Answered: A 3 phase half wave controlled…

A 3 phase half wave controlled rectifier has a 3 phase line to line supply voltage of 410 V rms at 50 Hz for 11 ohm and 4 H load. If the firing angle a = 30, then the average output voltage is V.

Electric Motor Control

10th Edition

ISBN:9781133702818

Author:Herman

Publisher:Herman

Chapter59: Motor Startup And Troubleshooting Basics

Section: Chapter Questions

Problem 12SQ: How is a solid-state diode tested? Explain.

See similar textbooks

Related questions

Q: A three-phase, half-wave uncontrolled rectifier is fed from an ideal three-phase voltage source of…

A: " Since you have posted a question with multiple subparts, we will solve the first three subparts…

Q: A center tapped rectifier is supplied using 220 V,60 Hz supply, then using ideal mode, the peak…

A: Third option is correct. The explanation is provided below.

Q: Q1. For the single-phase half-wave controlled rectifier with a firing angle of (a = 60°) and with…

Q: Q1) If V1 (RMS) = 110 V (60 HZ) and transformer conversion ratio is 10: 1 according to the half-wave…

A: Fig: Given circuit Calculate voltage at secondary terminal of transformer…

Q: 2. The four diodes used in a bridge rectifier circuit have forward resistances which may be…

A: Given Data: Forward resistance rf = 1 ohm supply votlage = 240 RL = 480 ohm

Q: 3) For the Half-Wave Rectifier circuit shown below, determine: the Transformer Turns ratio, n [ IEEE…

Q: Q1):- A single-phase diode bridge rectifier is supplied at 120V. Determine the mean and r.m.s load…

Q: The single-phase half wave rectifier has R-L load with R= 5N nd L= 6.5mH. The input voltage V,=220V…

A: Given R-L load with R=5ohms and L=6.5mH. The input voltage Vs = 220 V at 50 Hz

Q: A half wave rectifier feeds a load of 10ohms in series with inductance of 20mH. The input supply…

A: Given A half wave rectifier circuit along with its parameters.we need to determine the average dc…

Q: When the rms output voltage of a full-wave bridge rectifier is 31.8 V, the peak inverse voltage…

Q: Example 33: A thyristor used in a half wave rectifier used 220V , with firing angle 60° , total…

A: *Keeping a note ?as per our company guidelines we are supposed to answer ?️only first 3️⃣ sub-parts.…

Q: Q.2) A three-phase half-wave diode rectifier is fed from an ideal three-phase supply of value 380 V…

A: We find the average output current from the given average diode current to find load resistance and…

Q: Calculate the average voltage, RMS load voltage, and efficiency of the rectifier netv Sketch the V.…

Q: Design a bridge rectifier circuit to provide an output of 100 VDC. Calculate the diodes PIV rating…

A: In this question, Output average voltage is 100V DC, and input power is 120V Design a bridge…

Q: A thyristor used in a half wave rectifier used 220V , with firing angle 60°, total resistance load…

A: We are authorized to answer three subparts at a time since you have not mentioned which part you are…

Q: Complete design an electronic circuit to produce bridge full wave rectifier with decrement…

A: Given Vin = 50 sin(wt) We have to design an best electronic circuit to produce bridge full wave…

Q: half-wave rectifier is used with 117-V rms ac (house mains), the average dc output voltage is about

A: In this question , a half wave rectifier is given with input RMS voltage given....We have to find…

Q: A single-phase half wave controlled rectifier, operating at 120 V rms and 60 Hz ac supply, has a…

A: Given a single phase half wave controlled rectifier has, Operating voltage, Vrms=120 V Peak voltage,…

Q: connect the circuit of single phase half- wave controlled rectifier with Ac supply Vs=220 sinwt,…

A: Given: Vs=220 sinωt f=50Hz R=15 ohm L=20MH β=3.37 α=66.4

Q: Q3. For the single-phase half-wave controlled rectifier with R-L load circuit shown below sketch io,…

A: Given: For a single-phase half-wave controlled rectifier, input RMS voltage Vs=240 V, input source…

Q: Discussion: 1) Piscuss clearly the operation for three phase half wave rectifier circuit

A: As per Bartleby guidelines we are allowed to solve only one question, please ask the rest again.

Q: Example 33: A thyristor used in a half wave rectifier used 220V, with firing angle 60° , total…

Q: Consider a full wave bridge rectifier, whose transformer secondary voltage is 130sinwt. If the…

A: As per the guidelines, we need to solve only first three sub-parts of question. we need to find out…

Q: A 3 phase half wave controlled rectifier has a 3 phase line to line supply voltage of 420 V rms at…

A: Given, Vrmsline=420 Vα=70∘ Vrmsphase=Vrmsline2=4202V

Q: In a full wave bridge rectifier, the transformer secondary voltage of 15sin330t is connected to a…

A: Hello. Since you have posted multiple questions and not specified which question needs to be solved,…

Q: 1. Half Wave Rectifier a. Sketch the output V, taken 2kQ load resistor and determine the dc level of…

Q: A thyristor used in a half wave rectifier used 50 KV, with firing angle 30° , total resistance load…

Q: Simulate the behavior of the half-wave rectiﬁer as shown for vI = 10sin 120πt, R = 0.025 Ω and C =…

A: Simulate the circuit, and draw the input and output voltage waveform together for the given values…

Q: Q1 ) If a resistive load is supplied from a single phase half wave rectifier, if a supply voltage is…

A: Single phase half wave rectifier , Draw the circuit and input and output waveform for firing angle…

Q: In a single-phase semi-controlled rectifier, if the firing angle is 45 degrees and the input voltage…

