A ball of mass m₂ - 0.209 kg and velocity 1.511 m/s collides elastically with a ball of mass m₂ 0.305 kg and velocity -0.410 m/s. Assume the collision is head-on. (Express your answers in vector form. Due to the nature of this problem, do not use rounded intermediate values in your calculations including answers submitted in WebAssign.) (a) Find their velocities after the collision (in m/s). m/s m/s (b) Find the velocity of their center of mass before and after the collision (in m/s). m/s cm, after m/s

A ball of mass m₂ - 0.209 kg and velocity 1.511 m/s collides elastically with a ball of mass m₂ 0.305 kg and velocity -0.410 m/s. Assume the collision is head-on. (Express your answers in vector form. Due to the nature of this problem, do not use rounded intermediate values in your calculations including answers submitted in WebAssign.) (a) Find their velocities after the collision (in m/s). m/s m/s (b) Find the velocity of their center of mass before and after the collision (in m/s). m/s cm, after m/s

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

1. Assuming that there are no heat effects and no frictional effects,find the kinetic energy and speed of a 3220lb body after it falls 778 ft from rest. Start with the steady flow equation, deleting energy terms which are irrelevant. Draw a figure or FBD that will support the problem. Explain each step by step formula.
please I need an answer for this A water jet is deflected 180 degree in a curved vane with diameter of 25.5mm and velocity of jet of 6.5m/s. Determine the force that the jet exerts on the stationary vane Group of answer choices 234 23.4 43.2 34.2
The Texas Motor Speedway is an oval racing track with curves of radius 229 m that are banked at an angle of 24.0°. The size of the track allows for race cars to achieve speeds in excess of 400 km/h. An unintended consequence of the banked curves and high speeds is that race car drivers experience excessive G forces, especially in the "vertical" direction (with respect to their body position), causing dizziness and loss of consciousness. (a) A daring driver, pushing his car to the limit, experiences 3.52g of centripetal acceleration during one banking maneuver. What is the speed of his car during the maneuver? (Give your answer in km/h.) (b) If the driver is seated so that during the banking maneuver his upper body is aligned with the direction normal to the banked curve, what is the magnitude of the component of the centripetal acceleration along the driver's upper body? (Give your answer in terms of g.)
Please answer this NEATLY, COMPLETELY, and CORRECTLY for an UPVOTE. The wooden block (mass m = 0.5358 kg) is released from rest at A by a compressed spring (compressed length 0.6 m, undeformed length 1 m, spring constant k = 150 N/m). The block is allowed to slide through the rough horizontal surface (A to B), then along the smooth circular ramp (B to C, central angle θ = 47.2°, until the block is released after point C. Calculate the speed of the block at points B and C. Also, what is the magnitude of the normal force exerted to the block just before the block leaves the ramp? Neglect the geometry of the block. NOTE: Use Work-Energy Method to solve for the speeds; use Force-Mass-Acceleration (FMA) Method to compute for the normal force.
A particle of mass 133 kg is traveling on a constant radius 1.1 m with a angle of 0.23*sin(0.35t). 1. What is the transverse speed at 2.6 seconds? [m.s-1] 2. What is the radial force at 2.6 seconds? [N] 3. What is the transverse force on the particle at 2.6 seconds? [N
Assuming that there are no heat effects and no frictional effects, find the kinetic energy and speed of a 3220-lb body after it falls 778 ft from rest. Start with the steady flow equation, deleting energy terms which are irrelevant.Answer: 224 fps
..A crane is to raise a load of 25,000 N at an acceleration of 1 m/s2 through a 6 x 19 wire rope whose weight is 15,000 N. The diameter of the rope is 32 mm and the rope drum diameter is 960 mm. Take the Young’s modulus for the wire rope as 80 kN/mm2. Assume dw = 0.063 d. Which of the following is the bending load of the wire rope? Group of answer choices 61 kN 40 kN 4 kN 80 kN
Ballistic Pendulum To apply conservation of energy and momentum. As shown, an object of mass m is fired with an initial speed v0 at a ballistic pendulum’s bob. The bob has mass M and is suspended by a massless rod of length L. After the collision, the pendulum’s bob and object stick together and swing to a maximum angular displacement θ. Find an expression for v0, the initial speed of the object fired. Express your answer in terms of some or all of the variables m, M, L, and θ and g, the acceleration due to gravity.
A wheel tractor has a 200HP engine.If the weight of the wheel tractor is 30 tons and the weight on the drivingwheels is 50% of this weight, and it is operating at an altitute of 1000m above sea level, at an average temperature of 25 degree celcius, and at an average speed of 12km/hr. What is the maximum available rimpull if thecoefficient of traction is 0.25?. Take rimpull efficiency as 85%
What is the equation for the time of flight of a projectile? Is this equation dimensionally homogeneous?
A gun is on the same horizontal level as a target 484 meters away. A bullet is fired from the gun with a muzzle velocity of 154m/s. At what angle of elecation should the muzzle of the gun be set in order to ensure the bullet hits the target? Hint: You may use the formulas for the horixzontal x(t) and vertical y(t) displacement of the particle: x(t) = ucos(α)t, y(t) - usin(α)t - ½gt2 , g = 10m/sec2.
Students are given two spherical balls made of different materials, but of identical mass and diameter to experiment with. Each ball is dropped from an initial height, h0. The “sad ball” comes to rest without visibly bouncing when it strikes the tabletop. The “happy ball” bounces up to a final height h, where h< h0 A fellow student wants to use one of the balls in a carnival game where cups are knocked over by a thrown ball. Which ball should they use, happy or sad? Why?