A closed steam room of volume 125 m has a temperature 45 C and has a RH=100%. Calculate: a. The mass of water vapor in the room; b. The person inside decides that it is too hot and lowers the thermostat's temperature to a new temperature of 35 C. What is the mass of water vapor for this temperature? c. How much water vapor will condense, in order to still have RH=100% in the room?

Q: Problem 3. An adult takes about 12 breaths per minute, inhaling roughly 500 mL of air with each brea...

A: Adult takes 12 breathes per minute, each time he inhales 500ml of air. So total volume of air inhale...

Q: The following equations are in regards to the mass transfer coefficient, k: a.) Why do overall mass ...

A: Part (a) At equilibrium, the ratio of the concentration of a solute in a mixture of two immiscible s...

Q: The trash can distributed by the city of Mobile are approximately 4 feet tall and have a square cros...

A: Given dataHeight of the rectangle (h) = 4 ftSide (l)=30 inchConversion factors are as given below

Q: 9.20. A certain gas obeys the equation of state P kBT/(v - b) where b is a constant with units of vo...

A: Gas obeys the equation of state, where b is constant with unit of volume per molecule. Assume the ot...

Q: Briefly discuss the most practical and time-proven methods used to combat corrosion in the Petroleum...

A: Corrosion: Corrosion is a process in which a metal degrades when meets environment by a chemical rea...

Q: Air is heated from 25°C to 140°C prior to entering a combustion furnace. The flow rate of the air at...

A: Given information:   Air is assumed to behave ideally. Also, kinetic and potential energies for the ...

Q: A liquid mixture containing 30 mols Beneene, B, 25% Toluene T and the balance Xylene X is fed to a d...

A: Given information in the problem:Feed compositionMole % of Benzene = 30Mole% of Toluene = 25Mole% of...

Q: This problem is (12.1) from a book  "Thermodynamics and Statistical Mechanics An Integrated Approach...

A: Consider that the number of ideal gases are in a container and are separated, each occupying a volum...

Q: 1. As a process technicians, what type of materials are used in the manufacture of storage tanks?   ...

A: The different type of materials required to manufacture the storage tanks is to be determined. The p...

Q: The latest weather report states that the temperature is 24 C and the relative humidity is 50%. Uset...

A: A  chart used to provide a concise compilation of large physical property data used extensively to a...

Q: 4.4 Consider the transfer function model in Exercise 4.2. For an initial condition of y(0) =4 and a ...

A: The transfer function model to be used is Initial condition are given as, y(0) = 4 at t = 0.  

Q: 1) Consider the data below for a binary mixture of species A and B at 300 K and 1 bar. The vapor pre...

A: Note: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question...

Q: This problem is (13.11) from a book  "Thermodynamics and Statistical Mechanics An Integrated Approac...

A: Let,     N1 be number of polymer molecules and     N2 be the number of solvent molecules.    M be th...

Q: 3. Determine the osmotic pressure of seawater assuming that its composition can be reasonably approx...

A: Equation for Osmotic pressure can be written as:

Q: Intro to Thermodynamics question

A: (a)   Given information:   Gas: Ethylene (C2H4) Mass: 18 kg Temperature: 55ºC = 328.15 K Pressure: 4...

Q: Air (an ideal gas) at 90ºF and 10 psia is contained in a horizontal cylinder by a frictionless pisto...

A: Part (a) For an ideal gas work done by the gas on the piston if the expansion occurs at constant int...

Q: A crude oil sample contains 10 ppm water. What is the water concentration in (a) mg/L,(b) mM.  densi...

A: Given information:

Q: This problem is (7.11) from a book  "Thermodynamics and Statistical Mechanics An Integrated Approach...

A: (a) The given function is found to be fundamental as S is function of E,V,N which satisfy the given ...

Q: I have attached an image of the problem that needs to be resolved and its parts. The problem number ...

A: (a)   In the given process, there are three components present (A, B, and C). Material balance is wr...

Q: Describe what would happen to the ozone molecules if a small amount of ozone were generated and rele...

A: Ozone is a gas that is naturally existing in our atmosphere. Ozone, (O3), is sometimes called "activ...

Q: A binary feed is 35.% isopropyl ether (IPE) and the rest isopropyl alcohol (IPA), enters at the bubb...

A: Hello, Since your question has multiple sub-parts, we will solve first three sub-parts for you. If y...

Q: 300kg of air and 24kg of carbon are introduced into a reactor and complete combustion of carbon and ...

A:

Q: Water is pumped at the rate of 0.075m3/s from a reservoir 20m above a pump to a free discharge 35 m ...

A:

Q: Out of bottom Distillation column 2 is n9(mol C6H5OH/hr) and m9(kg C6H5OH/hr) Questions: What is n1,...

A:

Q: If you have 100 L of air, how much of that volume contains 10.0 g oxygen gas at 273 K and 1 atm? (Ox...

