The parameters of a cable are as follows Resistance = 65 ohms; Inductance 1.6 m H; Capacitance 0.1 microfarads; Conductance = 2.25 micromho. If the angular frequency is 5000 radians/sec, Calculate the Characteristics impedance %3D %3D

The parameters of a cable are as follows Resistance = 65 ohms; Inductance 1.6 m H; Capacitance 0.1 microfarads; Conductance = 2.25 micromho. If the angular frequency is 5000 radians/sec, Calculate the Characteristics impedance %3D %3D

Electric Motor Control

10th Edition

ISBN:9781133702818

Author:Herman

Publisher:Herman

Chapter3: Magnetic Starters

Section: Chapter Questions

Problem 30SQ

See similar textbooks

Related questions

Q: R L 3. Find the expression for the instantaneous values of the voltages across the resistance (VR),…

A: Given circuit, Where, i(t)=414sin2πft Af=50 HzR=100 ΩL=0.31831 H

Q: A 240 kV, 3-phase, 50 Hz, 400 km transmission line has a capacitance to earth of 0.04 µF/km per…

A: We have a 3-phase transmission line having, Line voltage (V) = 240 KV = 240 * 103 V frequency (f) =…

Q: A resistance of 100 Ω, an inductance of 0.1 H, and a capacitance of 5(10 −5 ) F are connected in…

A: Explanation: The resistor, inductor, and capacitor are connected in series Given that, ω = 377 So…

Q: Using the phase shift of 72º from the Experiment, determine the inductance value, L, of the inductor…

Q: 19 Three impedances are connected in series across a 100 V, 2 kHz supply. The impedances comprise:…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: A 66 kV single phase line has two parallel conductors 2.2 meter apart. The diameter of each…

Q: 6. A 240-Vrms 50-Hz supply serves a load that is 10 kW (resistive), 15 KVAR (capacitivc), and 22…

Q: Practical Side Choose the right answer of the following: 1- As pressure decreases, the disruptive…

Q: 3. A voltage e(t) = 100 sin 314 t is applied to a series circuit consisting of 10 ohms resistance,…

A: Given e(t)=10sin314t R=10 ohms L=0.0318H C=63.6uF

Q: 16. It is desired to run a bank of ten 100-W, 10-V lamps in parallel from a 230-V, 50-Hz supply by…

A: Given that ten lamps of 100 W each , Therefore, Total power of the system is 1000 W Although…

Q: A transmission line has aluminum conductors of a radius of 1.0 inches. If the aluminum conductors…

A: InductanceL = 2×10-7×lndrAs r2 = 2 inchesr1 = 1 inchesAs r2>r1so L2>L1 → So inductance…

Q: An air-filled planar line with w = with o, = 7 x 10' S/m. Calculate R, L. 30 cm, d = 1.2 cm, t 3 mm…

A: Wave is function of space and time. The mode at which waveguide have lowest frequency is said to be…

Q: 3. Find the expression for the instantaneous values of the voltages across the resistance (VR),…

A: Given series RL circuit shown i=414sin2πft Af=50 HzR=100 ΩL=0.31831 H

Q: Given a parallel RLC circuit comprised of the following element: 76.19-ohm resistor, ideal inductor…

A: True power is nothing but power consumed by resistor Given by P = Vrms2/R

Q: TT=3,1416 Find the capacitance of the system (interms of nF) consisting of two air-filled…

Q: A 50 km, 60 Hz transmission line has a resistance of 6 Q and its magnitude equal to 10. Then its…

Q: a. A parallel plate capacitor with plate area of 8 cm and plate separation 2 mm has a voltage 20 sin…

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…

Q: na pure inductive circuit, connected to an ac source, the current in it leads the applied voltage by…

A: in a pure inductive circuit, connected to an AC source the current in it leads the applied voltage…

Q: Three identical capacitors are connected in Delta to a 415V, 50HZ, 3-phase supply. If the line…

A: For delta connection of capacitors, IL= squareroot(3) x Ip => Ip = 10/(squareroot(3)) => Ip =…

Q: A circuit comprises a coil of inductance 113.68mH, resistance 3on in series with a variable…

Q: Q2. A 50 Q carbon resistor has two lead wires with inductance of 10 nH each. If the stray…

A: Impedance of inductor given byXL= jwL Impedance bof capacitor given by Xc= -j/wC

Q: 2. The equivalent_ represents the electrical fields distribution between the two wires of the…

A: The objective is to determine the correct option for the transmission line parameter.