A: Single phase semi controlled rectifier is basically a circuit consisting of thyristors and diodes.…

Q: Q1) A full-wave rectifier uses two diodes. The transformer r.m.s. secondary voltage from the center…

A: In this question, Full wave rectifier uses two diodes. The rms value of secondary voltage from the…

Q: A 3 phase fully controlled rectifier has a 3 phase line to line supply voltage of 410 V rms at 50 Hz…

Q: Explain the role of the voltage regulator in the following system and explain in detail how Zener…

A: Semiconductor are the material made of pure Si or Ge or compound . They have conductivity in between…

Q: A transformer with 440/340 line voltage ratio is used in a three phase half wave rectifier. The load…

Q: A 3 phase half wave controlled rectifier has a 3 phase line to line supply voltage of 420 V rms at…

A: In this question we need to find a average output voltage

Q: Draw the one phase 6 Layer Full Wave Rectifier circuit? Lesson:High Voltage Technique

Q: A 3 phase fully controlled rectifier has a 3 phase line to line supply voltage of 420 V rms at 50 Hz…

A: The solution can be achieved as follows.

Q: Example 33: A thyristor used in a half wave rectifier used 220V, with firing angle 60°, total…

Q: A 3 phase half wave controlled rectifier has a 3 phase line to line supply voltage of 416 V rms at…

A: Given data: Line voltage , VL=416 VLoad resistance, RL=13 OhmLoad inductance, LL=2…

Q: A 3 phase fully controlled rectifier has a 3 phase line to line supply voltage of 420 V rms at 50 Hz…

Q: A 3 phase half wave controlled rectifier has a 3 phase line to line supply voltage of 420 V rms at…

Q: A 3 phase fully controlled rectifier has a 3 phase line to line supply voltage of 420 V rms at 50 Hz…

Q: For a full wave controlled rectifier with pure resistive load (R=1002),the supply voltage is…

A: Given: A full wave controlled rectifier with, Pure resistive load, R=10 Ω Supply voltage, Vs=50 sin…

Q: For the half wave rectifier shown, determine input power factor & ripple factor for a firing angle a…

A: Solution: For α=90°Input pf=π-α+sin2α2π=π-π2+0π=12 lagging Average value of output voltage for…

Q: A 3 phase half wave controlled rectifier has a 3 phase line to line supply voltage of 420 V rms at…

A: A 3- phase fully controlled rectifier has a 3 phase line to line supply voltage of 420 v rms at 50…

Q: A3 phase fully controlled rectifier has a 3 phase line to line supply voltage of 420 V ms at 50 Hz…

A: In case of converter mode DC output voltage =3× Line to Line Peak voltage in supply wave formπ cos…

Q: A full wave bridge rectifier is supplied from 230V, 50Hz and uses a transformer of turns ration…

A: The solution is given below

Q: Consider a full wave bridge rectifier, whose transformer secondary voltage is 130sinwt. If the…

Q: A 3 phase half wave controlled rectifier has a 3 phase line to line supply voltage of 410 V rms at…

A: A 3 phase half wave controlled rectifier has a 3 phase line to line supply voltage of 410 V rms at…

Q: please answer (vii) that is the graph

Question

Quiq

A 3 phase half wave controlled rectifier has a 3 phase line to line supply voltage of 410 V rms at 50 Hz for 11 ohm and 4 H load. If
the firing angle a = 30, then the average output voltage is
V.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

How is a solid-state diode tested? Explain.
What is CEMF?
What is the difference between a diode and rectifier?
A 3 phase half wave controlled rectifier has a 3 phase line to line supply voltage of 420 V rms at 50 Hz for 10 ohm and 4 H load. If the firing angle = 50, then the average output voltage is ______________________. Answer
A 3 phase fully controlled rectifier has a 3 phase line to line supply voltage of 410 V rms at 50 Hz for 10 ohm and 1.5 H load. If the firing angle = 50, then the average output voltage is ______________________. Answer
A 3 phase fully controlled rectifier has a 3 phase line to line supply voltage of 410 V rms at 50 Hz for 11 ohm and 4 H load. If the average output voltage is 250 V then __________________ is the firing angle for this condition.
Design rectifier circuits to provide an output of 100 VDC using:a) Half wave rectifierb) Center-tapped Full wave rectifier For each circuit, calculate the diode PIV ratings and the transformer turns ratio (secondary to primary), if power is taken from the 220 V line AC supply.
Single phase half wave controlled rectifier supplied from 150 V if the load is 10 ohm if the delay angle a =30 Find : 1- maximum load current 2-average load voltage 3- average load current 4-RMS load current 5-power supply to the load 6-conduction angle 7-power factor
Design rectifier circuits to provide an output of 100 VDC using:a) Half wave rectifierb) Center-tapped Full wave rectifier For each circuit, calculate the diode PIV ratings and the transformer turns ratio (secondary to primary), if power is taken from the 220 V line AC supply.Use Silicon diodes.
A 3 phase half wave controlled rectifier has a 3 phase line to line supply voltage of 416 V rms at 50 Hz for 13 ohm and 2 H load. If the average output voltage is 210 V then __________________ is the firing angle for this condition. Answer
Single phase Full wave controlled rectifier with inductive load connected tо 120 V source. The R load equal 10 ohm, the inductive is very large. If the delay angle equal 30 degree Calculate 1- average load voltage 2-average load current 3-maximum load current 4-RMS load current 5-power supplied to the load 6-Form factor 7-ripple factor 8-draw the voltage source, V load, I load, current in each diode
Design a bridge rectifier circuit to provide an output of 100 VDC. Calculate the diodes PIV rating and the transformer’s turns ratio, if power is taken from the 120 V line AC supply