Find all properties of warm air outside a building at 32C and 60%RH. Show your work on Psychrometric chart. Will condensation on the outside of building windows occurs if the surface temperature of the glass is at 22C? why?

Find all properties of warm air outside a building at 32C and 60%RH. Show your work on Psychrometric chart. Will condensation on the outside of building windows occurs if the surface temperature of the glass is at 22C? why?

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter9: Heat Transfer With Phase Change

Section: Chapter Questions

Problem 9.28P

See similar textbooks

Related questions

Q: water source in the municipality is from an open reservoir and will supply to a pressure tank that…

A: Since the question asked by you contains more than three sub-parts, so according to our guidelines,…

Q: A 10 ft by 15 ft rectangular cistern (storage tank for rainwater) has its top 30 ft below ground…

A: Calculus is frequently used to determine the amount of labour required to empty a tank of the…

Q: A system has a volume flow rate requirement of 21it/s with an index run AP of 60k Pa. Find an…

A: Given: Volume flow rate requirement→Q=2 lit/sec Index run ∆P=60KPa So from the catalogue we have to…

Q: The cylindrical steel column has an outer diameter of 4 in. and inner diameter of 3.5 in. The column…

Q: Q 2(b) Consider the non-uniform beam shown in Figure 3. It's horizontal when in equilibrium. Its…

A: For solution of part b). Refer below images.

Q: Three idlers of 28 T , 26 T and 26 T are introduced between the 34 T pinion withaturning speed of…

A: Consider below figure for nomenclature and position of idlers, pinion and driven gear. Given, Teeth…

Q: The 7-kg smooth cylinder is supported by the spring having a stiffness of kab = 120 N/m. Determine…

Q: A tidal power plant of single basin type, has a basin area of 25 x 10 to power 6 m2. The tide has a…

A: Given dataBasin area = 25 x 106 m2Tide maximum height = 10 mTurbine stops operation below a head of…

Q: Brief explanation of Equilibrium of a Rigid Body and an example

A: A rigid body is assumed to not undergo any deformation upon the application of load or pressure.…

Q: 12 A line shaft ABCD, 9 metres long, has four pulleys A, B, C and D at equal distance apart. Power…

A: Given Data:N=630 rpmζmax=55 MpaG=85 GpaTo Find :1dAB2dBC3dCD4θD/A

Q: . Determine the resultant moment about point A of the system of forces shown in Figure 1- 30. Each…

Q: Consider the manometer exposed in the environment with a local pressure of 228.257 torrs, and the…

A: Given data Local gauge pressure = 228.257 torrs = 30431.77 PaAbsolute pressure = Local Gauge…

Q: A steel rod is subjected to a stress of 200 MPa and has Young's modulus of 200 GPa. Calculate…

Q: Consider the manometer exposed in the environment with a local pressure of 328.227 torrsg and the…

A: Answer: Fluid - R Fluid - L (a) Density 5983.46 kg/m3 4230.94 kg/m3 (b) Specific Gravity…

Q: The number of links is L = The number of full joints is j1 = The number of Half joints is J2 = 1 The…

Q: A material is deformed under a pure shear stress as shown in the following figure. Calculate the…

Q: QUESTION 3 If constriction occurs more at the entrance than the outlet, the culvert is said to be…

A: Answer: The correct answer is option (b) i.e. inlet control.

Q: 6-7. Water flows through the hose with a velocity of 4 m/s. Determine the force that the water…

Q: 8-A diesel engine has a clearance volume is 0.00025m³ and bore and stroke of 152.5mm and 200mm,…

A: Given that, Clearance volume, Vc=V2=0.00025 m3Bore, D=152.5 mm,Stroke, L=200 mm,Pressure of air,…

Q: Problem#3: You need to design a metallic glass for use in industry. The glass transition temperature…

A: (1) VFT equation, t=toexpCT-ToWhen to=tref=250 °C,t=6 years=6×365×24=52560 yearTuse=230 °C,Assuming…

Q: In terms of conceptual framework, why does the standards reign over it? why is it more superior or…

A: Given Conceptual framework To find Reason for conceptual framework doesn't follow standards Reason…

Q: Air enters a multistage compressor of a jet engine at 0.65 atm and 275 K with a flow rate of 63.5…

Q: Q6/ Water at 15°C is to be heated to 65°C by passing it over a bundle of 4-m-long 1-cm-diameter…

A: Given Data The intial temperature of water is:Ti=15°C The heated temperature is:To=65°C The length…

Q: 6–27. Air flows through the closed duct with a uniform velocity of 0.3 m/s. Determine the horizontal…

Q: gf What is the tenacity in of den that ruptures under a load of S Provide your answer with tv

A: Given Data : Linear density of fiberρ=3.2 tex Load(F)=94.8 gf

Q: hat is the true answer

A: Link 2, a=29mmLink3, b=182mmOffset, c=67mm To-Find:- 1 dmax=?2 dmin=?

