A 200-N body is being supported by two different ropes, the first rope, T1 is 600 above the positive x-axis while the second rope is 300 above the negative x-axis. Calculate the tension force in each rope. Show complete solution.

A 200-N body is being supported by two different ropes, the first rope, T1 is 600 above the positive x-axis while the second rope is 300 above the negative x-axis. Calculate the tension force in each rope. Show complete solution.

Glencoe Physics: Principles and Problems, Student Edition

1st Edition

ISBN:9780078807213

Author:Paul W. Zitzewitz

Publisher:Paul W. Zitzewitz

Chapter5: Displacement And Force In Two Dimensions

Section: Chapter Questions

Problem 80A

See similar textbooks

Similar questions

Consider the three connected objects shown in Figure P5.43. Assume first that the inclined plane is frictionless and that the system is in equilibrium. In terms of m, g, and , find (a) the mass M and (b) the tensions T1 and T2. Now assume that the value of M is double the value found in part (a). Find (c) the acceleration of each object and (d) the tensions T1 and T2. Next, assume that the coefficient of static friction between m and 2m and the inclined plane is s and that the system is in equilibrium. Find (e) the maximum value of M and (f) the minimum value of M. (g) Compare the values of T2 when M has its minimum and maximum values. Figure P5.43
(a) What is the minimum force of friction required to hold the system of Figure P4.74 in equilibrium? (b) What coefficient of static friction between the 100.-N block and the table ensures equilibrium? (c) If the coefficient of kinetic friction between the 100.-N block and the table is 0.250, what hanging weight should replace the 50.0-N weight to allow the system to move at a constant speed once it is set in motion? Figure P4.74
(a) Find the tension in each cable supporting the 6.00 102-N cat burglar in Figure P4.35. (b) Suppose the horizontal cable were reattached higher up on the wall. Would the tension in the other cables increase, decrease, or stay the same? Why? Figure P4.35
The person in Figure P5.6 weighs 170 lb. As seen from the front, each light crutch makes an angle of 22.0 with the vertical. Half of the persons weight is supported by the crutches. The other half is supported by the vertical forces of the ground on the persons feet. Assuming that the person is moving with constant velocity and the force exerted by the ground on the crutches acts along the crutches, determine (a) the smallest possible coefficient of friction between crutches and ground and (b) the magnitude of the compression force in each crutch. Figure P5.6
A car is stuck in the mud. A tow truck pulls on the car with the arrangement shown in Fig. P4.32. The tow cable is under a tension of 2 500 N and pulls downward and to the left on the pin at its upper end. The light pin is held in equilibrium by forces exerted by the two bars A and B. Each bar is a strut; that is, each is a bar whose weight is small compared to the forces it exerts and which exerts forces only through hinge pins at its ends. Each strut exerts a force directed parallel to its length. Determine the force of tension or compression in each strut. Proceed as follows. Make a guess as to which way (pushing or pulling) each force acts on the top pin. Draw a free-body diagram of the pin. Use the condition for equilibrium of the pin to translate the free-body diagram into equations. From the equations calculate the forces exerted by struts A and B. If you obtain a positive answer, you correctly guessed the direction of the force. A negative answer means that the direction should be reversed, but the absolute value correctly gives the magnitude of the force. If a strut pulls on a pin, it is in tension. If it pushes, the strut is in compression. Identify whether each strut is in tension or in compression.
(a) Find the tension in each cable supporting the 6.00 102-N cat burglar in Figure P4.35. (b) Suppose the horizontal cable were reattached higher up on the wall. Would the tension in the other cables increase, decrease, or stay the same? Why? Figure P4.35
In Figure P4.35, the man and the platform together weigh 950 N. The pulley can be modeled as frictionless. Determine how hard the man has to pull on the rope to lift himself steadily upward above the ground. (Or is it impossible? If so, explain why.) Figure P4.35
A block of mass 3.00 kg is pushed up against a wall by a force P that makes an angle of = 50.0 with the horizontal as shown in Figure P5.12. The coefficient of static friction between the block and the wall is 0.250. (a) Determine the possible values for the magnitude of P that allow the block to remain stationary. (b) Describe what happens if P has a larger value and what happens if it is smaller. (c) Repeat parts (a) and (b), assuming the force makes an angle of = 13.0 with the horizontal. Figure P5.12
A crate of weight Fg is pushed by a force P on a horizontal floor as shown in Figure P4.83. The coefficient of static friction is s, and P is directed at angle below the horizontal. (a) Show that the minimum value of P that will move the crate is given by P=sFgsec1stan (b) Find the condition on in terms of , for which motion of the crate is impossible for any value of P. Figure P4.83
(a) What is the resultant force exerted by the two cables supporting the traffic light in Figure P4.75? (b) What is the weight of the light? Figure P4.75
The coefficient of static friction between the 3.00-kg crate and the 35.0 incline of Figure P4.31 is 0.300. What minimum force F must be applied to the crate perpendicular to the incline to prevent the crate from sliding down the incline? Figure P4.31
The leg and cast in Figure P4.40 weigh 220 N (w1). Determine the weight w2 and the angle needed so that no force is exerted on the hip joint by the leg plus the cast. Figure P4.40