A 6 pole wave wound shunt generator delivers 180A at a terminal voltage of 215V. Ra and Rsh are 0.042 and 600 respectively. Neglecting brush drop, determine (i) armature current (ii) current per parallel path (ii) generated voltage and (iv) Power developed.

A 6 pole wave wound shunt generator delivers 180A at a terminal voltage of 215V. Ra and Rsh are 0.042 and 600 respectively. Neglecting brush drop, determine (i) armature current (ii) current per parallel path (ii) generated voltage and (iv) Power developed.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter12: Power System Controls

Section: Chapter Questions

Problem 12.5P

See similar textbooks

Related questions

Q: Given a six pole IM connected to a 60-cycle 3 phase circuit. Calculate the airgap diameter ( rotor…

Q: A 1000KVA, 6.6 kV 3 PHASE star connected cylindrical pole synchronous generator has 20-ohm as…

A: The circuit diagram for the synchronous generator is shown below:

Q: . Discuss about the excitation system of Synchronous generator.

Q: How many poles should a 60-Hz generator have, if it is connected to a turbine operating under a…

Q: (a) Give comparison between salient pole and non-salient pole type synchronous generator.

A: Note :- We’ll answer the first question since the exact one wasn’t specified. Please submit a new…

Q: Q: (A): Draw the general per-phase equivalent circuit of a two-winding (2-phase) motor, based on the…

A: to explain symmetrical stator winding

Q: EITY OF GOLOAO DENVER A 1500kW, three-phase Y-connected 2300V, 30-pole, 60HZ synchronous motor has a…

A: Given: Line voltage = 2300 V, Terminal voltage per phase Vϕ=23003=1327.9 V, Synchronous reactance…

Q: Discuss the double field revolving theory and discuss the equivalent circuit diagram of single phase…

A: Single phase Induction Motor are also known as Fractional kW motors. It is commonly used in…

Q: A 1000 kVA, 6.6 kV, 3-phase star connected cylindrical pole synchronous generator has a synchronous…

A: Given values are - S=1000kVAVt=6.6kVXs=20ohmUnity power factor.cosϕ=1

Q: A 230VAC rated, 60 Hz, 10-Hp Single-phase AC motor is to be connected for across-the-line starting.…

A: Steps With 20 % overloading, calculate line currents Choose range from wire selection table Take a…

Q: (2)A 20 MVA, 3-phase, star-connected, 50HZ, salient pole synchronous generator with X; =1 pu, X =…

Q: Q11. If the rotating speed of a synchronous motor becomes higher, will the slot leakage reactance…

Q: A 6 pole wave wound shunt generator delivers 185A at a terminal voltage of 235V. Ra and Rsh are…

A: pole=6IL=185A(load current)V=235VRa=0.05ohmRsh=40ohm Shunt generatorE=V+IaRaE=generated voltageIa=IL…

Q: Discuss about Generator modeling in transient stability and derive the formula for the real and…

A: In transient stability analysis of the generator, because of large disturbance linearisation of…

Q: A shunt generator supplies a 34kW load at 225V through cables of resistance, R = 126m2. If the field…

Q: Example: A30,5KVA,208V,60HZ,synchronous machine has negligible stator winding resistance and Xs =80…

A: Given information a three phase synchronous machine which is operated as a generator is, Rated…

Q: 1- Prove from the first principles an expression for the generated EMF at the armature of DC…

Q: 5) With derivative controller, the value of maximum overshoot M, is

A: Control systems are represented by transfer function. This can be written in both time domain and…

Q: Q3: A synchronous generator with peak generated voltage Vg which is connected to a lighting arrester…

A: Equivalent per phase diagram Apply KVL in loop 1)

Q: Describe constant and variable frequency operation of chopper control. Describe how duty cycle…

Q: A 2 pole wave wound shunt generator delivers 190A at a terminal voltage of 210V. Ra and Rsh are…

A: Since we only answer up to 3 sub parts we will answer the first 3, please resubmit the question and…

Q: a- Compare the excitation of 3-phase induction and synchronous machines.

A: As per the policy, I can attempt only one individual question at a time. Compare the excitation of 3…

Q: The torque angle of synchronous machine operating from a constant voltage bus, is usually defined as…

A: the torque angle of synchronous machine is operated from a constant voltage bus, is usually defined…

Q: shunt generator supplies a 24kW load at 200V through cables of resistance, R = 110mΩ. If the field…

Q: does not the generator voltage increase when the excitation current (Ie) increases over the

Q: a) Explain the principle operation of synchronous generator.

Q: The breadth factor for 3rd harmonic emf of a 3 phase, 4 pole, synchronous machine having 36 stator…

A: Given a 3-phase synchronous machine having, 3rd harmonic, r =3 Number of pole, P = 4 Number of slots…

Q: (a) Sketch the equivalent circuit and obtain the general equation for synchronous generator

A: Synchronous generator: It is an electromechanical device. This is called a synchronous generator…

Q: A long-shunt compound generator delivers a load current of 50A at 500V and has armature, series…

Q: What is the Difference between (Cumulative compound & Differential compound DC generator)??

