a capacitor has the capacitance of 20uf and a phase diff of 10 degrees it is inserted in series with 100 ohm resistor across 220v 50hz line find the increase in resistance due to insertion id capacitor

a capacitor has the capacitance of 20uf and a phase diff of 10 degrees it is inserted in series with 100 ohm resistor across 220v 50hz line find the increase in resistance due to insertion id capacitor

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter8: Basic Electric Motors

Section: Chapter Questions

Problem 34RQ: Which of the following is the capacitance of an 88-microfarad and a 108-microfarad starting...

See similar textbooks

Related questions

Q: A rectangular waveguide has a dimension of 3cm by 2 cm is used to transmit a signal of 8 GHz. Determ...

A: Given: Rectangular wave-guide used in dominant mode. The dimensions are, a=3 cm and b=2 cm Frequency...

Q: For the zener regulator shown above, Vo = 12V, R, = 12, R, = 1092. Calculate the zener current 1,, l...

A: “Since you have asked multiple question, we will solve the first question for you. If you want any s...

Q: What is the expected value of the square of the number of bits in error? (Use 4 decimal places) * X ...

Q: Please analyze the circuit below Identify the errors in the circuit, explain why they are wrong and ...

A: The circuit is given as

Q: Find the values of VA, VB, Vo in the circuit, also determine I, I1, I2, load voltage, and load power...

A: We will find out the current and voltage for given circuit

Q: Consider the following system: F k1 Construct the transfer function X(s)/F(s) and state space model ...

Q: this problem, t = 0+ means just after t = 0. Find the values of the following quantities: (Remember...

Q: 7.21 Ignoring reflection at the air-soil boundary, if the amplitude of a 3 GHz incident wave is 10 V...

A: Since you have asked multiple question ,we will slove the first question for you .If you want any sp...

Q: Show how a five bit 11011 binary number can illustrated in the five-bit serial in –parallel out shif...

Q: 3. Determine the value of R for the circuit of Fig. 153 that will result in a diode current of 10 mA...

Q: angular waveguide has a dimension of 3cm by 2 cm is used

Q: Explain how a rotating magnetic field is produced when a three phase supply is connected across the ...

Q: For a frequency of 200 Hz, the time period will be O a. 0.005 sec O b. 0.5 sec O c. 0.05 sec O d. 0....

A: Given, Frequency, f = 200 Hz

Q: 5. Vo and In 1.2KQ Si IR BoVo +12 V o– 2.4ΚΩ -5V

Q: Find the phasor of the total current IT of the parallel R, L, C circuit shown below. The source volt...

A: In this question we will find total current in parallel RLC circuit....

Q: Stuck on your D6.1. Find the relative permittivity of the dielectric material present in a parallel-...

A: We need to find relative permittivity for given parallel plate capacitor .

Q: 8(b) Sketch the polar plot for 32 G(s) = (s+4)(s + 4s +8) and find its points of intersection with t...

Q: Assuming an ideal diode, sketch vi vd,h and id for the half-wave rectifier of Fig. 2.163. The input ...

Q: 12/0* v 10 10 ww 10 2/0 A A

A: We are authorized to answer one question at a time, since you have not mentioned which question you ...

Q: Explain the importance of cascaded IF amplifiers in a superheterodyne receiver.

A: Superheterodyne receiver- A superheterodyne receiver mixes its input with a higher or lower frequenc...

Q: Three voltage amplifiers are cascaded with gains(ratios) A1, A2 and A3. The gain of the second stage...

A: Consider the overall gain G in the cascaded connection is the product of gain of each of the stage. ...

Q: Explain in broad the theory about Common Emitter Amplifier

A: A common emitter amplifier is the type of BJT configuration in which there are three terminal that a...

Q: 3. Find the following in the circuit below; a. Total Resistance b. Total Current c. Total Power d. C...

Q: Based on your own understanding, differentiate the five (5) types of Magnetic Motor Starter in a min...

A: There are five main types of magnetic motor starters that are used based on the requirements of the...

Q: Q1) For the circuit shown in Figure 1 L=10 mH R=100 0 C=100 µF i. Calculate i(t) if the frequency va...

A: RLC circuit A Resistor, capacitor, and inductor are connected in series between an alternating supp...

Q: IV-. From the circuit of common source JFET amplifier shown in the figure, its has VGs(off) = -2.0V,...

A: We need to find resistance value for given drain current and voltage gain for given circuit

Q: 7-2 A function generator can be angle modulated with various waveforms. Based on a 50-Hz sinusoid be...

A: Modulation- Changing some parameter of the carrier signal with respect to the modulating signal is k...

Q: 3. A 30 ohm resistor is connected in parallel with a 0.106 henry inductor. The parallel combination ...

A: The solution is given below

Q: 2. Consider an input x[n] and a unit impulse response h[n] given by x[n] = )"-2 u[n – 2] h[n]= u [n+...

A: This question belongs to signal and system . It is based on the concept of z transform of the system...

Q: 1. Use Kirchhoff's Laws to find the branch curents indicated in the following networks: 2420'v a 50 ...

