A car of mass 4540 kg is travelling over a hill with a radius of curvature of 13.9 m, at a speed of 8.5 m/s. What is the magnitude of the normal force acting on the car when the car is at the very top of the hill?

A car of mass 4540 kg is travelling over a hill with a radius of curvature of 13.9 m, at a speed of 8.5 m/s. What is the magnitude of the normal force acting on the car when the car is at the very top of the hill?

Principles of Physics: A Calculus-Based Text

5th Edition

ISBN:9781133104261

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter5: More Applications Of Newton’s Laws

Section: Chapter Questions

Problem 4OQ: An office door is given a sharp push and swings open against a pneumatic device that slows the door...

See similar textbooks

Related questions

Q: Does the value of gravity depend on the mass of the pendulum?

A: The value of g does not depend on the mass of the pendulum. The formula of gravity is g=GM/r^2.…

Q: A ball is thrown upwards vertically from the ground with an initial velocity of 40 m/s. Draw the…

Q: An ambulance with a siren emitting a whine at 1590 Hz overtakes and passes a cyclist pedaling a bike…

Q: Og of Water is heated from 0°C to 100 °C, and (c) 100 g of water is vaporized at 100 °C? Use the…

Q: Three charges are arranged on x-axis : q2 = + 4 uC is at x=0, q1 = -3 uC is at x=0.2 m, and q3= + 7…

Q: A tube 1.10 m long is closed at one end. A stretched wire is placed near the open end. The wire is…

A: Given data: Length of tube, L=1.10 m Length of wire, l=0.329 m Mass of wire, m=9.50 kg Speed of…

Q: A soccer player kicks a ball at initial velocity of 18m/s at an angle of 3aº to the horizontal. Find…

A: Given Initial velocity of ball = 18 m/s angle of projection with horizontal= 30° We have to…

Q: How far up a 30-degree ramp will a bowling ball with diameter of 9 inches and a mass of 10lbs go if…

A: Given:- The mass of the ball is m = 10 lbs The radius of the ball is r = 9 inches The angle of…

Q: Find the mechanical energy of a block-spring system having a spring constant of 2.3 N/cm and an…

A: We have a block spring system having spring constant k=2.3 N/cm=230 N/m and an oscillation amplitude…

Q: Which of the following scenarios show an increase in the electric potential energy? A negative…

Q: 17) Two very small +3.00-μC charges are at the ends of a meter stick. Find the electric potential…

A: In above figure two very small +3.0μc charges are at the end of meter stick (A and B). The electric…

Q: 10 ΚΩ | bo 1 ΚΩ Μ 2 ΚΩ 5 ΚΩ 5 ΚΩ www 3 ΚΩ • 1.5 ΚΩ

Q: A uranium ion and an iron ion are separated by a distance of R = 56.50 nm, as shown in the figure.…

A: Given:- r= distance between uranium and electron = 23.4 nm = 23.4×10-9 m

Q: 5. A 1.0-2 resistor is connected across a battery having an emf of 6 v. If the resistor has to…

Q: A wave has a speed of 650 m/s and a wavelength of 5.8 m. What are the (a) frequency and (b) period…

A: Given: Speed of wave v=650 m/s, Wavelength of wave λ=5.8 m. Required: (a) Frequency of the wave f,…

Q: PROBLEM 3: A 10 kg sphere is moving to the right at a speed of 10 m/s collided with a 5 kg sphere…

A: Given:- Two spheres of mass m1 = 10 kg and m2= 5 kg the speed of the sphere of mass m1 is u1= 10…

Q: An aluminum-alloy rod has a length of 6.4955 cm at 10.00°C and a length of 6.5356 cm at the boiling…

A: (a) Given: Length at T0=10°C is L0=6.4955 cm, Length at T=100°C(boiling point of water) is L=6.5356…

Q: Briefly explain the main characteristics of a perfectly inelastic collision.

A: Given that- In elastic collision To determine that Briefly explain the main characteristics of a…

Q: Two objects, a sphere and a block of the same mass, are released from rest at the top of an inclined…

A: The correct answer is option D The block, because it does not gain rotational kinetic energy, but…

Q: Photoelectric effect: What is it and how does it work?

