The tank of water shown below is 15 cm wide into the paper. The tank is accelerated in rigid-body motion at 9 m/s² in x-direction (right) and 2 m/s“ in z-direction (upwards). Assume nospilling.(a) Show with sketch what will happen to surface point B.(b) Find the angle 0 and the new water depth (height) of side AB.(c) Calculate the water force on wall AB.3Given: Specific Weight of Water, Ywater = 9790 N/m',Draw sketch and show all calculations.B20 cmWater at 20°C36 cm

The above liquid is subjected to acceleration in x direction and z direction, thus it is subjected…

Answered: The tank of water shown below is 15 cm…

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

The three-legged manometer in Fig. is filled with water to a depth of 20 cm. All tubes are long and have equal small diameters. If the system spins at an angular velocity about the central tube, (a) derive a formula to find the change of height in the tubes; (b) find the height in cm in each tube if ω = 120 r/min.
Dam ABC in Fig. is 30 m wide into the paper andmade of concrete (SG =2.4). Find the hydrostatic force onsurface AB and its moment about C . Assuming no seepageof water under the dam, could this force tip the dam over?How does your argument change if there is seepage underthe dam?
A very tall 10-cm-diameter vase contains 1178 cm 3 of water.When spun steadily to achieve rigid-body rotation, a 4-cmdiameterdry spot appears at the bottom of the vase. Whatis the rotation rate, in r/min, for this condition?
The 45 ° V-tube in Fig. contains water and is open atA and closed at C . What uniform rotation rate in r/minabout axis AB will cause the pressure to be equal at pointsB and C ? For this condition, at what point in leg BC will thepressure be a minimum?
[Fluid dynamics] a.) For your science exhibit, you want to make a block of wood float at the interface between a layer of oil of unknown density ?_???, and water (?_????? = 1000 [kg/m^3]) inside a container as shown. What must be the density of the oil so that only 30.0% of the wood is submerged in water? b.) Water is flowing through a pipeline shown onthe right. The radii of the pipe at points 1 and 2 are0.500 [m] and 1.50 [m], respectively. The volume flowrate through the pipeline is 2.50 [L/s]. If the pressureat point 1 in the pipe is 200 [kPa], what is the pressureat point 2, located 5.00 [m] above point 1?
a closed cylindrical vessel of diameter 15 cm and length 100 cm contains water up to a height of 80cm. the vessel is rotated at speed of 500rpm about its vertical axis.find the height in cm of the paraboloid formed.
a vertical cylindrical tank 4.82 m. in diameter and 6.87 m. high is full of water. if the tank is to be rotated about its vertical axis, what will be the required angular velocity (in rpm) so that there is no water within 0.6 m. fom the center of the bottom of the tank.
3. Supposed that air (std.) has a uniform density of 1.2kg/m^3, estimate how high (meters) above the sea level where there exists a zero pressure. Assume that in the given condition, barometric pressure at sea level is 101.325 kPa. Include also the free body diagram or figure of the problem, and your findings after solving it.
A cylinder is formed by bolting two semicylindrical channelstogether on the inside, as shown in Fig. Thereare 10 bolts per meter of width on each side, and the insidepressure is 50 kPa (gage). Using potential theory for theoutside pressure, compute the tension force in each bolt ifthe fluid outside is sea-level air.
The ABC cover in the figure is R = 270 cm in diameter and in the form of a semi-circle and its vertical width to the screen is 140 cm. Find the horizontal component in (N) of the hydrostatic pressure force acting on the lid by the water of density 1g / cm³.
Q5: The U-tube shown in figure (3), in filed with water and rotated about a vertical axis (0.15m) to the right of (A) For a gage pressure at (A) equal to zero Determine the rotational speed in (r.p.m)
An open vessel of water accelerates up to a 30ᵒ plane at 2 m/s². a). What is the angle the water surface makes with the horizontal? B). If the angle mage by the water surface to the horizontal is increased to 25.21ᵒ, what will be the depth of water at the rear side of the vessel, if the initial depth of water at the rear side is 4m and the front is 2m before accelerating? The vessel has a length of 4m and 2m width. C). If the vessel’s depth at the rear side is 5m, what will be the volume spilled if the acceleration is increased to 15m/s²?

SEE MORE QUESTIONS

Recommended textbooks for you

Elements Of Electromagnetics

Mechanical Engineering

ISBN:

9780190698614

Author:

Sadiku, Matthew N. O.

Publisher:

Oxford University Press

Mechanics of Materials (10th Edition)

Mechanical Engineering

ISBN:

9780134319650

Author:

Russell C. Hibbeler

Publisher:

PEARSON

Thermodynamics: An Engineering Approach

Mechanical Engineering

ISBN:

9781259822674

Author:

Yunus A. Cengel Dr., Michael A. Boles

Publisher:

McGraw-Hill Education

Elements Of Electromagnetics

Mechanical Engineering

ISBN:

9780190698614

Author:

Sadiku, Matthew N. O.

Publisher:

Oxford University Press

Mechanics of Materials (10th Edition)

Mechanical Engineering

ISBN:

9780134319650

Author:

Russell C. Hibbeler

Publisher:

PEARSON

Thermodynamics: An Engineering Approach

Mechanical Engineering

ISBN:

9781259822674

Author:

Yunus A. Cengel Dr., Michael A. Boles

Publisher:

McGraw-Hill Education

Control Systems Engineering

Mechanical Engineering

ISBN:

9781118170519

Author:

Norman S. Nise

Publisher:

WILEY

Mechanics of Materials (MindTap Course List)

Mechanical Engineering

ISBN:

9781337093347

Author:

Barry J. Goodno, James M. Gere

Publisher:

Cengage Learning

Engineering Mechanics: Statics

Mechanical Engineering

ISBN:

9781118807330

Author:

James L. Meriam, L. G. Kraige, J. N. Bolton

Publisher:

WILEY

SEE MORE TEXTBOOKS