A 25-lb sphere A is held at the 51° angle shown and released. It strikes the 10-lb sphere B. The coefficient of restitution for this collision is e=0.75. Sphere B is attached to the end of a light rod that pivots freely about point O. If the spring of constant k = 107 lb/ft of the light rod after impact. is initially unstretched, determine the maximum rotation angle 16" 51° ww 30"- Answer: 0 = i ca B 30" O

A 25-lb sphere A is held at the 51° angle shown and released. It strikes the 10-lb sphere B. The coefficient of restitution for this collision is e=0.75. Sphere B is attached to the end of a light rod that pivots freely about point O. If the spring of constant k = 107 lb/ft of the light rod after impact. is initially unstretched, determine the maximum rotation angle 16" 51° ww 30"- Answer: 0 = i ca B 30" O

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

An 80-Mg railroad engine A coasting at 6.5 km/h strikes a 20-Mg flatcar C carrying a 30-Mg load B which can slide along the floor of the car (μk= 0.25). The flatcar was at rest with its brakes released. Instead of A and C coupling as expected, it is observed that A rebounds with a speed of 2 km/h after the impact. Draw impulse-momentum diagrams that can be used to determine (a) the coefficient of restitution and the speed of the flatcar immediately after impact, (b) the time it takes the load to slide to a stop relative to the car.
To pass inspection, steel balls designed for use in ball bearings must clear the fixed bar A at the top of their rebound when dropped from rest through the vertical distance H = 36 in. onto the heavy inclined steel plate. If balls which have a coefficient of restitution of less than 0.7 with the rebound plate are to be rejected, determine the position of the bar by specifying h and s. Neglect any friction during impact.
The 9.0 kg sphere A is held at an angle of 60° as shown, and then is released from rest and hits the B sphere which has a mass of 4.5 kg. In this crash the coefficient of restitution is e = 0.75. The sphere B is attached to the end of a rod lightweight rotating around the O point. The spring is initially non elongated and it is known that the maximum angle θ that the rod turned after the crash measured from the initial position was of 21.4º. Calculate: a) The speed with which sphere A impacts with sphere B. b) The magnitude and direction of the velocities of each sphere A and B after impact. c) The mechanical energy dissipated on impact. d) The spring stiffness constant k.
The two spheres shown collide. the weight of the first sphere (W1) is 40 N while that of the second is (W2) is 30N. assuming that the second sphere's velocity (v2) is 14 m/s and the first sphere's velocity (v1) is 16 m/s along the their respective angles. theta 1(θ1)=30 degrees and theta 2(θ2)=60 degrees. Assume velocities along y will be equal before and after impact. The coefficient of restitution is 0.57. A.) Determine the velocity of the 30N sphere after impact (m/s) B.) Determine the Velocity of the 40N sphere after impact (m/s) C.) Determine the angle of the velocity after impact of the 40N sphere with the horizontal (degrees) D.) Determine the angle of the velocity after impact for the 30N sphere with the vertical (degrees)
The 38-lb collar A is released from rest in the position shown and slides up the 30° inclined bar with negligible friction due to the action of the constant force P = 45 lb applied. on the wire.Assuming that the maximum deformation of the spring is 6 inches, determine b) The required stiffness K of the spring, in lb/ft. The position of the small pulley B is fixed.
Direct central impact occurs between a 100lbs body moving to the right at 5 ft per second and a body of weight W moving to the left at 3 ft per sec. The coefficient of restitution e = 0.5. After impact the 100lb body rebounds to the left at 2ft/s. Determine the weight W of the other body. (lbs)
Two identical frictionless balls have its magnitude and direction of velocities before they strike each other as shown in the figure. If the coefficient of restitution e =90. a) determine the magnitude of the velocity of ball A after the impact b) determine the direction of the velocity of ball A after the impact c) determine the magnitude of the velocity of ball B after the impact.
Compute the final velocities v1' and v2' after collision of the two cylinders which slide on the smooth horizontal shaft. The velocities are positive if to the right, negative if to the left. The coefficient of restitution is e = 0.83.Assime v1 = 27 ft/sec, v2= 4 ft/sec, W1 = 6 lb, W2 = 16 lb.
The 4-kg masses A and B slide on the smooth horizontal bar with the velocities shown. Determine their velocities after they collide if their coefficient of restitution is e = 0.8
4. The 12-kg package A has a speed of 2.5 m/s when it enters the smooth ramp. As it slides down the ramp, it strikes the 34-kg package B which is initially at rest. If the coefficient of restitution between A and Bis = 0.65, determine the velocity of B just after the impact.
Block A is released from rest and slides down the frictionless surface of B until it hits a bumper on the right end of B. block has a mass of 10 kg and object B has a mass of 30 kg and B can roll freely on the ground. Determine the velocities of A and B immediately after impact when (a) e= 0, (b) e= 0.7.
Instead of a traditional cue, Rodrigow used a spring-powered cue in his game of billiards. When the constraints on the spring (k = 100 kN/m) are removed, the launching mechanism of the cue is triggered, and the 170-g cue ball A is launched forward. Ball A is separated from the plate when the spring becomes fully unstretched. Ball A is launched at an angle a with the horizontal, making it rebound off the cushion at an angle ß. When the cue ball A hits the initially stationary 9-ball B (ma= 160 g), the latter goes snuggly into the lower left pocket. Determine the amount of compression (mm) on the spring so that the speed of ball B is exactly 5.XYZ m/s, where XYZ is the last three digits of your student number (Ball B may bounce off the table if its velocity is> 5.XYZ m/s and may not reach the pocket if < 5.XYZ m/s). The coefficient of restitution between ball A and the cushion is 0.6 while between balls A and B is 0.95. Neglect the effect of friction and the size of the balls.