Can solve it fast please A 50 km, 60 Hz transmission line has a resistance of 6 Q and its B-Parameter has amagnitude equal to 10. Then its inductance in H (to 4 decimal places) is equal to:Answer

Answered: Image /qna-images/answer/51e20b0a-04e2-45e9-aef2-9b1b66a009a3.jpg

Answered: A 50 km, 60 Hz transmission line has a…

A 50 km, 60 Hz transmission line has a resistance of 6 Q and its magnitude equal to 10. Then its inductance in H (to 4 decimal pla Answer

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter17: Resistive-inductive Series Circuits

Section: Chapter Questions

Problem 2PP: Assume that the voltage drop across the resistor, ER, is 78 V, that the voltage drop across the...

See similar textbooks

Related questions

Q: Calculate the capacitance and charging current of a single-core cable used on a 3-phase, 66 kV…

A: Given data, Length of cable l = 1 km. Core diameter D = 10 cm = 0.1 m Paper thickness d = 7 cm =…

Q: Example 6: Calculate the capacitance and charging current of a single core cable used on a 3-phase,…

A: Given Data: d = 10 cm l = 1000 m er = 4

Q: (25 pts) A patient is coupled by 5pF stray capacitance to a 220V 50HZ ac power-line bus while his…

Q: Given a parallel plate capacitor, determine the energy density if the potential difference and…

A: Given, A parallel plate capacitor has, Potential difference between the plates (dV)= 250 volts…

Q: A three-conductor belted cable 15 mi long is used as a three-phase underground line for a 69 kV…

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: A radio transmitter is connected to an antenna having an impedance 60 + j20 N with a 50 N coaxial…

A: This question belongs to electronics . It is based on the calculation of power for antenna .…

Q: 3. A voltage e(t) = 100 sin 314 t is applied to a series circuit consisting of 10 ohms resistance,…

A: Given e(t)=10sin314t R=10 ohms L=0.0318H C=63.6uF

Q: PROBLEMS (PG. NO: 323) Three coils each having resistance 60 and inductance LH are connected in…

A: For delta connected system line current=3×phase current. current I=VZ where Z=R2+(WL)2

Q: 1. Given V, = 20cos (17t – 30), find out the P and Q absorbed by the capacitor. Moreover, How much P…

Q: Given the following pairs of voltages and currents, indicate whether the element involved is a…

A: We know, The expression for voltage is given by,V=Vmsinωt ---(A)The expression for current is given…

Q: A coil, with 100 mH of inductance and 10 Q of resistance, has been connected to an AC power supply…

Q: represents the electrical fields distribution between 2. The equivalent_ the two wires of the…

A: Capacitor stored energy in the form of electric field.

Q: Q.4 Answer any One of the following A. Two microstrip transmission lines A and B are to be used in a…

A: Given: for transmission line A, wh=0.34εr=4 for transmission line B, wh=0.9εr=2

Q: A SERIES RC CIRCUIT TAKES A CURRENT WHOSE EQUATION Is 2 sin (754t+40) AMPERE. WHEN CONNECTED TO A…

Q: To change the power factor of an electrical load from unity to 0.9 lag, a capacitor should be…

A: Power factor is the ratio of true power by apparent power. The value of power factor lies in between…

Q: Define Five of the following Heliostats, Primary energy, capacity factor, commercial energ;…

A: As per Bartleby guidelines we are allowed to solve only three subparts, please ask the rest again.

Q: The parameters of a cable are as follows Resistance = 65 ohms; Inductance 1.6 m H; Capacitance 0.1…

A: Given:- R(Resistance)=65ohm L(Inductance)=1.6mh C(Capacitance)=0.1microfarad…

Q: Q2) A 132 kV, 3-phase, 50 Hz transmission line 200 km long having a capacitance to earth of each…

Q: AC circuit contains resistor 18.7 0, inductor 18 mH, and capacitor 560 µF, where they are connected…

Q: 2. The equivalent_ represents the electrical fields distribution between the two wires of the…

A: The objective is to determine the correct option for the transmission line parameter.

Q: 1. A transmission line has 2.5 pF of capacitance per foot and 100 nH of inductance per foot.…

Q: A single-phase 60 miles 69kV transmission line consist of two 000-AWG solid copper conductors spaced…

A: In this question we need to find a capacitance of the given transmission line.

Q: R L 10 Q ll V sine The frequency of the voltage source is 5000 rad/sec. The impedance &f the…

A: In this question, We need to determine the value of capacitance C for the unity power factor? We…

Q: A conducting sphere of radius 2 cm is surrounded by a concentric conducting sphere of radius 5 cm.…

A: We need to find out capacitance

Q: 369-Vrms, 60-Hz supply serves a load that is 9 kW (resistive), 9 KVAR (capacitive), and 13 kVAR…

A: Given, Vs = 369 Vrms, F = 60 Hz, Power = 9 Kw, Capacitive reactive power = 9 KVAR, Inductive power =…

Q: An RG58 coaxial cable has a capacitance of 30 pF per foot and a characteristic impedance of 50 ohms.…

A: According to the question we have to calculate the inductance of the cable per foot.

