6:17 AM Wed Jan 25Question 26.b of 28A 8.65 g sample of an unknown salt (MM= 116.82 g/mol) is dissolved in 150.00 gwater in a coffee cup calorimeter. Beforeplacing the sample in the water, thetemperature of the salt and water is23.72 °C. After the salt has completelydissolved, the temperature of thesolution is 28.54 °C.What is the change in temperature, in °C,inside the calorimeter?Tap here or pull up for additional resources147+/-

Given: initial temperature of Salt and water= 23.72°C = T1 After complete dissolution of salt…

Answered: A 8.65 g sample of an unknown salt (MM…

Chemistry for Engineering Students

4th Edition

ISBN:9781337398909

Author:Lawrence S. Brown, Tom Holme

Publisher:Lawrence S. Brown, Tom Holme

Chapter9: Energy And Chemistry

Section: Chapter Questions

Problem 9.50PAE: 9.50 When a 13.0-g sample of NaOH(s) dissolves in 400.0 mL of water in a coffee cup calorimeter, the...

See similar textbooks

Similar questions

Ammonium nitrate is an oxidizing agent and can give rise to explosive mixtures. A mixture of 2.00 mol of powdered aluminum and 3.00 mol of ammonium nitrate crystals reacts exothermically yielding nitrogen gas, water vapor, and aluminum oxide. How many grams of the mixture are required to provide 245 kJ of heat? See Appendix C for data.
When 1.0 g of fructose, C6H12O6(s), a sugar commonly found in fruits, is burned in oxygen in a bomb calorimeter, the temperature of the calorimeter increases by 1.58 C. If the heat capacity of the calorimeter and its contents is 9.90 kJ/C, what is q for this combustion?
A student performing a calorimetry experiment combined 100.0 ml. of 0.50 M HCI and 100.0 ml. of 0.50 M NaOH in a StyrofoamTM cup calorimeter. Both solutions were initially at 20.0 C, but when the two were mixed, the temperature rose to 23.2 C (a) Suppose the experiment is repeated in the same calorimeter but this time using 200 mL of 0.50 M HCl and 200.0 ml of 0.50 M NaOH. WIII the AT observed be greater than, less than, or equal to that in the first experiment, and why? (b) Suppose that the experiment is repeated once again in the same calorimeter, this time using 100 mL of 1.00 M HCI and 100.0 ml. of 1.00 M NaOH. Will the T observed be greater than, less than, or equal to that in the first experiment, and why?
9.103 One reason why the energy density of a fuel is important is that to move a vehicle one must also move its unburned fuel. Octane is a major component of gasoline. It burns according to the reaction 2C8H18(l)+25O2(g)16CO2(g)+18H2O(g) H = 1.10104 kJ Starting from this thermochemical equation, describe how you would determine the energy density, in kJ/g, for octane. Be sure to indicate what you would need to calculate or look up to complete this problem.
A volume of 1.50 L of argon gas is confined in a cylinder with a movable piston under a constant pressure of 1.22 105 Pa. When 1.25 kJ of energy in the form of heat is transferred from the surroundings to the gas, the internal energy of the gas increases by 1.11 kJ. What is the final volume of argon gas in the cylinder?
9.38 The energy densities of various types of coal are listed below: Anthracite 35 kJ/g Subbituminous 31 kJ/g Bituminous 28 kJ/g Lignite 26 kJ/g An unknown sample of one of these coals is burned in an apparatus with a calorimeter constant of 1.3 kJ/°C. When a 0.367-g sample is used, the temperature change is 8.75°C. Which type of coal is the sample?
An industrial process for manufacturing sulfuric acid, H2SO4, uses hydrogen sulfide, H2S, from the purification of natural gas. In the first step of this process, the hydrogen sulfide is burned to obtain sulfur dioxide, SO2. 2H2S(g)+3O2(g)2H2O(l)+2SO2(g);H=1124kJ The density of sulfur dioxide at 25C and 1.00 atm is 2.62 g/L, and the molar heat capacity is 30.2 J/(mol C). (a) How much heat would be evolved in producing 1.00 L of SO2 at 25C and 1.00 atm? (b) Suppose heat from this reaction is used to heat 1.00 L of the SO2 from 25C to 500C for its use in the next step of the process. What percentage of the heat evolved is required for this?
Nitric acid, HNO3, can be prepared by the following sequence of reactions: 4NH3(g)+5O2(g)4NO(g)+6H2O(g)2NO(g)+O2(g)2NO2(g)3NO2(g)+H2O(l)2HNO3(l)+NO(g) How much heat is evolved when 1 mol of NH3(g) is converted to HNO3(l)? Assume standard states at 25 C.
9.63 Reactions of hydrocarhons are often studied in the petroleum industry. One example is 2C3H8(g)C6H6(l)+5H2(g) , with H = 698 kJ. If 35 L of propane at 25C and 0.97 atm is to be reacted, how much heat must he supplied?
9.91 You want to heat the air in your house with natural gas (CH4). Assume your house has 275 m2(ahout 2800 ft2) of floor area and that the ceilings are 2.50 m from the floors. The air in the house has a molar heat capacity of 29.1 J mol-l K-l. (The number of moles of air in the house may he found by assuming that the average molar mass of air is 28.9 g/mol and that the density of air at these temperatures is 1.22 g/L.) What mass of methane do you have to burn to heat the air from 15.0 to 22.0°C?
9.50 When a 13.0-g sample of NaOH(s) dissolves in 400.0 mL of water in a coffee cup calorimeter, the temperature of the water changes from 22.6°C to 30.7C Assuming that the specific heat capacity of the solution is the same as for water, calculate (a) the heat transfer from system to surroundings and (b) H for the reaction NaOH(s)Na+(aq)+OH(aq)
In earlier times, ethyl ether was commonly used as an anesthetic. It is, however, highly flammable. When five milliliters of ethyl ether, C4H10O(l)(d=0.714g/mL), are burned in a bomb calorimeter, the temperature rises from 23.5C to 39.7C. The calorimeter contains 1.200 kg of water and has a heat capacity of 5.32 kJ/C. (a) What is qH2o? (b) What is qcal? (c) What is q for the combustion of 5.00 mL of ethyl ether? (d) What is q for the combustion of one mole of ethyl ether?

