A 2m tall by 10m wide partition wall made of fibreboard (untreated, 12.5mm) separates two rooms, one at 40% rh and 20 oC and the other at 80% rh and 20 oC. Calculate the vapour pressure on either side of the wall as well as the vapour pressure gradient across the wal

A 2m tall by 10m wide partition wall made of fibreboard (untreated, 12.5mm) separates two rooms, one at 40% rh and 20 oC and the other at 80% rh and 20 oC. Calculate the vapour pressure on either side of the wall as well as the vapour pressure gradient across the wal

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter5: Analysis Of Convection Heat Transfer

Section: Chapter Questions

Problem 5.46P

See similar textbooks

Related questions

Q: Air at 20°C and 1 atm flows through a cylindrical tube made of naphthalene at a velocity of 5 m/s.…

A: Given data as per question v=5 msd=0.1 mTair=200cμair=1.8×10−5 kgmsρair=1.2 kgm3v=1.5×10−5 m2sυ=4.24…

Q: Consider 100 m3 of a mixture of dry air and water vapor at 0.1 MPa, 35 C, and 70% R.H. Calculate the…

Q: Question 8 A sheet of steel 3 mm thick is exposed on one side to a nitrogen-rich atmosphere at…

Q: Estimate the boiling heat transfer coefficient between the water and the wire surface. Properties of…

Q: A sheet of steel with 3.5-mm thickness has a nitrogen atmospheres on both sides at 900°C and is…

A: This problem can be solved by using the following formula:

Q: 13. A mixture of water and steam is flowing up a 25 mm diameter channel at a rate of 4500 kg/s m²…

A: Answer: Two-phase or multi-phase flow appears to be an unusual issue employed only in scientific…

Q: Find all properties of warm air outside a building at 32C and 60%RH. Show your work on Psychrometric…

Q: The gas constant R has the value 287 J/Kg * K for dry air. Using the ideal gas law (P = PdryRT):…

Q: An old single storey, 500 m home with an air exchange rate of 0.6 ach, uses a gas oven for cooking.…

A: Air changes each hour (ACH) is a significant measurement to guarantee a room has great air quality…

Q: A mixture of water (density=1000 kg/m3) and vapor flowing with a mass rate = 7 kg/sec in a pipe of…

Q: Steam at a pressure of 3 MN/m, at a temperature of 250°C and flowing at a rate of 3 kg/s is…

A: givensteam 1 pressure P1=3MN/m2temperature T1=250oC=523Kflowing at rate m˙1=3kg/sthrottled to a…

Q: Water at atmospheric pressure enters a 1.2 [cm] ID, 2.4 [m] long electrically heated vertical pipe…

Q: The air at 25 degree C and 100 kpa in a 150 m3 room has a relative humidity of 60%. calculate the…

A: The Answer is below

Q: Calculate the evaporation rate from an open water source, if the net radiation is 300 W/m² and the…

A: Write the given data with suitable variables: E=300 W/m2ρ=996 kg/m3T=30°C

Q: Saturated steam at 100 °C in condensing over 1-cm diameter vertical metal rod which maintained at 93…

A: Given data:

Q: Air at 25°C and atmospheric pressure flows with a velocity of 3 m/s inside a 10mm diameter tube of 1…

Q: Q6/ It is required to enhance the wear resistance of steel part by Nitriding process. To perform…

Q: Use the definition of the Sherwood number to calculate the mass transfer coefficient (in cm/s) for a…

Q: Bouling water at 1 atm may require a surface heat flux of 3 x 10° Btu/h · ft for a. surface…

A: Solution :- Given data :- For boiling water at 1 atm the temperature is 100Cο =3×104btu/h.ft2T…

Q: taken place) 1. One and a half moles of air (80% nitrogen and 20% oxygen by volume) at 298.15 K is…

A: Hello dear, As you have posted multiple question at a time and according to our Policy Iam able to…

Q: A sealed rigid vessel contains of 1.8 m' of saturated water vapor at 135 °C. The vessel is now…

