Answered: a) Discuss the use of hyperbolic…

a) Discuss the use of hyperbolic functions and Taylor series when modelling the long transmission line as an equivalent n circuit.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter6: Power Flows

Section: Chapter Questions

Problem 6.7MCQ

See similar textbooks

Related questions

Q: b) Write ABCD Parameters of the nominal Tt model of the medium transmission line.

Q: Formulate the ???? matrix for the network shown here. 2. Modify ???? in the previous problem if the…

A: Redraw the circuit Given values : Y1-3 = j0.30Y1-2 = j0.24Y2-3 = j0.16 Z1-2 = j0.20Z2-3 =…

Q: )A 60-ohm distortionless transmission line has a capacitance of 0.15nF/m. The…

A: here, the given line is the distortionless transmission line so, the condition of the distortionless…

Q: Line parameters of a transmission line at 2 GHz are R = 10 mn/m, G = 1 µS/m, L = 1 µH/m, C = 1 nF/m…

A: The given circuit diagram is shown below: It is given that: R=10 mΩ/m=10×10-3 Ω/mG=1 μS/m=1×10-6…

Q: Give four challenges and suggest solutions for those challenges in wireline operations.

A: 1)Crowded place:- In crowded place it is very difficult to do wiring as very small space is…

Q: What are the advantages of transmission lines over lumped elements in matching networks?

A: Since you have posted multiple questions, hence we have answered the first question. Repost the…

Q: Choose the correct answer for the following; • The components of the propagation constant are named…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: 14-2 Based on the rule-of-thumb in the lext, determine the length of line al which transmission line…

A: The solution is given below

Q: Y = E(0,2,3,4,9,10,12,13) d (6,8,14) .Simplify using KMap. Q

A: K-map is used to minimized the expression . The K-map is arranged in such way that its differ by 1…

Q: A 400 kV, 50-Hz transmission line is 400 km long. Assuming that sending end of the line is energized…

A: It is given that: Velocity of propagation=v=300,000 km/sSending end voltage=VS=400 kVFrequency=f=50…

Q: 4) When the transmission line is terminated by a matched load, what is the value of the VSWR?

Q: Viva Questions: 1. What is the difference between Primary and Secondary constants? 2.Define…

A: 1. The fundamental difference between the primary and secondary constants is that the primary line…

Q: Q3/ A 3-phase, 50HZ, 150 km line has a resistance, inductive reactance and capacitive shunt…

A: Total resistance 'R' per phase of the line, R=0.1*150 =15Ω Total inductive reactance 'XL'…

Q: A lossless transmission line has a distributed inductance of 10 pH per meter and a distributed shunt…

A: Given data : Distributed inductance L=10×10-6H/m For 4m length L=10×10-6×4 =40×10-6 Distributed…

Q: When analyzing Short Transmission Line problems, the sending and receiving ends must be in Star…

A: We need to tell about short transmission line .

Q: A 132-kV, 50HZ, three-phase transmission line has a per phase series impedance of z = 0.11 0/km and…

Q: The inductances per phase and capacitance per phase of a three-phase, 50H z, 450KV transmission line…

Q: Discuss the use of hyperbolic functions and Taylor series when modelling the long transmission line…

A: Discuss the use of hyperbolic functions and Taylor series when modelling the long transmission line…

Q: b) Write ABCD Parameters of the nominal T model of the medium transmission line.

Q: Q3/ A 3-phase, 50HZ, 150 km line has a resistance, inductive reactance and capacitive shunt…

Q: Q5: A 3-phase, 50Hz, 150 km line has a resistance, inductive reactance and capacitive shunt…

Q: 2) Write the Applications of Ring & Radial distribution network.

A: The ring distribution network is shown below. The applications of the ring distribution network are…

Q: B-For the lossless transmission lines circuit shown below, design the value of Rx for proper series…

A: Given figure,

Q: The components of the propagation constant are named as For long transmission line system, The…

A: Given *The components of the propagation constant are named as…

Q: A lossless transmission line, with characteristic impedance of 50 N and electrical 2 length of { =…

A: 2. A lossless line is characterized as a transmission line that has no line obstruction and no…

Q: Consider an open – wire telephone line, which is 200 km in length, is terminated by - its…

A: The length of the wire = 200 km Generator frequency = 1 kHz Internal impedance of generator = 500…

Q: For a STABLE LTI system, all the poles of the system function H(z) must lie inside the unit circle.…

A: The LTI system is considered as stable when the bounded input provide a bounded input.