Q: 1. A transmission line has 2.5 pF of capacitance per foot and 100 nH of inductance per foot.…

Q: 2 A voltage e(t) = 100sin 314t is applied to a series circuit consisting of 10ohms resistance,…

Q: A conducting sphere of radius 2 cm is surrounded by a concentric conducting sphere of radius 5 cm.…

A: We need to find out capacitance

Q: Three identical capacitors are connected in star to a 415 V, 50 Hz, 3-phase supply. If XC = 15…

A: Xc=15 ohm

Q: 2. A delta-connected load with 500 resistance, 209mH inductance and 50µF capacitance in series per…

A: In this question we need to find a phase current of the given three phase circuit.

Q: 5. Following readings were obtained from a series circuit containing resistance and capacitance : V…

Q: 8.What is the coefficient of coupling of two coils whose mutual inductance is 1 H and whose…

A: coefficient of coupling = mutual inductance bateween two coilproduct of inductance of the two…

Q: Ohm s Law applies to all types of circuits, but in the case of AC circuits, all circuit quantities…

A: In this question we will find circuit related problems.... Note:- as per our guidelines , I will…

Q: A transmission line has a capacitance of 25 pF / ft. and an inductance of 0.15 µh / ft. Determine…

Q: Q1/ Determine the value of the capacitance, C for the circuit shown in Fig.(1) The network function…

A: The circuit is shown below: The output voltage is given the voltage division rule,…

Q: A cable has inductance of 0.22 mH per km and capacitance of 0.202 microF per km. The surge impedance…

A: Given, a cable has Inductance, L= 0.22 mH Capacitance, C= 0.202 μF

Q: A 230 kV, 3-phase, 50 Hz, 200 km transmission line has a capacitance to earth of 0.03 µF/km per…

A: We have an Transmission line with, Line Voltage (Vl) = 230 KV = 230 * 103 V Length of Line (l) = 200…

Q: The capacitance of an overhead transmission line increases with 1. increase in mutual geometrical…

A: we need to choose correct option.

Q: Electrical Engineering 4.0 m) 1819 18.9 m m 7.3 m 44.5 m b 33.8 m CA 25.3 m Electrical Power Systems…

A: Solution

Q: 3 An air line has a characteristic impedance of 70 Q and a phase constant of 3rad/m at 100MHZ.…

A: Characteristics impedance is given 70 ohm Frequency is given f = 100 MHz Phase constant is given β=3…

Q: a series r-c circuit takes a current whose equation is i=0.85sin(754t+pi/4) when connected to a…

A: This question belongs to circuit theory . It is based on the concept of series connected RC circuit…

Q: 1- As pressure decreases, the disruptive voltage (increases/ decreases). 2- Actually the string…

A: Here are the few basic questions related to power system. Through these questions corona loss…

Q: For the circuit shown below (a) Determine the Norton equivalent circuit excluding the inductor. (b)…

Q: 5. A coil RL is connected in series with a capacitor across the 220 V, 60 hz, AC supply. If this…

A: Use phasor diagram to find magnitude of voltage across the coil or voltage across the capacitor.