SEE MORE QUESTIONS

Recommended textbooks for you

Chemistry for Engineering Students

Chemistry

ISBN:

9781337398909

Author:

Lawrence S. Brown, Tom Holme

Publisher:

Cengage Learning

General Chemistry - Standalone book (MindTap Cour…

Chemistry

ISBN:

9781305580343

Author:

Steven D. Gammon, Ebbing, Darrell Ebbing, Steven D., Darrell; Gammon, Darrell Ebbing; Steven D. Gammon, Darrell D.; Gammon, Ebbing; Steven D. Gammon; Darrell

Publisher:

Cengage Learning

Chemistry by OpenStax (2015-05-04)

Chemistry

ISBN:

9781938168390

Author:

Klaus Theopold, Richard H Langley, Paul Flowers, William R. Robinson, Mark Blaser

Publisher:

OpenStax

Chemistry for Engineering Students

Chemistry

ISBN:

9781337398909

Author:

Lawrence S. Brown, Tom Holme

Publisher:

Cengage Learning

General Chemistry - Standalone book (MindTap Cour…

Chemistry

ISBN:

9781305580343

Author:

Steven D. Gammon, Ebbing, Darrell Ebbing, Steven D., Darrell; Gammon, Darrell Ebbing; Steven D. Gammon, Darrell D.; Gammon, Ebbing; Steven D. Gammon; Darrell

Publisher:

Cengage Learning

Chemistry by OpenStax (2015-05-04)

Chemistry

ISBN:

9781938168390

Author:

Klaus Theopold, Richard H Langley, Paul Flowers, William R. Robinson, Mark Blaser

Publisher:

OpenStax

Chemistry for Engineering Students

Chemistry

ISBN:

9781285199023

Author:

Lawrence S. Brown, Tom Holme

Publisher:

Cengage Learning

Chemistry & Chemical Reactivity

Chemistry

ISBN:

9781133949640

Author:

John C. Kotz, Paul M. Treichel, John Townsend, David Treichel

Publisher:

Cengage Learning

Chemistry & Chemical Reactivity

Chemistry

ISBN:

9781337399074

Author:

John C. Kotz, Paul M. Treichel, John Townsend, David Treichel

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS