A 2 pole wave wound shunt generator delivers 190A at a terminal voltage of 210V. Ra and Rsh are 0.020 and 5On respectively. Neglecting brush drop, determine (i) armature current (ii) current per parallel path (iii) generated voltage and (iv) Power developed. armature current current per parallel path generated voltage

A 2 pole wave wound shunt generator delivers 190A at a terminal voltage of 210V. Ra and Rsh are 0.020 and 5On respectively. Neglecting brush drop, determine (i) armature current (ii) current per parallel path (iii) generated voltage and (iv) Power developed. armature current current per parallel path generated voltage

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter6: Power Flows

Section: Chapter Questions

Problem 6.48P

See similar textbooks

Similar questions

a) 3-phase star-connected synchronous generator supplies a current of 10A having phase angle of 20° lagging 400V (phase voltage). Given the direct and quadrature axis reactances as 10ohms and 6.5ohms respectively and neglecting armature resistance, Find: 1. The load angle 2 The direct and quadrature components of armature currents 3. Voltage regulation
Two generators rated 200MW and 400MW are operating in parallel. The droop characteristics of both the governor have a drop of 4%. from no load to full load. Assuming that the generators are operating at 50Hz at no load, how would a load of 600MW be shared between them? What will be the system frequency at this load? Assume free governor operation.
A long shunt generator delivers 25kW at 220V. The shunt, series and armature resistances are 50ohms, 0.02ohms, and 0.05ohms respectively, calculate the generated emf.
Derive emf equation of the synchronous generator.
A shunt generator supplies a 31kW load at 230V through cables of resistance, R = 122mΩ. If the field winding resistance, Rf =50Ω and the armature resistance, Ra =51mΩ. Determine the following below: The terminal voltage is, Answer and unit for part 1 The e.m.f. generated in the armature is,
For the power system of Figure Q4.1, all per unit quantities have been calculated using a common base. The generator delivers power ??∞=1 ??.??. at a lagging power factor of ????????=0.93. i) Calculate the internal voltage of the generator, the maximum electrical power that the generator can deliver to the system during the steady state operation and the steady state rotor angle, ??0, of the generator.ii)A three-phase fault occurs at busbar 3 and it is cleared by simultaneously disconnecting lines 13 and 23. Following the fault clearing, the system continues to operate with only line 12 in service. Determine the new steady state rotor angle, ??1, of the generator and the maximum power the generator can deliver to the system post fault.iii)Assuming that the post fault condition is small disturbance stable and that there is no negative interaction among system controllers, calculate the critical clearing angle, ??????, at which the fault should be cleared to ensure the generator reaches…
a single-phase, 10-kVA, 200-V, generator has an internal impedance Z, of 2 Q. Using the ratings of the generator as base values, determine the generated per-unit voltage that is required to produce full-load current under the short-circuit condition.
A long-shunt compound generator delivers a load current of 50A at 500V and has armature, series field and shunt field resistances of 0.05 ohms, 0.03 ohms and 250 ohms respectively. Calculate the generated voltage and the armature current. Allow 1V per brush for contact drop.
A 100KVA, 6.6 kV 3 PHASE star connected cylindrical pole synchronous generator has 20-ohm as synchronous reactance and the armature resistance is negligible and the generator is working at the full load and unity power factor then find the value of the induced emf voltage(line to line). Answer fast
A synchronous generator is connected to an infinite bus by a transmission line as shown in the figure. The field current IF = 900A when the unloaded generator is synchronized to the infinite bus. a.) P_M is increased to 0.5pu while I_F is held constant at 900A. Find the complex power S_Inf supplied to the infinite bus in per unit. b.) Determine S_Inf in per unit if IF increases to 1600A and PM is held fixed at 0.5pu.
A 230VAC rated, 60 Hz, 10-Hp Single-phase AC motor is to be connected for across-the-line starting. Determine its conductor size if the ambient temp and RHW copper-clad aluminum will be used.
a) With the aid of a diagram and phasor diagram, explain the double-reactance concept for salient-pole alternators. b) 3-phase star-connected synchronous generator supplies a current of 10A having phase angle of 20° lagging 400V (phase voltage). Given the direct and quadrature axis reactances as 10ohms and 6.5ohms respectively and neglecting armature resistance, Find: 1. The load angle 2 The direct and quadrature components of armature currents 3. Voltage regulation