a) Calculate the volume in ft' of one Ib-mole of air (MW = 29 lbm/lb-mole) at a temperature of 492 R at a pressure of 1 atm (absolute). b) Repeat the calculation of a) but now considering 1 Ib-mole of CO2 (MW= 44 lbm/lb-mole). c) Calculate the molar volume (V) of this mole of air in ft'/lb-mole. d) Calculate the density (p) of air in Ibm/ft under these conditions e) Calculate the density (p) of CO, in Ibm/ft under these conditions

a) Calculate the volume in ft' of one Ib-mole of air (MW = 29 lbm/lb-mole) at a temperature of 492 R at a pressure of 1 atm (absolute). b) Repeat the calculation of a) but now considering 1 Ib-mole of CO2 (MW= 44 lbm/lb-mole). c) Calculate the molar volume (V) of this mole of air in ft'/lb-mole. d) Calculate the density (p) of air in Ibm/ft under these conditions e) Calculate the density (p) of CO, in Ibm/ft under these conditions

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

Show solution : if 12m³ of nitrogen at constant temp of 30°c and 12kpa abs is permitted to expand to 30m³, what is the resulting pressure? Ans. 50 kpa
A mixture of methane and air is capable of being ignited only if the mole percent of methane is between 5% and 15%. A mixture containing 9.0 mole% methane in air flowing at a rate of 7:00 x 102 kg/h is to be diluted with pure air to reduce the methane concentration to the lower flammability limit. Calculate the required flow rate of air in mol/h and the percent by mass of oxygen in the product gas. (Note: Air may be taken to consist of 21 mole% O2 and 79% N2 and to have an average molecular weight of 29.0.)
A fuel contains 78wt% carbon and 22wt% hydrogen (H). Combustion results in the following composition by volume (dry basis): CO2 : 9.41 CO : 1.69 O2 : 3.8 N2: 85.1 The following equations describe the chemical reactions taking place: CO+0.5 O2→ CO2 C+O2→ CO2 H2 + 0.5 O2 → H2O C+0.5O2→ CO On the basis of 120 lb moles of dry flue gas, the O2 required (lb moles) for complete combustion is most nearly. Find the amount of O2 needed for the completion of combustion
stack gas analysis: 83.08% N2, 7.5% CO2, 2.3% CO, 1.12% H2, 6% O2 with a saturation temperature of 54°C at 400°C and 760mmHg. a) %excess of air (1000 m^3 of air is supplied, produced 3100 m^3 of stack gas) b) chemical formula of the fuel burned c) analysis of the fuel mixture
Calculate the partial pressure in atm of each gas in a mixture of gases. In a tank containing 16.00 grams of carbon dioxide, 26.50 g of nitrogen gas, and 8.00 grams oxygen gas for a total pressure of 80.0 kPa. Conversion: 1 atm = 101.325 kPa; MW(CO2) = 44.01 g/mol;MW(N2) = 28.0 g/mol; and MW(O2) = 32.0 g/mol. The pCO2, pN2, and pO2 in atm are .........., ............, and .............., respectively in 3 sig. figures.
23 ft^3 of air was drawn from a ventilation duct and measured by means of a dry gas meter. the meter's temperature averaged 60 F and the meter gage pressure was -1.9" H2O. Barometric pressure during the sampling was 752 mm Hg. Calculate the volume in standard cubic feet and in standard cubic meter (25C, atm) this is an ideal gas problem
A 25L bag was filled with air, a 10uL sample was then injected into the bag to make 50ppmv vapor sample. Can you explain how you get to the 50ppmv?
(a) Water in vadose zone contains chlorobenzene of concentration 40 mg/L. What is the equilibrium concentration soil air in contact with this solution? (b) An aquifer with porosity 0.3 has distribution coefficient of TCE as 100 L/kg. What fraction of TCE is in aqueous phase and sorbed phase of the soil?
A 0.064 kg of octane vapor (MW = 114) is mixed with 0.91 kg of air ( MW = 29 ) in the manifold is 86.1 kPa, and the temperature is 290 K. Assume octane behaves ideally, what is the total volume of this mixture. Show unit analysis and conversion on solution. Round off to four decimal places.
Cereal is being dried in a vertical drier by air flowing countercurrent to the cereal. To prevent breakage of the cereal flakes, some of the exit air from the drier is recycled back to mix with the the moist fresh air. For each 1000 kg/hr of wet cereal fed to the drier, calculate the input of moist fresh air in kg/hr and recycle rate in kg/hr. The available data on stream compositions is (fractions): For water: Fresh air: 0.0132 Wet cereal: 0.200 Exit air: 0.263 Dried Cereal: 0.050 Air entering Dryer: 0.066
One mol of a gas is contained in a piston-cylinder device at 100 kPa. The piston rests at 10cm from the base of cylinder. Force is applied to the piston causing the pressure in the cylinder increases at 200kPA. What should be the restong position of the piston from the base of the cylinder? Assume the following temperature is held constant at 300K, throughout the experiment, gas is ideal, piston has negligble mass, is frictionless and airtight. a.5cm b.8cm c.20cm d.1cm How many grams of water vapor can be stored in a 71.9-mL rigid vessel held at a pressure of 10.4 atm and temperature of 465C? a. 0.421 b. 0.222 c. 0.129 d. 22.4 e. 0.183
The combustion gases from an industrial furnace using a hydrocarbon fuel and dry air enter the stack gas at normal barometric pressure and 3750F and have the following Orsat analysis: 12.2% CO2, 3.1% O2, 1.2% CO, and 83.5% N2. Determine the following: (a) The percent excess air (b) The volume of gases entering the stack, expressed as cubic feet per pound of carbon burnt in the furnace (c) The dew point of the stack gas (d) The atomic ratio of hydrogen to carbon in the fuel (e) The mol of stack gas per atom of carbon burnt