Q: 3. A. A coil consists of a resistance of 200 N and an inductance of 2500MH. If an alternating…

Q: 4. What is the inductance of a cable that has a capacitance of 50 pF/ft and a characteristic…

Q: 3. A voltage e(t) = 100 sin 314 t is applied to a series circuit consisting of 10 ohms resistance,…

A: In this question, we need to determine the expression of the current I(t) and phase angle and power…

Q: A coil of wire having a value of (6 + j9) ohms is connected in series with a capacitive reactance…

Q: A resistor of 150 ohms is connected in series with an 0.8 H inductor, across a 230 V, 60 Hz supply.…

A: Given RL series network With R = 150 ohm L = 0.8 Henry Supply voltage 230 v, 60 Hz

Q: Three currents i,, i, and i, are approaching a node. If i, = 10 sin (400t + 60°) A, and i, = 10 sin…

A: In this question we will find current i 3...

Q: 6. a) For a parallel plate capacitor &=10, A=.01 m², distance between two plates,d=0.05 mm. If…

A: Given data Area is A = 0.01 m2 Distance between two plates is d = 0.05 mm Applied voltage is V =…

Question

The parameters of a cable are as follows Resistance = 65 ohms; Inductance 1.6 m H; Capacitance = 0.1
microfarads: Conductance = 2.25 micromho. If the angular frequency is 5000 radians/sec, Calculate the
Characteristics impedance
%3D
Paragraph
-61E

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 230 kV, 3-phase, 50 Hz, 200 km transmission line has a capacitance to earth of 0.03 µF/km per phase. Calculate the inductance and kVA rating of the Peterson coil used for earthing the above system.
3. A transmission line has a capacitance of 0.1 μF per phase. Determine the inductance of Peterson coilto neutralize the effect of capacitance of (i) complete length of the line, (ii) 97% of the line, (iii) 90%length of the line. The supply frequency is 50 Hz. [(i) 33.80H (ii) 34.84H (iii) 37.55H]
An RG58 coaxial cable has a capacitance of 30 pF per foot and a characteristic impedance of 50 ohms. What is the inductance of the cable per foot.
A resistance of 16 Ω is connected in series with a pure inductance of 39.9 mH and the circuit is connected to a 100 V, 50 Hz, sinusoidal supply. Calculate the phase angle of the impedance. Give your answer as a number without units to 0 decimal places.
A cable has inductance of 0.22 mH per km and capacitance of 0.202 microF per km. The surge impedance of the cable is ?
Given a parallel RLC circuit comprised of the following element: 76.19-ohm resistor, ideal inductor with reactance of 72.41 ohms; and a capacitor with reactance of 16.55 ohms. Compute for true power in watts given an ac voltage source of 100 cis 0 volts.
I have already answer but can please help to understand calculations..i will give vote A 240 kV, 3-phase, 50 Hz, 400 km transmission line has a capacitance to earth of 0.04 µF/km per phase. Calculate the inductance and kVA rating of the Peterson coil used for earthing the above system.
solve the equation for I(t), where Resistance (ohm) = 6.8, Voltage(volts) = 120, Frequency (Hz) = 50, Inductance (millihenry) = 1.3, Capacitance (millifarad) = 16.19
A coil of wire having a value of (5 + j8) ohms is connected in series with a capacitive reactance Xc, and this series combination is then connected in parallel with a resistor R. If the equivalent impedance of the circuit is 4 /0o ohms, calculate the values of Xc and R.
A choking coil having a resistance of 20 Ω and an inductance of 0.07 henry is connected with a capacitor of 60 μF capacitance which is in series with a resistor of 50 Ω. Calculate the total current and the phase angle when this arrangement is connected to 200-V, 50 Hz mains.
A microstrip transmission line is to be used as a capacitor of 4pf at 800MHZ. The PCB dielectric is 3.6. The microstrip dimensions are h= 0.0625in, w= 0.13in, and l=0.002in.What are (a) the characteristic impedance of the line and (b) the reactance of the capacitor.
A coil of inductance 159.2 mH and resistance 40 ohms is connected in parallel with a 30 µF capacitor across a 240 V, 50 Hz supply.Calculate(a) Current in the coil and its phase angle (b) Current in the capacitor and its phase angle, (c) Supply current and its phase angle, (d) Circuit impedance,