A: Dear student When radiations of suitable wavelength or frequency are incident on metal surface,…

Q: A particle moves that is defined by the parametric equations x = 3t² - 1 y = t³ - 3t² +t-3 (where x…

Q: What does the stress in a composite beam depend on? O the modulus of elasticity of both materials…

A: The stress in a composite beam is given by where I1 and I2 are the moments of inertia about the…

Q: I'm confused as to why the angle changes to 60 deg. Why wouldn't the angle be 30deg?

Q: Is there a use for the photoelectric effect in the real world?

A: Photoelectric effect is a phenomenon in which electrically charged particles are released from or…

Q: Points A, B and C are at various distances from a given point charge. Which statement is most…

A: Given data: A positive charge There points A, B and C are at verious distances from the point…

Q: Q16: A) What do you understand by Gibbs phase rule, and explain in detail each term used in the…

A: The given question is about the Gibb's phase rule and the Engineering and True strain, explain all…

Q: Which of the following diagrams are NOT correct? (Check all that apply) Diagram A Diagram B Diagram…

A: Let's check each option one by one. Diagram A. This diagram is correct. Electric field from the…

Q: A particle moves that is defined by the parametric equations x = 3t² - 1 y = t³ − 3t² + t = 3 (where…

A: The position of the particle as a function of time in the x-direction is given by, x=3t2-1 The…

Q: On a string with a fixed tension and a fixed free string length, as the driver frequency is…

Q: Briefly explain the main characteristics of a perfectly inelastic collision.

A: We have to briefly explain the main characteristics of perfectly inelastic collision.

Q: Calculating the Work You Do to Push a Lawn Mower Across a Large Lawn How much work is done on the…

Q: A parallel plate capacitor is constructed with plates of areas 0.038 m² and separation 0.6 mm. (a)…

A: Given data: Area of the parallel plates, A=0.038 m2 Separation between the plates, d=0.6…

Q: A car is running at 45ft/s when it passes by a gasoline station. 2 seconds after, another car leaves…

A: Given car 1 - velocity V1 = 45ft/s at time t=0 At time t =2 seconds Another car leaves the gas…

Q: What equation is almost similar to the electric potential energy? electric potential…

A: Introduction: The electric potential energy of the charged particle is equal to work done on the…

Q: A stretched string has a mass per unit length of 4.53 g/cm and a tension of 28.4 N. A sinusoidal…

Q: From the table below, find the resultant (magnitude and direction) of J and D. A = 15 at 270°…

Q: A roller coaster of mass 2420 kg is rolling down a track with an instantaneous speed 10 m/s. What is…

A: Given data, Velocity = v Mass = m To find , Kinetic energy

Q: A 71.9 Kg mass is placed on an incline plane that is 38 degrees from the horizontal. a) Assuming…

A: Given Information:- Mass is m=71.9 kg Angle of inclination of the incline plane is θ=38° Length of…

Q: In the figure below, each capacitor has capacitance of 6.75 µF and Vab= +23V. C₁ C₂ C₂ C₂ (a)…

Q: Which of the following statements concerning the pairs of charges below are correct? YUZ a b C d B)…

Q: A bicycle starts to move from rest. If in 5 seconds it reaches to velocity of 30m/s, find its…

A: Given data, Final velocity = v Initial velocity = u Time Taken = t To…

Q: Compare and contrast the differences between parallel and series circuits (Standard SPS10 b)

Q: About 29% of the body of a person floating in the Dead Sea will be above the water line. Assuming…

Q: Suppose we want to calculate the moment of inertia of a 68.5 kg skater, relative to a vertical axis…

Q: Q16: A) What do you understand by Gibbs phase rule, and explain in detail each term used in the…

A: Note: As per the guidelines, we can only answer first question of multiple question. Sorry for the…

Q: An object hangs from a spring balance. The balance registers 32 N in air, 22 N when this object is…

Q: Given a SHM equation, x(t) = 5 cos 3.15π t , where x in meter and t in second, calculate: The…

Q: Suppose you are observing a light wave traveling down a thin transparent fiber. Let A = 5V/m; let λ…

Q: An unstrained horizontal spring has a length of 0.38 m and a spring constant of 300 N/m. Two small…

A: In this problem we can observe that, the electrostatic force at both ends keeps on stretches the…

Q: Why forces are generated for parts of the loop (actually rectangle in Fig 20-37) and not for other…

Concept explainers

Centripetal Force

A particle, body, object or certain mass while travelling in a rotational path or semicircular path, experiences an inertia force. If that inertia force pulls the towards the inward of the imaginary circle in the rotation, it is termed as centripetal force.

