A closed container containing water up to a height of 3.0 meter and air at the upper part with an orifice of 100 mm at its bottom. If 50% of the air is being removed from the upper part of the container by suction then Estimate discharge passing through the orifice using Bernoulli’s equation if Cd=0.62.

A closed container containing water up to a height of 3.0 meter and air at the upper part with an orifice of 100 mm at its bottom. If 50% of the air is being removed from the upper part of the container by suction then Estimate discharge passing through the orifice using Bernoulli’s equation if Cd=0.62.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

An open tube is attached to a tank as shown. A). If Liquid X (Oil SG=0.55) rises to a height of 800 mm in the tube, what is the pressure Pa (in kPa) of the air above water? Neglect capillary effects in the tube. B). If Liquid X (Alcohol SG=0.79) rises to a height of 800 mm in the tube, what is the pressure Pb (in kPa) of the air above water? Neglect capillary effects in the tube.
1. A 50 mm by 25 mm Venturi meter is installed in a 50 mm diameter horizontal pipe to measure the flow of a certain liquid (sp. gr. 1.30). A differential manometer connected with the inlet and throat of the Venturi meter contains a liquid substance (sp. gr. 2.5) in the lower part of the tube, the remainder of the tube being filled with the certain liquid. The difference in height of substance columns in the two legs of the manometer is 25 cm. If the coefficient of the meter is 0.96, compute the actual discharge and the headloss in the Venturi meter. 2. A 50 mm Venturi meter (C = 0.96) is installed in a 100 mm diameter horizontal pipe carrying oil having a specific gravity of 0.82. If the recorded actual flow in the Venturi meter was 15 liters per second, what could have been the deflection of water in the differential manometer connected between the inlet and the throat? Determine the headloss in the Venturi meter. 3.A fire pump delivers water through a 100 mm main to a hydrant…
A right circular tank 6 m. in diameter and 12 m. high is filled with 6 m. of oil sp.gr. = 0.80 and 6 m. of water. A horizontal circular orifice 75 mm in diameter is situated at the bottom. Coefficient of velocity is 0.98 and coefficient of contraction is 0.61. Neglecting velocity of approach. a. Determine the velocity of the jet issuing from the orifice at the instant the surface of the liquid in the tank is 6.5 m. above the orifice. b. Determine the discharge in kg/sec. through the orifice at the instant the surface of the liquid is 5.5 m. above the orifice. c. Compute the total time to empty the container.
A sprayer located in the vertical plane is used to deflect water with a mass flow of 30 kg/sec from a horizontal pipe by accelerating it by 45 degrees upwards. The elbow throws water into the atmosphere. The pipe diameter of the elbow at the inlet is D1=15 cm, and at the outlet is D2=5 cm. The Dec difference between the axes of the input and output sections is 40 cm. The mass of the elbow, along with the water contained in it, is 50 kg. Determine the necessary force to hold the elbow in place. The momentum flow correction coefficient for the fluid entering and exiting the control volume is 1.03. Note: The sections (1) and (2) are close enough to each other. Specific mass of water : ?w=1000 ??/?3
The liquid in Fig. D has a specific gravity of 1.50. The gas pressure is P = +5.67 lb per sq in.and Pb is -2.67 Ib per sq in. The orifice is 4 inches in diameter with C = Cv = 0.95. Determinethe velocity in the jet and the discharge when h = 4.67 ft.
Air in a room at T0 = 290 K and P0 = 90 kPa is to be drawn by a vacuum pump through a 3-cm-diameter, 2-m-long adiabatic tube equipped with a converging nozzle at the inlet. The flow in the nozzle section can be approximated as isentropic. The static pressure is measured to be 87 kPa at the tube inlet and 55 kPa at the tube exit. Determine the mass flow rate of air through the duct, the air velocity at the duct exit, and the average friction factor for the duct.
1. An orifice in the side of a vertical tank discharges oil (sp. gr. = 0.82) under a head of 4.0 m. and 25 KPa pressure acting on the surface of the oil. If the diameter of the orifice is 5 cm, the coefficient of contraction is 0.62, and the head lost on the orifice is 45 cm, determine the discharge, coefficient of velocity, and the coefficient of discharge.
A jet is discharged through a 25 cm-diameter orifice under constant head of 0.64 m. The total discharge is 103 kg in 90 seconds. The jet is observed to pass through a point 60m downward 1.2 m away from the vena contracta. Compute the theoretical discharge in kg,Compute the coefficient of contraction and the coefficient of discharge, Compute the coefficient of velocity (PLS SHOW STEP BY STEP SOLUTION AND CANCELLATION OF UNITS)
A 3 cm orifice plate is placed within a 4 cm pipe in which methanol at 20 °C (SG =0.7884 and dynamic viscosity (μ) = 0.5857 cP) is flowing through. If the flow ratepassing through the pipe is 3.1 litres per seconds, determine the pressure difference thatmust be measured around the orifice plate. The discharge coefficient of the orifice can be calculated by Where, β is the ratio of orifice diameter to pipe diameter and Re is the Reynoldsnumber.
Determine the diameter of an orifice that permits a tank of horizontal crosssection 1.5m2 to have its liquid surface draw down at the rate of 160 mm/sfor a 3.35-m head on the orifice. Use C=0.63.
An open jet of water at 20 ℃ exits a nozzle into sea-level air and strikes a stagnation tube, as shown in the sketch. If the pressure at the centerline of section (1) is 110kpa (abs), and losses are neglected, estimate: (a) the mass flow in kg/s, and (b) the height H of the fluid in the stagnation tube. (Atmospheric pressure =101.3 kpa)
plzzzz help meee right nowww plzzz what will be the pressure gradient (kpa/m) at L=30 cm through the nozzle? At L=0, the liquid flows inside the nozzle has a specific gravity S=7.5, at L=0, the velocity is 2 m/s while at L=70 cm, the velocity is 6 m/s. Assume steady and inviscid flow. The velocity varies linearly with distance through the nozzle