Q: A 8 pole wave wound shunt generator delivers 205A at a terminal voltage of 230V. Ra and Rsh are…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: 7. What is the nature of the generator-load frequency characteristics? 8. What is the effect of a…

A: Load-frequency characteristics: Under equilibrium conditions, but with equivalent primary control…

Q: 11 What is the dq component - Park transform The effective stator field current is I, = and the…

A: The direction of the direct-axis current is along the direction of the rotor magnetic field and the…

Q: For the radial system shown, the setting of the second zone (in secondary settings) of a relay at V…

A: Given CT 1000: 1 VT ratio -132000 : 120 -1100 :1 Second zone

Q: A 230VAC rated, 60 Hz, 10-Hp Single-phase AC motor is to be connected for across-the-line starting.…

A: Calculate current after loading 20 % extra Choose current range from calculated value and wire…

Q: Compared between three_ phase induction generator and synchronous them at impedance field and EMF…

Q: A 4 pole lap wound shunt generator delivers 200A at a terminal voltage of 220V. Ra and Rsh are 0.02Ω…

A: For this problem, given terminal voltage is 220V, armature resistance 0.02ohms.

Q: A 4 pole wave wound shunt generator delivers 200A at a terminal voltage of 220V. Ra and Rsh are…

Q: A 1200 kVA, 6600 volts, three-phase wye connected alternator, has an effective resistance of 2.5…

A: The solution is given below

Q: A 10 pole wave wound shunt generator delivers 178 A at a terminal voltage of 236 V. Ra and Rsh are…

A: For generator Armature current = Load current +shunt field current. Generated voltage =Terminal…

Q: torque equation of induct

A: Solution- Torque Equation- In induction relay torque equation, two magnetic fluxes ϕ1 & ϕ2 which…

Q: Derive emf equation of the synchronous generator.

Q: why is there a phase shift in rc cct?how do we make it exactily 90 degree?

Q: analyze 3 commonly used ac motor starting methods using suitable diagrams and torque-speed curves

A: Starting of a 3-phase induction (AC) motor: A 3-phase induction motor is widely used in industries.…

Q: A 8 pole wave wound shunt generator delivers 185A at a terminal voltage of 240V. Ra and Rsh are…

A: Armature current =load current +shunt field current. Armature current per parallel path = total…

Q: Draw voltage phasor diagrams for different load cases of salient synchronous generators and derive…

A: Synchronous generators are used for power generation. The power factor shows the phase relation…

Concept explainers

Synchronous Generator

In comparison to an asynchronous generator, it is a machine where the rotor speed is equal to the rotating magnetic field produced by the stator, i.e., mechanical speed is equal to the electrical speed, thus called synchronous, and not asynchronous.

Salient Pole Rotor

Salient pole rotor includes a large number of exposed poles mounted on a magnetic wheel. The construction of a bright pole is as shown in the image on the left. The proposed poles are made of metal laminations. The rotor winding is provided on these poles and is supported by pole shoes.

Question

100%

A 6 pole wave wound shunt generator delivers 180A at a terminal voltage of 215V. Ra and Rsh are 0.042 and 602 respectively. Neglecting brush drop,
determine (i) armature current (ii) current per parallel path (ii) generated voltage and (iv) Power developed.
armature current
current per parallel path
generated voltage
Power developed

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

For Problem 3.18, the motor operates at full load, at 0.8 power factor leading, and at a terminal voltage of 10.45 kV. Determine (a) the voltage at bus 1, which is the generator bus, and (b) the generator and motor internal EMFs.
The amplitude of the sinusoidal symmetrical ac component of the three-phase short-circuit current of an unloaded synchronous machine decreases from a high initial value to a lower steady-state value, going periods through the stages of __________ and ________ periods.
A long shunt generator delivers 25kW at 220V. The shunt, series and armature resistances are 50ohms, 0.02ohms, and 0.05ohms respectively, calculate the generated emf.
a) 3-phase star-connected synchronous generator supplies a current of 10A having phase angle of 20° lagging 400V (phase voltage). Given the direct and quadrature axis reactances as 10ohms and 6.5ohms respectively and neglecting armature resistance, Find: 1. The load angle 2 The direct and quadrature components of armature currents 3. Voltage regulation
A 100KVA, 6.6 kV 3 PHASE star connected cylindrical pole synchronous generator has 20-ohm as synchronous reactance and the armature resistance is negligible and the generator is working at the full load and unity power factor then find the value of the induced emf voltage(line to line).
Derive emf equation of the synchronous generator.
A long-shunt compound generator delivers a load current of 50A at 500V and has armature, series field and shunt field resistances of 0.05 ohms, 0.03 ohms and 250 ohms respectively. Calculate the generated voltage and the armature current. Allow 1V per brush for contact drop.
a single-phase, 10-kVA, 200-V, generator has an internal impedance Z, of 2 Q. Using the ratings of the generator as base values, determine the generated per-unit voltage that is required to produce full-load current under the short-circuit condition.
Two generators rated 200MW and 400MW are operating in parallel. The droop characteristics of both the governor have a drop of 4%. from no load to full load. Assuming that the generators are operating at 50Hz at no load, how would a load of 600MW be shared between them? What will be the system frequency at this load? Assume free governor operation.
A long shunt compound DC generator delivers a load current of 150A at 230V and has armature, series field and shunt field resistances of 0.032, 0.015 and 92Ωrespectively. Calculate (i) induced emf (ii) total power generated and (iii) distribution of this power (iv) voltage regulation
a) With the aid of a diagram and phasor diagram, explain the double-reactance concept for salient-pole alternators. b) 3-phase star-connected synchronous generator supplies a current of 10A having phase angle of 20° lagging 400V (phase voltage). Given the direct and quadrature axis reactances as 10ohms and 6.5ohms respectively and neglecting armature resistance, Find: 1. The load angle 2 The direct and quadrature components of armature currents 3. Voltage regulation
A 100KVA, 6.6 kV 3 PHASE star connected cylindrical pole synchronous generator has 20-ohm as synchronous reactance and the armature resistance is negligible and the generator is working at the full load and unity power factor then find the value of the induced emf voltage(line to line). Answer fast