A: Given information in the problem:Volume of air = 100 LTemperature = 273 KPressure = 1 atm           ...

Q: A droplet of liquid A, of radius r1, is suspended in a stream of gas B.  It is believed that there i...

A: (a) The total flux of A through stagnant gas stream B is the sum of molecular and convective flux.  ...

Q: The Occupational Safety and Health Administration has set the limit on the maximum percentage of car...

A: Hello. Since you have posted multiple questions and not specified which question needs to be solved,...

Q: This problem is (10.9) from a book  "Thermodynamics and Statistical Mechanics An Integrated Approach...

A: For a single component system in two phases in equilibrium, the relationship between the chemical po...

Q: .Verizon 89% 5:33 PM Done 2. A liquid system consisting of 5 % mole ethanol and the rest being water...

A: Part (a) At constant pressure, the temperature at which the liquid mixture boils is determined as sh...

Q: A mixture of 15% helium, 28% argon, and 57% nitrogen has a total mass of 11.6342 grams and occupies ...

A: Given data: The total mass of the mixture = 11.6342 g The volume of the mixture = 5 L Temperature = ...

Q: What is the percent by mass of oxygen in a gaseous mixture whose molar composition is 0.500% CO2 and...

A: Let the mole of gas mixture present be 100 mol. It is given that there is 0.500% CO2 and 99.500% air...

Q: A 8.7 kg of lead initially at 210∘C is dropped into an insulated basin containing 21.9 kg of water i...

A: Given Information: Mass of lead dropped in the water basin, mL = 8.7 kgInitial temperature of the le...

Q: For some plants, enough heat is generated to increase the temperature of the blossom by 15 C. About ...

A: Given data: Volume of the water = 1 L Temperature difference = 15 0C

Q: A fuel consists of 75 mole % methane and 25 mole % ethane. It enters a furnace with 80% excess air a...

A: Consider the following system with 2 feed streams F1 and F2 and one product stream P1. Moles of CH4 ...

Q: Water at 65∘F and 20 psia is mixed steadily with saturated water vapor at 20 psia in an insulated ch...

A:

Q: 1. Countercurrent multistage extraction. Pure methylisobutyl ketone (MIK) of 200kg/h is used to extr...

A:  For counter current multistage flow pure methyl isobutyl is used to extract acetone 

Q: Express the Internal Energy and Entropy as a Function of T and V for a homogeneous fluid. Develop th...

A:

Q: This problem is (8.10) from a book  "Thermodynamics and Statistical Mechanics An Integrated Approach...

A: For a system of variable composition (open system), the differential change in molar Gibbs free ener...

Q: One hundred kilograms of molecular hydrogen (H2) is fed into a reactor each hour. What is the molar ...

A: Molar flow rate of a stream is defined as number of moles of substance per unit time entering the re...

Q: . Quenching Lead Shot in a Bath. Lead shot having is at an initial temperature of 204.4°C. To quench...

A: Given information in the question:Considering the shape of lead shot as sphericalAverage diameter (D...

Q: This problem is (6.21) from a book  "Thermodynamics and Statistical Mechanics An Integrated Approach...

A: Efficiency of refrigerator is measured by coefficient of performanceCOP  of a refrigerator is writte...

Q: A steam turbine in a small electric power plant is designed to accept 4500lg/hr of steam at 60 bar a...

A: Given information:   Inlet conditions are represented by 1 and outlet conditions by 2.

Q: What's your favorite color

A: The color of the person who is answering this question is been asked.

Q: I need a drawing of a closed loop diagram

A: A closed loop system is a closed system of mechanical devices that regulates the variables of the pr...

Q: How much heat (in kJ/hr) is released/absorbed (specify which) if 100 mol/hr of liquid n-heptane is c...

A: The combustion reaction of n-heptane is:

Q: Gaseous ethane  CH3CH3  will react with gaseous oxygen  O2  to produce gaseous carbon dioxide  ...

A:

Q: This problem is (14.1) from a book  "Thermodynamics and Statistical Mechanics An Integrated Approach...

A: It is given that dry ice (Carbon dioxide) is in equilibrium with gas phase of CO2 and N2 and gas pha...

Q: Orthonitroanaline is formed from the reaction of ortho nitrochlorobenzene (ONCB) and aqueous ammonia...

A: Part (a):Consider the given reaction. O-nitrochlorobenzene is represented by A and liquid ammonia by...

Q: the feed to distillation column is 100gmole/h. the feed composition is 40 mol℅ benzene and the rest ...

A: Let, Benzene = B and Toluene = T xF = 0.4 mol B/mol (mole fraction of benzene in feed stream)yB = 0....

Q: The problem that is listed below need to be solved and you may access that problem via viewing them ...

A: (a) It is known that the pressure at two different points on the horizontal line in a liquid with no...