A 400V, 3-phase, wye-connected wound rotor synchronous motor operates at unity pf while developing power of 60kW. If the synchronous reactance is 1Ω per phase and the armature resistance is negligible, calculate the induced voltage per phase.

Q: (d) Sketch the spectrum of the sampled signal xs(t) when: = 1.5 Nyquist rate = 0.25 Nyquist rate а.…

A: Given the signal as shown below: x(t)=sinc2tπ d) We need to sketch the spectrum of the sampled…

Q: (a) Give a component block-diagram for a practical temperature feedback system. (b) Explain how the…

A: Feedback Control: The variable being controlled is measured and compared to a target value in…

Q: 2 M2 1 MQ 50 k2 1 µF. Error 50 k2 e(t) 400 k2 100 k2 Output m(t)

A: An operational amplifier can be used as summer, differentiator, integrator using passive components…

Q: Benefits of 3 phase system over 1 phase system

A: Benefits of 3 phase system over 1 phase system

Q: Q/ For the below system, if you know that the input is r(t) = A sin(wt) , explain and draw the…

A:

Q: Draw a schematic diagram of a close loop, choose between Level and Flow Control System.

A: It is asked to draw the schematic diagram of a close loop for level control system and flow control…

Q: Design two combinational circuit with four inputs and one output. The output is 1 if the number of…

A:

Q: The Mesh loop for i2 in the S domain is * 4 H elle 4e 4 ult) V (1) )2et ult) V 100

A:

Q: The inductance and a capacitance are connected in parallel. This combination is then placed in…

A: As per the guidelines of bartleyby I need to answer first question only.So kindly repost other…

Q: 2. 1052 202 SOU Lind In wging Thrvenin'h Thethem 362 4ov

A: The solution is given below

Q: 10 SL WL Flnd IL Wsing そ6 Norton's treikem IA

A:

Q: Q1: Calculate the drif T=300 K, Na=102'/m³. Hp=0.04m²/V.s, E=35 (Ans: 6.8×10 A/m2)

A:

Q: Problem 3: Using fourier transform, find vo (t) 12 1 F Where v(t) = e'u(-t) + u(t)

A:

Q: The Laplace Transform for sin(at) is* O a/(s2+a2)

A: As per the guidelines we are supposed to answer only first three questions of multiple type…

Q: Problem 3: Using fourier transform, find vo(t) 12 1F Where v(t) = eʻu(-t) + u(t) %3D

A:

Q: For the circuit shown below, calculate the time constant. (54.1 ns) 70Ω 2 mH all 20 V 30 Ω 80 Ω

A:

Q: (a) Give a component block-diagram for a practical temperature feedback system. kplain how the…

A: Note: We are authorized to answer the first question since the exact one wasn’t specified. Please…

Q: Consider multi-level page table with 22-bit memory addresses and 1 KB page size. The size of the…

A: According to the question,  Consider a multi-level page table with 22-bit memory addresses and 1 KB…

Q: If the roots of the characteristics equation z-0.53474+0.5543 rad and sampling time%-D0.5sec., the…

A: It is given that: Roots=z=0.5347∠±0.5543radSampling time=T=0.5 s

Q: Determine vo1 and vo for v71 = 5.92 mV and v2 = -4.85 mV. Voi (mV) Format : -22.8 vo (mV) Format :…

A:

Q: 1. A SCR has a forward breakover voltage of 175V when a gate pulse of 2 mA is made to flow. Find the…

A: It is given that: Vs=175 VVm=350V

Q: If V = 100 sin100t volt, and %3D I = 100 sin(100t +-) A. then find the watt less 6. power in watt :-…

A: Given, Voltage, V=100 si 100t volt Current, I=100 sin 100t+π6 A

Q: A discrete-time signal z[n] has a period of N > 2. Which of the following is/are always true about…

A: According to the properties CK=CN+K=CN-K ||CK+a||=||CN-K-a||=||CN+K+a||. where a is a constant /_ Ck…

Q: Q 2) The armature resistance of d.c motor is 0.5 2 and armature current is 200 A, when the supply…

A:

Q: Determine Vo for the network shown. Si Ge 2 k2 12 V 10 k2

A: The solution is given below

Q: Question 3 A two-legged core is shown in Figure 3. The winding on the left leg of the core has N =…

A:

Q: What is the permeability and magnetic susceptibility of a superconductor

A: In this question we will write about permeability and magnetic susceptibility of superconductor...

