A calibration curve for the determination of aspirin is constructed from known concentration aspirin solutions, mg/mL, and the HPLC peak area's for each standard. If the equation is y = 12.565x - 0.71, %3D what is the concentration for an unknown that has a peak area of 195.2? 6.7 O 15.5 O 8.9 O 14.1 O 17.7

A calibration curve for the determination of aspirin is constructed from known concentration aspirin solutions, mg/mL, and the HPLC peak area's for each standard. If the equation is y = 12.565x - 0.71, %3D what is the concentration for an unknown that has a peak area of 195.2? 6.7 O 15.5 O 8.9 O 14.1 O 17.7

Chemistry

9th Edition

ISBN:9781133611097

Author:Steven S. Zumdahl

Publisher:Steven S. Zumdahl

Chapter11: Properties Of Solutions

Section: Chapter Questions

Problem 109AE: Patients undergoing an upper gastrointestinal tract laboratory test are typically given an X-ray...

See similar textbooks

Similar questions

Patients undergoing an upper gastrointestinal tract laboratory test are typically given an X-ray contrast agent that aids with the radiologic imaging of the anatomy. One such contrast agent is sodium diatrizoate, a nonvolatile water-soluble compound. A 0.378-m solution is prepared by dissolving 38.4 g sodium diatrizoate (NaDTZ) in.l.60 102 mL water at 3 1.2C (the density of water at 31.2C is 0.995 g/cm3). What is the molar mass of sodium diatrizoate? What is the vapor pressure of this solution if the vapor pressure of pure water at 31.2C is 34.1 torr?
Based on the following molarities obtained,1.00 x10^-1 , 1.04 x10^-1 and 1.0 2x10^-1. fine the average molarity and standard deviation.
An analysis of city drinking water for total hardness was done by two students in the laboratory and produced the following results (in ppm CaCO3): Student A: 228.3, 226.4, 226.9, 227.1, and 228.6. Student B: 229.5, 226.1, 230.7, 223.8, and 227.5 what is the coefficient variation?
The first goal is to make the oxalic acid standard solution. You measure 1.5232 g of oxalic acid on an analytical balance, add it to a 250-mL volumetric flask and add deionized H2O to a final volume of 250.0 mL. Molar mass of H2C2O4•2H2O = 126.07 g/mol Mass of H2C2O4•2H2O = 1.5232g Volume of H2C2O4•2H2O solution = 250.0mL What is the Molarity H2C2O4 standard solution ?
SCE students measured the concentration of HCl in a solution by titrating with different indicators to find the end point.Indicator Mean HCl concentration (M)(± standard deviation)Number of measurementsBromothymol blue 0.09565 ± 0.00225 28Methyl red 0.08686 ± 0.00098 18Bromocresol green 0.08641 ± 0.00113 29Is the difference between indicators 1 and 2 significant at the 95% confidence level? Answer the same question for indicators 2 and 3
A STOCK SOLUTION containing 0.1581 g/L K2CrO4 was prepared.In order to make the CALIBRATION STANDARD, 5 ml of the STOCK was transferredinto a 50ml volumetric flask and then diluted with an appropriate solvent.Calculate:(a) The ppm of K2CrO4 in the CALIBRATION STANDARD.(b) The molarity of K2CrO4 in the CALIBRATION STANDARD. (c) Calculate the molar absorptivity of K2CrO4 (at 371.0 nm). Assume that Beer's Law isobeyed over this concentration range.At 371.0 nm, this CALIBRATION STANDARD in a cell of path length 1.00 cm gave a %T of 59.752.
1. A 1.2-gram sample of lanolin was treated with Wij’s solution and excess potassium iodide solution. The liberated iodine reacted with 30 ml of 0.1 N sodium thiosulfate solution. If the iodine value was determined as 12.69, what is the volume used in blank titration? 2. A fat sample with combination of acids contain standard hydrochloric acid for blank and sample with 8mL and 5mL respectively. The normality of the standard hydrochloric acid is 0.93N and the weight of the sample is 3 grams. Calculate the saponification value. 3. A 3.50-gram sample of Streptomycin powder was tested for its water content. If the water equivalence factor of the KF reagent was 4.6, what is the percentage water content of the sample if 9.2 ml of the KF reagent was used? 4. A 500mg oil sample is taken from a conical flask and is dissolved in 50mL distilled alcohol. An indicator is added and is then titrated against 0.112N KOH until a slight pink color appears. It took 17.6mL of the titrant to reach the…
A chemist receive different mixtures for analysis with the statement that it contain NaOH, NaHCO3 , Na2CO3 or compatible mixtures of these substances together with the inert material. From the data given, identify the respective materials and calculate the percentage of each component. 1.000g samples and 0.2500 N HCl were used in all cases. Sample 1 With phenolphthalein as the indicator, 24.32 ml of HCl was used. A duplicate sample required 48.64 ml HCl using methyl orange as the indicator. Sample 2. With phenolphthalein as the indicator it uses 28.2 ml of HCl to make it colorless and added with methyl orange indicator and uses 11.3 ml of HCl to reach the end point.
30.0 mL of 0.400 M Zn²⁺ is mixed with 100.0 mL of 0.200 M F⁻ (Ksp ZnF₂ = 0.030). In the mixture you would observe
In the conductivity test, _____________________ is going to result to a brightly lit light bulb. a. 70% v/v ethanol b. 1.0 M citric acid c. Mixture of 10.0 mL 1.0 M Mg(OH)2 and 10.0 mL 1.0 M HNO3 d. Glacial acetic acid
Calculate [ I- ] given the following information: In a test tube, 2.0 mL 0.060 M KI solution 4.0 mL Distilled H2O 2.0 mL 2.0 mM Na2S2O3 solution 2.0 mL 0.040 M H2O2 solution Total solution volume: 10 mL
The separation and purification processes given below and the method used against them are given. Which or which of these pairings are correct? Brewing the tea - Extraction Purification of water from impurities-Chromatography Separating olive pomace from oil while olive oil is being produced - Decantation Obtaining oil fractions - Ordinary distillation Obtaining essential oils and using them in perfume making - Water-steam distillation A. I, IV, V B. I, II, III, IV, V C. I, II, V D. I, II, III, V E. I, II, III, IV