Q: Rework Problem 3-25, using Chart la, with the mixture condition computed on the basis of the mass…

Q: Steam is used to heat a cylindrical open tank of water until it boils, after which a proportion of…

A: (a) Heating medium is saturated steam at 5 bar Temp. of the heating coil is the saturation…

Q: Write the generalized relation (write only final equations and explain each term) for Internal…

Q: Calculate and compare the mol fraction of water vapor (in PPM) for two cases: 90% relative humidity…

Q: Water is to be boiled at atmospheric pressure in a polished copper pan by means of an electric…

A: As per the calculation the nearest option is b. So option b is correct.

Q: 2. Humid air at 35o C and a pressure of 1 atm and with 98% relative humidity enters a condenser in…

A: Given: Properties of humid air T1=35oCP=1 atmRelative Humidity φ=98%Tcond=15oC=288…

Q: consider a room filled with air at 15 degrees centigrade and relative humidity 75 percent,calculate…

A: relative humidity of moist air (ϕ) = 0.75 temp. of room (T) = 15oC use the steam table, saturation…

Q: The inner surface of a pipe with an inside diameter of 0.015 m is wet (concentration: 0.010 kmol /…

Q: 6. Saturated steam at 1 atm is condensing on a horizontal tube at a rate of 300 kg/h. The tube is 2…

A: Given: The steam pressure, P = 1 atm The rate of steam condensation, m = 300 kg/h The length of…

Q: Determine the evaporation rate when a container contains hot water and the surface temperature of…

Q: You are required to purchase a 3,000 L tank of liquid butane to heat a maintenance building during…

A: Given data as per the question Molecular weight of vutane =58gm/molspecific gravity=0.6,…

Q: ind the diffusitivity of air in methane and the molecular diffusion of methane, if the tank filled…

Q: Dry saturated steam is expanded in a steam nozzle from 1 MPa to 0.01 MPa. Calculate dryness fraction…

A: Given Data : Pressure P1 = 1 MPa Pressure P2 = 0.01 MPa Now, From the standard Steam Table the…

Q: From an open water surface with air temperature 22°C, relative humidity is 40% and wind speed is 3…

A: here the given relative humidity in percent (RH) =40%and temperature in kelvin(K)=273+20=293KFirst…

Q: Calculate the amount of heat required (in kJ) to raise the temperature of 23.4 g of ice at -11°C to…

A: given data m = 23.4 g = 0.0234 kg ΔHvap = 40.67 kJ/mol ΔHfus = 6.008 kJ/mol Cice = 2.092 J/g°C,…

Q: Moist air contains 0.025 kg water vapour per cubic metre of themixture at 313 K and 101.3 kPa.…

A: GivenV=1m3mw=0.025 kgT=313KP=101.3 kPa

Q: In general, the disposal of hot streams to the environment is not a good a practice due to the risk…

Q: What is entropy? Write entropy equation. What happens to the entropy in ideal isobaric heating…

Q: A 2 m wide, 3 m high, and 50 mm thick sheet of XPS insulation (M = 50 ng/Pa.s.m2), has a vapor…

Q: Consider a sealed can that is filled with 4.4 kg of water at 115 °C and P = 248 kPa. Now a leak…

A: Given: The mass of water, m = 4.4 kg The temperature of the water, T = 115 C The pressure of water,…

Q: In a falling-film evaporator, Air at 40℃ and 50 kPa flows through a wetted-wall column with 100 mm…

A: Given data : Findu = 10 mm a) mass transfer coefficientv = 5…

Q: Q: Salt in crude oil must be removed before the oil undergoes processing in a refinery. The crude…

Q: A nuclear reactor contains a steam with 16 kg of vapour and 94 kg of liquid. Estimate the quality of…

A: Quality of a steam or dryness fraction of a steam is defined as the percentage of vapor content…

Q: Calculate the latent heat of vaporization(J/kg) from an open water surface with air temperature…

Question

Read the question carefully and give me right solution according to the question.

