A bar screen is inclined at 75 degree angle and with horizontal. The rectangular bars have dimensions of 10mm width * 50 mm depth and a clear spacing of 25mm. The velocity through the screen is 0.9 m/s and the total number of bars is 47 and that of clear spacing is 48. Determine the : I) velocity of wastewater in the approached channel in m/s ii) width of screen in m iii) head loss in m when the bars are clean

A bar screen is inclined at 75 degree angle and with horizontal. The rectangular bars have dimensions of 10mm width * 50 mm depth and a clear spacing of 25mm. The velocity through the screen is 0.9 m/s and the total number of bars is 47 and that of clear spacing is 48. Determine the : I) velocity of wastewater in the approached channel in m/s ii) width of screen in m iii) head loss in m when the bars are clean

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A submerged sharp crested weir 0.81 m high stands clear across a channel having vertical sides and width of 3.15 m. The depth of water in the channel of approach is 1.26 m, and 10.5 m downstream from the weir the depth of water is 0.93 m. Determine the discharge in litres per minute. Assume Cd1 = 0.58 and Cd2 = 0.80.
A swimming pool is 18m by 12m, 4m deep on one end and 1.5m on the other end. There are two drain pipes 200 mm in diameter located at the lower end of the pool. If C = 0.75, how long will it take to drain the full contents of the swimming pool?
Flow Speed in a Channel The speed of water flowing in achannel, such as a canal or river bed, is governed by theManning Equation,
This problem is useful for the preliminary design of a hydroturbine. From the material learned in this chapter, it is fairly simple to estimate how much power a hydroturbine can generate, given only the flow rate of water and the elevation difference upstream and downstream of the dam. A dam has a gross head of 15.5 m and a flow rate of 0.22 m3 /s. Approximating the overall efficiency of the turbine/generator to be 75%, estimate the electrical power (in kW) that couldbe produced.
which do you think would give a more accurate reading of the flow rate? thourougly justify.
find Step 1: Known, UnknownStep 2: SchematicStep 3: FormulaStep 4: CalculationsStep 5: Discussion A 30 cm diameter pipe, conveying water, branches into two pipes of diameters20 cm and 15 cmrespectively. If the average velocity in the 30 cm diameter pipe is 2.5 m/s, find the discharge inthis pipe (m3/s). Also determine the velocity (m/s) in 15 cm pipe if the average velocity in 20cm diameter pipe is 2 m/s.
The power of available at the stream flowing a 266 ft^3/s having a total head of 34 ft is a. 765.46 kW b. 456.34 hp c. 851. 11 kW d. 245.01 hp
At a potential hydroelectric site, the average gross head is 73m. It has 9m width and depth of 15m rectangular gate and average water velocity is 4.5 m/s. Assume a coefficient of discharge of 60.5%, leakage loss is 5% of the discharge load and the head utilized by the turbine blade is 60m. The loss in the turbine is equal to 3% of the gross head used. Determine: A. Mechanical Efficiency B. Electric Power Generated
For the conduction of the water there is a height difference of 38 m. The results obtained from the hydraulic calculation for three different diameters are shown in the following table Diameter, in. Total head loss, mca 8 56.5 12 37.2 16 29.1 What will be the available driving load? TRANSLATED FROM Para la conducción del agua se cuenta con un desnivel de cotas de 38 m. Los resultados obtenidos del cálculo hidráulico para tres diámetros diferentes son mostrados en la siguiente tabla: Diámetro, plgs. Pérdida de carga total, mca 8 56.5 12 37.2 16 29.1 ¿Cuál será la carga de conducción disponible?
What is the gross head (m) of a small hydroelectric dam that can produce 10 kW ofpower if the penstock discharge is 1,500 li/min?
Define Upstream and Down Stream.
Asnwer: VA = 1.219m/s