Q: 10. A 12 V battery with an internal resistance of 10 ohms is connected to a 20 m long 50 ohm coaxial…

Q: A voltage, v = 120 sin(377t + 50° ) supplies a current, i = 10 cos( 377t – 60°) to an impedance…

A: As per our policy i have to do only first three. Given data, The value of voltage is V =…

Q: Q2: For the three coupled coils in Fig., calculate the total inductance. 4 H 8 H 10 H ell 20 H ll ll…

Q: DISCUSSION: 1. Does the change in amplitude or frequency of supply Voltage affect the performance of…

A: 1) Voltage is defined in basic electric principles as the potential difference that pushes a current…

Q: ure inductance of L = 144 mH 118 V, 50 Hz supply. The cure ctor is given by

Q: The capacitance of a single phase two-wire transmission line depends on: Select one: O a. All the…

A: Capacitance of a Single Phase Two Wire Line consisting of two parallel conductors A and B spaced d…

Q: What is the instantaneous current at t=1 sec, if a 20 micro-farad capacitor was charged with 10…

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Q: Electrical Engineering 4.0 m) 1819 18.9 m m 7.3 m 44.5 m b 33.8 m CA 25.3 m Electrical Power Systems…

A: Solution

Q: Q3\ For the circuit in fig. (2) Change the value of the inductance to (5 mH) ,and Calculate the…

A: Disclaimer: Since you have asked multipart questions, we will solve the first three subpart for…

Q: Calculate the velocity factor of a coaxial cable used as a transmission line with the characteristic…

Q: R1 1000 V1 L1 12Vpk 1kHz 0° 100MH Find the inductor's reactance XL, impedance Z, the circuit's…

Q: Three identical capacitors are connected in delta with 400 V. If the line current is 12 A…

A: The solution can be achieved as follows.

Q: Q2: For the three coupled coils in Fig., calculate the total inductance. 4 H 8 H 10 H elll 20 H ll…

A: Inductor is passive element that store energy in magnetic field. When two inductor are in close such…

Q: Check the system if (linear, causal, stable) 1. y(t)=sin tx(t)

A: CONTINUOUS AND DISCRETE-TIME SIGNALS: Because a signal is a function, we truly mean continuous-time…

Q: 8/An Electrical Fan is considered an Inductive Load. Select one: True False

A: Electrical fan is an single phase induction motor , in which coils are wound by some copper wire. So…

Q: 6. a) For a parallel plate capacitor &=10, A=.01 m², distance between two plates,d=0.05 mm. If…

A: Given data Area is A = 0.01 m2 Distance between two plates is d = 0.05 mm Applied voltage is V =…

Q: Calculate what L network components will match a 60 internal resistance in series with an internal…

Q: Example: A 47µF capacitor is connected to a voltage which varies in time as v(t) = 20sin(200xt)…

A: Given circuit is - Given values are -

Question

Can solve it fast please

A 50 km, 60 Hz transmission line has a resistance of 6 Q and its B-Parameter has a
magnitude equal to 10. Then its inductance in H (to 4 decimal places) is equal to:
Answer

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Calculate the velocity factor of a coaxial cable used as a transmission line with the characteristic impedance of 50 ohms; capacitance is 40 pF/m and an inductance equal to 50 microH/m.
23. Calculate the reactance of a peterson coil suitable for 1 33kV, 3phase transmission system of which the capacitance to eart of each conductor is 3.2μF
1. Find the outer radius of a coaxial cable having a characteristic impedance of 12 and a dielectric constant of 0.06. The outer inner radius of this cable is 4 cm. 2. How much is the inductance of a coil of an instrument that induces 1000 V when its current changes at the rate of 50 mA in 2 µs
A twin lead transmission line is embedded in a dielectric material with 3.2 relative permittivity. Its wires are separated by 2cm and their diameters are both 3mm. Compute for its characteristic impedance.
A 25V, 2.5kHz supply is connected to a network comprising a variable capacitor in parallel with a coil of resistance 250 ohms and inductance 80 mH. Determine, for the condition when the supply current is a minimum the capacitance of the capacitor the dynamic impedance the supply current the upper half-power frequency the value of the circuit impedance at the -3dB frequencies
q15/ choose the correct answer In a 200kV transmission system, the transmission line can be used as a medium for power carrier communication. Select one: True False
A transmission line has the following primary constants: resistance R = 15 /loop km, inductance L = 3.4 mH/loop km, conductance G = 3µS/km and capacitance C = 10 nF/km. Determine the characteristic impedance of the line when the frequency is 2 kHz
A 230 kV, 3-phase, 50 Hz, 200 km transmission line has a capacitance to earth of 0.03 µF/km per phase. Calculate the inductance and kVA rating of the Peterson coil used for earthing the above system.
Explore the challenges and benefits of implementing power electronics-based grid solutions like STATCOM (Static Synchronous Compensator) for voltage control and stability.
characteristic impedance z0 = 50 ohms is a short-circuited coaxial (coaxial) cable with a length d = 0.3λ component is wanted to be made. Use Its frequency is f = 8 GHz. (a) Identify the component. (b) Find the impedance value of the component. (c) Find the parameter value of the component. lesson:electrical and electronical engineering
The ratio J/Jd (conduction current density to displacement current density) is very important at high frequencies. Calculate the ratio at 1 GHz for:(a) distilled water (μ = μo, ε = 81εo, σ = 2 x 10−3 S/m)(b) seawater (μ = μo, ε = 81εo, σ = 25 S/m)(c) limestone (μ = μo, ε = 5εo, σ = 2 x 10−4 S/m)
Given the following circuit. Determine the Z parameters. * 8Q 10Q “