Q: Q5/Air is to be heated by passing it over a bank of 3-m-long tubes inside which steam is condensing…

Q: 9-In an ideal dual combustion cycle conditions at the commencement of the adiabatic compression are…

A: The efficiency of the given Dual cycle can be calculated using the formula given below as-…

Q: eering student, where do you utilize flight simulator

A: we have to discuss the utility of a flight simulator for a aerospace engineering course

Q: 3. During a reversible process there are abstracted 320KJ/s of heat from 1.23kg/s of a certain gas,…

Q: The disk mounted on the axis "A" is in equilibrium under the action of a moment, M, and a braking…

A: Moment applied on the disc=M Radius of the disk=R Hence force required to brake: →F=MR…

Q: If a temperature of 28 degree Celsius and barometric reading of 680 mm Hg determine the correction…

Q: H.W: find the tangent plane and normal line of the surface f(x, y, z) = x + 2xy- y? + z2 = 7 at the…

Q: for COVID vaccine. The volume of the storage container will be 1 m³. You are debating on three…

A: Given: Velocity of the air flow→V=0.8 ms Because kinematic viscosity of air→ν=1.50×10-5 m2s And…

Q: Find the magnitude and point of application of the resultant force acting on the inclined…

A: given; diameter(d)=2mdensity of water(ρ)=1000kg/m3height(h1)=2.5mangle(θ)=600

Q: The resultant of the concurrent forces in Figure 1-33 is 200 N up to the left at 0, 60°. Compute the…

A: Consider below Free Body Diagram , drawn from the data given in question: From the given data,…

Q: 7- At the commencement of the compression stroke, the cylinder of an oil engine is charged with air…

A: In engine combustion system, The inlet valves open and fresh charge of fuel and air mixture is comes…

Q: AP W h mg ΔΡ + Az +

A: The above given equation is Bernoulli's equation. Every term of Bernoulli's equation has units of…

Q: In the Figure below, a cantilever beam is subjected to an inclined force (P); calculate the: 1-…

Q: The bicyclist encounters a incline in the road. (Eigure 3) To maintain a constant velocity, the…

Q: The acceleration due to gravity is given as g = 32.125 ft/s2 and that its variation is 0.0049 ft/s2…

A: Gravitational acceleration is the acceleration acquired by an object as a result of the…

Q: Fill in the blanks: A refrigeration system operates on an ideal vapor compression using R-134a with…

Q: what is the COP of this refrigeration system.

A: Condenser temperature, Tc=40oCEvaporator 1 and 2 temperature, Te,1,2=-10oCEvaporator 3 temperature,…

Q: You need to design a metallic glass for use in industry. The glass transition temperature of the…

A: Given that, Temperature of metallic glass, T=250 °C,Time for permanent tensile stress, tuse=6…

Q: 6. E 5 3

A: From the given figure, Number of links (given in the figure) = 6 (Note that ground is link 1). To…

Q: Determine the phase and required properties in the following. Indicate the steam table number and…

A: It is required to determine the properties of steam at: (a) P=1 MPa, x=30% (b) T= 200C, y=0%

Q: A shaft running at 400 r.p.m. transmits 10 kW. Assuming allowable shear stress in shaft as 40 MPa,…

A: GivenN=400rpmP=10kWσa=40MPa

Q: The two forces and a couple acting on the beam are equivalent to a single force acting at C.…

Q: Q- 6- Resolve the force 250N into rectangular components 250 N 16 9. 12

A: Here, Magnitude of the force = 250 N For the given triangle, missing angle θ can be found by,…

Q: In the following unit cell, which vector represents the [001 direction? A -y B Select one: О а. В O…

Question

2. Find all properties of warm air outside a building at 32C and 60%RH. Show your work on Psychrometric
chart. Will condensation on the outside of building windows occurs if the surface temperature of the glass is
at 22C? why?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

What is the enthalpy of steam at 155 deg C? Find the specific enthalpy of superheated steam at 2 atm and 900°C.
Find the enthalpy change for vaporizing 1 kg of water at 125°C and 232.1 kpa. What is the latent heat of vaporization of water at this condition. (Gpt/Ai wrong ans not allowed)
What is entropy? Write entropy equation. What happens to the entropy in ideal isobaric heatingprocess? Show this process on Pv and Ts diagram.
Why do you think HYGROCOPIC materials (such as glycerin, ethanol, methanol ) are used in dehumidification process NOT the mechanical means of dehumidification? Name some industrial/domestic applications of dehumidification using chemical hygrocopic material.
A coal water slurry contains 73% dry powdered bituminous coal and 27%water. If the coal has a dry higher heating value of 13,000 Btu/lb. andcontains 5 %( wt.) Hydrogen, find the higher and lower heating value of theslurry. Neglect any ash in the coal.
A rigid tank contains water vapor at 300 C and an unknown pressure. When pain the tank is cooled to 130 C, the vapor start condensing. Estimate the initial pressure in the tank.
Calculate the amount of heat required (in kJ) to raise the temperature of 23.4 g of ice at -11°C to steam at 135°C. ΔHvap = 40.67 kJ/mol, ΔHfus = 6.008 kJ/mol, Cice = 2.092 J/g°C, Cwater = 4.184 J/g°C, Csteam = 1.841 J/g°C, Melting point = 0.00°C, Boiling Point = 100.0°C
Draw a VLLE diagram when the temperature is constant.
On a hot humid summer day, the air can be considered saturated steam at 950C. If you were to take an ice-cold beverage (40C) from the cooler, you would notice drop-wise condensation on the side of the can forming. What is the condensation heat transfer coefficient for the cold can? Assume the can is 12-cm tall and has a diameter of 8-cm.
A poultry house in Mogobane, is made of 100mm fired clay bricks. In winter, the inside air temperature is 24°C and the relative humidity is 75%. The outside temperature is at 1°C and the relative humidity is 25%. Determine whether condensation will occur within this wall. If there is condensation, suggest mitigating measures and show that indeed the measures will work.
Plot the process on pv diagram which show the state points relative to the vapor dome. Label the states 1,2,3.. to indicate the sequence of the change in state.
Calculate the specific heat and the specific heat ratio γ = cp/cv for nitrogen N2 at 30, 70, 300, and 1500 K. Assume the pressure is sufficiently low for it to be an ideal gas.