A 2m tall by 10m wide partition wall made of fibreboard (untreated, 12.5mm) separates two rooms, one at 40% rh and 20 ^oC and the other at 80% rh and 20 ^oC. Calculate the vapour pressure on either side of the wall as well as the vapour pressure gradient across the wall.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Introduction

VIEW

Step 2: Calculation part

VIEW

Step 3: Conclusion

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Similar questions

8.2 From its definition and from the property values in Appendix 2, Table 13, calculate the coefficient of thermal expansion, , for saturated water at 403 K. Then compare your results with the value in the table.
Calculate the value of dryness fraction? in vessel which is volume of 5 m^3 contains (4.95 m^3) of saturated vapor and (0.05 m^3) of saturated liquid water at pressure * (100 kpa)
On a hot humid summer day, the air can be considered saturated steam at 950C. If you were to take an ice-cold beverage (40C) from the cooler, you would notice drop-wise condensation on the side of the can forming. What is the condensation heat transfer coefficient for the cold can? Assume the can is 12-cm tall and has a diameter of 8-cm.
A 300 ml sample of dry oxygen at STP ( standard temperature and pressure ) is transferred to a container over water at 19 deg C and 750 mmHg. What is the new volume of the oxygen?
2. Humid air at 35o C and a pressure of 1 atm and with 98% relative humidity enters a condenser in which the temperature is lowered isobarically (pressure is constant) to 15o C. Part of the water condenses and coexists with the remaining air. The remaining air leaves the condenser flowing through a 20-cm diameter duct at a velocity of 10 m/s. Calculate the rate (moles water/s) at which water condenses.
A poultry house in Mogobane, is made of 100mm fired clay bricks. In winter, the inside air temperature is 24°C and the relative humidity is 75%. The outside temperature is at 1°C and the relative humidity is 25%. Determine whether condensation will occur within this wall. If there is condensation, suggest mitigating measures and show that indeed the measures will work.
From an open water surface with air temperature 22°C, relative humidity is 40% and wind speed is 3 m/s, all measured at height 2 m above the water surface. Assume a roughness height of 0.03 cm. The net radiation is 200 W/m^2. Cp = 1005 J/kg-K A. Calculate the latent heat of vaporization (J/kg) B. Calculate the evaporation using Energy Balance Method (mm/day) C. Calculate the saturation deficit of the vapor pressure (Pa) D. Calculate the evaporation using Priestley-Taylor Method (mm/day)
A 2 m wide, 3 m high, and 50 mm thick sheet of XPS insulation (M = 50 ng/Pa.s.m2), has a vapor pressure of 1500 Pa on one side, and 3500 Pa on the other. Calculate the vapor flow rate (Qv), vapor flux (qv), permeability, Rv value and the permeability (μ)
How do you calculate the partial pressure of water vapour in the mixture of gasesconstituting flue gas? What is the importance of calculating the partial pressure of watervapour in flue gas downstream of economizer?
Calculate the water vapor pressure of the atmosphere if the dry-bulbtemperature is 22°C and the wet bulb temperature is 10°C at standardatmospheric pressure , Calculate also the relative humidity, the degree or percentof saturation , humidity ratio , and the enthalpy of the mixture. solve with complete diagram
A cold room for storage is kept at atemperature of 10[°C] and a relative humidity of 80%. The air flow overthe evaporator is 30,000 [m³/h] and the air temperature measured at the outlet of theevaporator is 5[°C]. Under these conditions, the installation develops a cooling power of 100 [kW].Calculate the amount of condensate water that forms in the evaporator inone hour.
Water is boiled at atmospheric pressure in a square (0.2 m x 0.2 m) pan placed on top of a heating unit. Pan is made of polished copper and the surface tension of liquid-vapor interaction is 0.06 N/m. The coefficient Ccr is 0.15. What should be the maximum bottom surface temperature of the pan for safe operation? Properties of water: ρl=960 kg/m3 ρv=0.6 kg/m3 μl=0.3x10-3 kg/ms cpl=4200 J/kgK Prl=2 hfg=2257x103 J/kg