Question

Please help me with this question below. Show all work and make sure their are appropriate units

A car of mass 4540 kg is travelling over a hill with a radius of curvature of 13.9 m, at
a speed of 8.5 m/s. What is the magnitude of the normal force acting on the car
when the car is at the very top of the hill?
IS

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Writing the given data

VIEW

Step 2: Finding the magnitude of the normal force

VIEW

Step 3: Conclusion

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

A single bead can slide with negligible friction on a stiff wire that has been bent into a circular loop of radius 15.0 cm as shown in Figure P5.59. The circle is always in a vertical plane and rotates steadily about its vertical diameter with a period of 0.450 s. The position of the bead is described by the angle θ that the radial line, from the center of the loop to the bead, makes with the vertical. (a) At what angle up from the bottom of the circle can the bead stay motionless relative to the turning circle? (b) What If ? Repeat the problem, this time taking the period of the circle’s rotation as 0.850 s. (c) Describe how the solution to part (b) is different from the solution to part (a). (d) For any period or loop size, is there always an angle at which the bead can stand still relative to the loop? (e) Are there ever more than two angles? Arnold Arons suggested the idea for this problem. Figure P5.59
An office door is given a sharp push and swings open against a pneumatic device that slows the door down and then reverses its motion. At the moment the door is open the widest, (a) does the doorknob have a centripetal acceleration? (b) Does it have a tangential acceleration?
A car drives straight down toward the bottom of a valley and up the other side on a road whose bottom has a radius of curvature of 135 m. At the very bottom, the normal force on the driver is twice his weight. - At what speed was the car traveling?
You’re driving your new sports car at 75 mph over the top of a hill that has a radius of curvature of 525 m. What fraction of your normal weight is your apparent weight as you crest the hill?
A car with a mass of 1000kg travels around a banked curve of radius 40m with a speed of 27m/s. In the absence of friction, what are the values of the horizontal and vertical components of the normal force?
A small car with mass 0.650 kg travels at constant speed on the inside of a track that is a vertical circle with radius 5.00 m. Q: If the normal force exerted by the track on the car when it is at the top of the track (point B) is 6.00 N, what is the normal force on the car when it is at the bottom of the track (point A)?
A 6400-pound vehicle is driven at a speed of 35 miles per hour on a circular interchange of radius 250 feet. To keep the vehicle from skidding off course, what frictional force must the road surface exert on the tires?
An aerobatic airplane flying at a constant 60.0 m/s makes a horizontal turn of radius 225 m. The pilot has mass 80.0 Kg. What is the pilot's apparent weight during the turn ?
A small car with mass 0.650 kg travels at constant speed on the inside of a track that is a vertical circle with radius 5.00 m. a. If the normal force exerted by the track on the car when it is at the top of the track (point B) is 6.00 N, what is the normal force on the car when it is at the bottom of the track (point A)?
A 1,300 kg car is capable of making a turn at a maximum speed of 15 m/s without spinning out. If the coefficient of friction between the car's tires and the road is 0.6, find the radius of this turn. Radius_____ m (round to the nearest whole number)
A car of mass 1.6 kg travels at a constant speed of 72 km/h around a horizontal curvedroad with radius of curvature 190 m. What is the minimum value of µₛ between the roadand the tires that will prevent slippage?
A motorist travels along a vertical circle with a diameter of 10.0 m. After one successful revolution, he notices that his speed at the bottom of the pathway is 6.50 m/s. The mass of the motorists is 70.0 kg. What apparent weight would he feel?