Q: Create a circuit diagram of a 1st order bandpass filter that can filter out frequencies of below 300...

Q: Find the mnemonic and the operand of the following machine code (shown as hexadecimal numbers) BE EF

A: Machine code is an important language to understand the computer. It is processed by a Central proce...

Q: Find the probability that, in the next 18 samples, exactly 2 contain the pollutant. (Use 4 significa...

Q: Question 1. Answer the following questions. a. Fill in the state table for the T flip-flop. T Q(t+1)...

Q: A 105-MHz carrier is to be frequency modulated by a 3-kHz tone. The maximum frequency deviation is t...

A: Given, Carrier frequency, fc=105 MHz Modulated frequency, fm=3 kHz Maximum frequency deviation is ad...

Q: Describe two methods of controlling voltage in a power system.

A: You have asked multiple independent questions. We are authorized to answer one question at a time. S...

Q: Find the current i for all t.

Q: Question Three Using block diagram reduction technique find closed loop transfer function C(s) / R(s...

Q: Find the derivatives f'(z) for the given function f(2) = 5z* – iz? + (8 – i)z² – 6i

Q: 15. A solenoid coil with a resistance of 50 ohms and an inductance of 250mH is connected to a 220Vpk...

Q: A 6 pole induction motor is supplied from a 400 V, three phase, 50 Hz supply system. The frequency o...

Q: The impedance seen from the relay side in a distance relay is 10 ohms. Given that the CT ratio is 10...

A: Given: CT ratio is 1000 : 1 PT ratio is 100,000 : 110 Line has a resistance of 1 milliohm per km and...

Q: List twenty farming operations requiring electrical power. Discuss the advantages and disadvantages ...

A: Electricity- Flow of electrons from region of high concentration (aka high potential or high voltage...

Q: Design a BCD to Excess -3 code converter

A: The solution is given below

Q: Find the inverse Laplace transform of the following: s+3 F(s) %3D (s + 1)(s+2)

A: The solution is given below

Q: takes 30 A at 200 V the power input being 1,500 W. On open circuit, both transformers give a seconda...

Q: X2(s) X1(s) and F2 (s) F1 (s) Q2. Obtain the transfer functions for the system shown below. F2(1) X2...

A: Given Mechanical system shown

Q: 10 FOIS For the electrical network system below, find the transfer function VV. Use the following va...

A: The solution is given below

Q: +15V R4 560 Q R1 1ka R3 9100 VZR: 3V R2 3 2ka - 8V

A: The solution is given below.

Q: 1. Sketch the following CT functions: (a) g(t) = 2u(4-t) (d) x(t) = 68(31 +9) (e) y(t) = 5 sine(t /2...

A: We are authorized to answer one question at a time, since you have not mentioned which question you ...

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

a capacitor has the capacitance of
20uf and a phase diff of 10 degrees
it is inserted in series with 100 ohm
resistor across 220v 50hz line find the
increase in resistance due to insertion
id capacitor

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
An AC circuit contains a 24 resistor, a 15.9-mH inductor, and a 13.3F capacitor connected in parallel. The circuit is connected to a 240-V, 400-Hz power supply. Find the following values. XL=XC=IR=AIL=AIC=AP=WVARsL=VARsC=IT=AVA=PF=%=
Two capacitors having values of 80 F and 60 F are connected in series. What is the total capacitance?
Three capacitors having values of 2.2 F, 280 F, and 470 pF are connected in parallel. What is the total capacitance?
Assume that the voltage drop across the resistor, ER, is 78 V; the voltage drop across the capacitor, EC, is 104 V; and the circuit has a total impedance, Z, of 20 . The frequency of the AC voltage is 60 Hz. Find the missing values. ET ER78V EC104V IT IR IC Z20 R XC VA P VARSC PF C
A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
given circuit is balanced. find value of capacitance C1. thanks.
In a RC charging circuit, given R = 150 Kohm, Supply voltage = 15 V and voltage across the capacitor is 5.6 V after time t = 12 ms. Find the value of the capacitor used.
Find out the complex admittance of a resistor of 50 ohm in parallel with a capacitor of capacitance 20 micro Farad. The frequency of the input ac is 50 Hz.
A 15uF capacitor in parallel with a coil of 20Ω and 10mH is connected in series with a parallel connection of 12mH inductor and 20Ω resistor. If this series-parallel combination is then connected to in series with a 20-Ω resistor, what will be the total impedance at 50 Hz?
An inductive coil of resistance 15 ohms and inductance 0.2H is connected in parallel with a 100 micro farad capacitor to a variable frequency supply. Find the frequency at which the total current taken is in phase with the supply voltage. What is this value of this current if the voltage is 200v. Draw a phase diagram
(Basic Electrical Engineering) A series circuit consisting of a resistor, 0.05 H inductor and a 100-microfarad capacitor is connected across a 100V, 60Hz. Determine the value of the resistor if the phase angle is 80 degrees. Show complete solution and limit your answer into three decimal places.