of N2/L?
Electrolytes have a greater effect on colligative properties than nonelectrolytes do because electrolytesA. are volatileB. have higher boiling pointsC. produce more moles of solute particles per mole of solventD. produce fewer moles of solute particles per mole of solvent
The density of acetonitrile (CH3CN) is 0.786 g/mL andthe density of methanol (CH3OH) is 0.791 g/mL. A solutionis made by dissolving 22.5 mL of CH3OH in 98.7 mL ofCH3CN. (a) What is the mole fraction of methanol in thesolution? (b) What is the molality of the solution? (c) Assumingthat the volumes are additive, what is the molarityof CH3OH in the solution?
Mass of empty dish: 38.386 grams Volume of 0.0400 M stock solution: 5.00 mL Mass of Dish and 0.0400 M stock solution: 44.751 grams Mass of Dish and CuSO4 (after evaporation): 38.468 grams 1. Calculate the density of the solution a)Calculate the percent by mass, CuSO4, in stock solution (100 x g CuSO4/g solution) b)Calculate the molality of the stock solution (mole CuSO4 / kg solvent) c) Calculate the molarity of the stock solution (moles CuSO4 / L solution)
You are handed a 15.85% by mass aqueous KCl (m.m. = 74.5513 g mol–1) solution (at 25 °C). Assume the density of the solution is that of pure water (dsolution = 1.000 g mL–1). The ebullioscopic constant (Kb) for water is 0.513 °C m–1. The cryoscopic constant (Kf) for water is 1.86 °C m–1. The vapor pressure of pure water is 0.0313 atm. Determine the following: Boiling point of solution (in °C to one decimal place) Freezing point of solution (in °C to two decimal places) Vapor pressure of the solution (in atm to three decimal places) Osmotic pressure (in atm to three decimal places)