Q: increase TPDMIN all answers are correct reduce the power consumption decrease TPDMAX

A: Frequency of the digital circuit means the number of pulse crossing per second.However on decreasing…

Q: Q3: Determine 10mmx1mmx1mm sample, a magnetic field 0.2wb/m? is superposed on applied voltage 1mV.…

A: Hall Effect: When an electric current passes through a conductor in the presence of a magnetic…

Q: The current passing through the resistor 40 when t<0 is * tzo sim 0.02f: lov 30.5 H 10A 1A O 1.5A O…

A:

Q: What's the approximate distance a 480V, 45A, three-phase transformer, wired with 6 AWG copper can be…

A: It is given that: V=480 VI=45A

Q: A radiative Hertzian dipole antenna

A: Antenna- A device used for capturing or transmitting radio electromagnetic wave is termed as…

Q: WL Fland IL wsing Nortoi's treikem. Sou DIA

A:

Q: tv. 10 V 5 V 15 V 10 2 R1 1 A 0.25 A 12

A:

Q: A circuit containing capacitors and inductors is shown in Figure Q1(a). Find the current I3. C =20µF…

A:

Q: 7.120 Figure P7.120 shows a scheme for coupling and amplifying a high-frequency pulse signal. The…

A: MOSFET: It is a semiconductor device, a three-terminal device, and is used as a switch. Its…

Q: Q /Find the current and resistance of Norton's and Theremin's ? 300L 3002 12 V- 150 1502

A:

Q: If an op-amp comparator has a gain. of 100,000, an input difference of 0.2 mV above reference, and a…

A:

Q: An ADC has a 0 to 14.5-volt input with a(n) 13-bit output. What would the binary value 00..0111…

A: The solution is given below

Q: USING SUPERPOSITION THEOREM FIND THE CURRENT FLOWING THROUGH ALL IMPEDANCES. SHOW YOUR…

A:

Q: A CE amplifier uses a Wilson source as an active load. npn transistors have a beta    of 100 and an…

A: The Wilson source is a type of current source. It is used as a current mirror in various…

Q: X %D АВ + св + ADC + BCD

A: The solution is given below

Q: 6. Consider the given circuit. Determine Ip, IE +5 RE=2 k2 Ry = 100 k2 ww oVE=+4 V ERc=8 k2 --5 V

A:

Q: Write the impedance equation for the circuit shown. Follow the format used in the manual. XL ll R1…

A: The formulae used are shown below.

Q: Q/ For the below system, if you know that the input is r(t) = A sin(wt) explain and draw the…

A:

Q: How much current will flow in a 100 Hz series RLC circuit if VS = 20 V, RT = 66 ohms, and XT = 47…

A:

Q: 3. The characteristics equation for a closed loop discrete time system is given by: Q(Z)-z -1.8Z…

A: In this question we need to choose a correct option

Q: Calculate a series RC value that will produce a V = 7.59 V output at f = 87 Hz when V = 20 V at f =…

A:

Q: In a DSB-LC system, the message signal is 15 cos (8T*10*t) and the modulation index is 0.8. The…

A: We need to find out losses and signal to noise ratio for given amplitude modulated signal .

Q: Q /Find current, voltage, total current, and total voltage using a superposition? 1502 17 52 12V7…

A:

Synchronous Motor

The synchronous motor is an AC electric type motor where at a steady-state the shaft rotation is synchronized with the supply current variable-frequency. To an integral number of AC cycles, the rotation period is exactly equal. The stator of the motor in the synchronous motor contains multi-phase AC electromagnets due to which a magnetic field is created that rotates in time with the oscillation of the line current. The rotor contains a permanent magnet and the rotor rotates in synchronization with the stator field at the same rate and provides the second synchronized magnetic field which is rotating in nature as a result. When the synchronous motor is supplied with independently excited multi-phase AC electromagnets on both the rotor and the stator, it is termed as a doubly-fed machine. The most widely used AC-type motors are the synchronous AC motor and the induction AC motors.