A 5.00-kg block is placed on top of a 12.0-kg block that rests on a frictionless table. The coefficient of static friction between the two blocks is 0.600. What is the maximum horizontal force that can be applied before the 5.00-kg block begins to slip relative to the 12.0-kg block, if the force is applied to (a) the more massive block and (b) the less massive block?

A 5.00-kg block is placed on top of a 12.0-kg block that rests on a frictionless table. The coefficient of static friction between the two blocks is 0.600. What is the maximum horizontal force that can be applied before the 5.00-kg block begins to slip relative to the 12.0-kg block, if the force is applied to (a) the more massive block and (b) the less massive block?

Principles of Physics: A Calculus-Based Text

5th Edition

ISBN:9781133104261

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter5: More Applications Of Newton’s Laws

Section: Chapter Questions

Problem 46P: An aluminum block of mass m1 = 2.00 kg and a copper block of mass m2 = 6.00 kg are connected by a...

See similar textbooks

Similar questions

A hiker who has broken his forearm rigs a temporary sling using a cordstretching from his shoulder to his hand. The cord holds the forearmlevel and makes an angle of 40.0° with the horizontal where it attachesto the hand. Considering the forearm and hand to be uniform, with atotal mass of 1.30 kg and a length of 0.300 m, find (a) the tension inthe cord and (b) the horizontal and vertical components of the force, f>,exerted by the humerus (the bone of the upper arm) on the radius andulna (the bones of the forearm).
In the following figure, the horizontal surface onwhich this block slides is frictionless. If the two forcesacting on it each have magnitude F = 30.0 N andM = 10.0 kg , what is the magnitude of the resultingacceleration of the block?
Enter an expression for the magnitude of the force of the bottom-most parcel on the center parcel valid for any value of the vertical acceleration, ay, using only the parameters provided in the palette
A 5.50kg block starts from rest and slides on a 30°wedge, which issupported by a horizontal surface. The weight of the wedge is 13.70kg. If weneglect the effect of friction, determine: the acceleration of the wedge; the acceleration of the block in relation to the wedge?
The leg and cast in fig p4.40 weight 220n (w1) ,Determine the weight w2 and the angle ∝ needed so that no force is exeted on the hip joinby the leg plus the cast
A 65-kg stuntman is trying to cross a busy street, using a rope over the street. At some point on the way he stops, as shown. Find the tensions (a) on the left side of the rope, and (b) on the right side of the rope, when the angles are ?= 800and ?= 700.
In about 1915, Henry Sincosky of Philadelphia suspended himself from a rafter by gripping the rafter with the thumb of each hand on one side and the fingers on the opposite side. Sincosky’s mass was 79 kg. If the coefficient of static friction between hand and rafter was 0.70, what was the least magnitude of the normal force on the rafter from each thumb or opposite fingers? (After suspending himself, Sincosky chinned himself on the rafter and then moved hand-over-hand along the rafter. If you do not think Sincosky’s grip was remarkable, try to repeat his stunt.)
In about 1915, Henry Sincosky of Philadelphia suspended himself from a rafter by gripping the rafter with the thumb of each hand on one side and the fingers on the other side (see the figure). Sincosky's mass was 79.0 kg. If the coefficient of static friction between hand and rafter was 0.720, what was the least magnitude of the normal force on the rafter from each thumb or opposite fingers?
Calculate the largest value of the static friction coefficient which the block slides before toppling.
Jamal and Dayo are lifting a large chest, weighing 207 lb, by using the two rope handles attached to either side. As they lift and hold it up so that it is motionless, each handle makes a different angle with respect to the vertical side of the chest (Fig. P5.76). If the angle between Jamals handle and the vertical side is 25.0 and the angle between Dayos handle and the vertical side of the chest is 30.0, what are the tensions in each handle? FIGURE P5.76
Calculate the maximum acceleration of a car that is heading up a 4.00slope (one that makes an angle of 4.00with the horizontal) under the following road conditions. Assume that only half the weight of the car is supported by the two drive wheels and that the coefficient of static friction is involved—that is, the tires are not allowed to slip during the acceleration. (Ignore rolling.) (a) On wet concrete. (b) On wet concrete. (C) On ice, assuming that s=0.100 , the same as for shoes on ice.
An aluminum block of mass m1 = 2.00 kg and a copper block of mass m2 = 6.00 kg are connected by a light string over a frictionless pulley. They sit on a steel surface as shown in Figure P5.46, where = 30.0. (a) When they are released from rest, will they start to move? If they do, determine (b) their acceleration and (c) the tension in the string. If they do not move, determine (d) the sum of the magnitudes of the forces of friction acting on the blocks. Figure P5.46