A bullet of mass 200 g is shot with ? = 100 ?/? toward a block of mass 2 kg that is placed on a frictionless table. The block is connected to rod of negligible mass and length 2 m, which is pinned at point P. The bullet, which is shot perpendicular to the rod, enters the block, and becomes embedded in it. The system then rotates about point P with angular speed ?. What is ?? Show your detailed work.

A bullet of mass 200 g is shot with ? = 100 ?/? toward a block of mass 2 kg that is placed on a frictionless table. The block is connected to rod of negligible mass and length 2 m, which is pinned at point P. The bullet, which is shot perpendicular to the rod, enters the block, and becomes embedded in it. The system then rotates about point P with angular speed ?. What is ?? Show your detailed work.

Glencoe Physics: Principles and Problems, Student Edition

1st Edition

ISBN:9780078807213

Author:Paul W. Zitzewitz

Publisher:Paul W. Zitzewitz

Chapter9: Momentum And Its Conservation

Section: Chapter Questions

Problem 6STP

See similar textbooks

Similar questions

Suppose the disk in Figure 1 below has a mass of 50.0 g and an initial velocity of 30.0 m/s when it strikes the stick that is 1.20 m long and 2.00 kg sticking at a distance 0.100 m from the pivot (where the board is nailed to the table). a. What is the angular velocity of the two after the collision? b. What is the kinetic energy before and after the collision? c. What is the total linear momentum before and after the collision?
Two thin frames are fixed with light bars with a mass, so that the center of the two frames applies. The moment of failure of the system around an axis that passes from the center and perpendicular to the page level is equal to: Choose and solve step
When you take your 1300-kg car out for a spin, you go arounda corner of radius 59 m with a speed of 16 m/s. The coefficient ofstatic friction between the car and the road is 0.88. Assuming yourcar doesn’t skid, what is the force exerted on it by static friction? Show your work and explain.
A system of three point particles of equal masses 45 gm are initially connected bythree rods of negligible mass to an axis of rotation perpendicular to the plane ofthe particles as shown in the figure-1. (a) If the massless rods are replaced by three rods of equal masses of 65 gm keepingtheir lengths unchanged, what is the moment of inertia of the system now?(b) If the systems rotate at 4.75 rev/s, what are the systems rotational kineticenergies?
A uniform 2-kg solid disk of radius R=0.4m is free to rotate on a frictionless horizontal axle through its center. The disk is initially at rest, and then a 10-g bullet traveling at 560 m/s is fired into it as shown in the figure below. Part A: If the bullet embeds itself in the disk at a vertical distance of 0.2 m above the axle, what will be the angular velocity of the disk? Express your answer in radians per second.
A horizontal 4.0 m long 5.0 N uniform bar at one end is attached to a wall by a frictionless hinge; and at the middle of the bar there is a vertical cable pulling down 7.0 N, and at the middle of the bar there is also a cable that is at 45 ° to the horizontal pulling up as shown. ii) What is the magnitude of the horizontal component of the force on the bar due to the hinge?
A non-uniform rod of mass M, length L and linear mass density λ = 2x2 is at a rotational equilibrium, shown in the figure*. On the left, mass m1 is hanging from a distance r1 from the wedge. Additionally, r2 denotes the distance between the center of the mass of the rod and the wedge. Derive an algebraic representation for r2 ONLY as a function of M, L, and m1 showing the steps to get there. Hint: first, find Xcm and then find 2 relationships between r1 and r2 *Note: figure is not drawn to scale.
A solid sphere of mass, M = 5.0 kg, and radius, R = 0.100 m is placed on two blocks so that it’s centre of mass lies at the origin as shown on the right. A bullet of mass, m = 0.100 kg, and with an x coordinate of b = 0.04 m strikes the sphere from below with a vertical velocity, v = 65 m/s and embeds in the sphere coming to rest at the location (-b,0) in the diagram below. Since there is no momentum in the horizontal direction, after the bullet hits the sphere , it will rise up to some maximum height and then fall back to its initial position on the two blocks. While the sphere is in the air it will rotate. What is the magnitude of the angle (in degrees) through which the sphere will rotate before it makes contact with the two blocks again?
How many forces provide the counterclockwise torque in the first part of the experiment? P.s. I had this question answered but I was confused on what the actually answer is. Is there only one force or three forces providing the couterclockwise torque? Please clarify more.
Calculate the torque (magnitude and direction) about point OO due to the force F⃗ F→ in each of the situations sketched in the figure below (Figure 1). In each case, the force F⃗ F→ and the rod both lie in the plane of the page, the rod has length 6.00 mm, and the force has magnitude 4.00 NN. Let counterclockwise torques be positive. A) Case (a): B)Case (b): C)Case (c): D)Case (d): E)Case (e): F)Case (f):
A car starts from rest and in 75 seconds it travels 1 mile. The wheels of the car have a diameter of 30 inches. Show all work and any unit conversions step by step. a) How many revolutions did the wheel make in that 1 mile distance?b) What was the final linear velocity of the car after the 75 seconds in units of feet per second?c) What was the final angular velocity of a point on the outer edge of the wheels in units of rpm?
Consider a bar, of length 5.5 m, shown in the figure, being acted on by three forces. The magnitudes of the first two forces are 23 N and 28 N, and the first force is acting on the end of the bar at an angle of 54° as shown. a)What is the torque, in newton-meters, due to F1 on this bar relative to the left end? Use a coordinate system with positive directed out of the screen. b)What is the torque, in newton-meters, due to F2 on this bar relative to the left end, if this force is acting at the midpoint of the bar? Use a coordinate system with positive directed out of the screen. c)What is the magnitude of the force F3, in newtons, if the force is a distance 0.65 m from the left end and the bar is not rotating?