Q: For a one port network, explain the effect on the admittance frequency characteristics when it has a…

A: In the question, What is effect of frequency in admittance of path if Element is connected to…

Q: 3. Determine the sending end voltage, V, of the given nominal-T transmission line.

Q: 10/Explain in your own words and your own understanding (avoid plagiarism) why there's Capacitance…

A: Simply capacitor is nothing but two conducting materials separated by small distance, in between…

Q: A 40-km, 220-kV, 60-Hz three-phase overhead transmission line has a per-phase resistance of 0.15…

Q: lossless transmission line has a capacitance per unit length of 64pF/m and an inductance per unit…

Q: Obtain cascade structure as a second-order transposed direct form II sections with real coefficients…

A: please rate meplease rate meplease rate meplease rate meplease rate meplease rate meplease rate…

Q: ii) A 10% voltage drop occurs in 2 km of a uniformly loaded transmission line terminated by its…

Q: The propagation constant for a lossless transmission line will be (a) Real (b) Complex (c) Real and…

A: The propagation constant of a transmission line indicates the magnitude and phase angle difference…

Q: The open-circuit and short-circuit impedances measured at the input terminals of an air- spaced…

Q: A 3 phase, 50 Hz, 150 km line has a resistance, inductive reactance and capacitive shunt admittance…

Q: 7. A transmission line has the following per-unit-length parameters: L = 0.25 uH/m, C= 100 pF/m,…

Q: 2- Transmission line 10m long has distributed parameters R = 52/m, L = 6µH/m, G= 10 mS/m, and C = 25…

Q: Show that VSWR for a transmission line will have values between 1 and infinity.

A: Although expression of standing wave ratio ‘S’

Q: For a medium transmission line, VRNL is equal to Vs. Select one: O True O False

A: sending end voltage will be same as no load receiving end only when capacitance effect is absent .…

Q: Transmission line 10m long has distributed parameters R = 5 Ω /m, L = 6µH/m, G = 10 mS/m, and C = 25…

A: (A): The characteristics impedance is:…

Q: 4. The propagation constant consists of two terms. the first term is the attenuation constant, and…

A: We need to find out attenuation constant for lossless transmission line

Q: ) Write ABCD Parameters of the nominal π model of the medium transmission line.

Q: 2. a) Draw nominal - T model of Transmission Line. ( b) Write ABCD Parameters of the nominal T model…

Q: The X by R ratio of a cable is much lower than that of a transmission line True False

A: X/R is the ratio of the reactance to the resistance.

Q: For a one port network, explain the effect on the admittance frequency characteristics when it has a…

A: In the question, What is effect of frequency in admittance of path if Element(either indotor Or…

Q: a) Draw nominal - T model of Transmission Line. b) Write ABCD Parameters of the nominal T…

Q: Return loss for a transmission line in terms of its reflection co efficient is given by:

A: The return loss is a parameter that is used to measure the amount of energy that is reflected back…

Concept explainers

Transmission Line Parameters

The performance of a power system is mostly determined by the producing stations and transmission lines in the system which can be studied with the help of transmission line parameters.

Question

=、ロ
Done
a)
Discuss the use of hyperbolic functions and Taylor series when modelling the
long transmission line as an equivalent z circuit.
- 5 -

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Transmission Line Parameter (T-parameter)

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Obtain the bus admittance matrix for the given 5-bus power system.
Discuss the use of hyperbolic functions and Taylor series when modelling the long transmission line as an equivalent pi circuit
What other challenges can be encountered in designing a transmission line? Enumerate at least 3 and how can these challenges be solved. What are the advantages of solar panels over transmission lines? Why can’t we still fully transition to solar panels?
With the system shown in figures, use 100MVA as system base, and 230 kV as base voltage along the transmission line. 1. Build the Y-bus matrix without the Load. What is the element Y12 in susceptance value? 2. If you are to convert the real power load to a shunt conductance, what is the value of the conductance in per unit?
Subject: Electrical & Electronics Engineering Course: Power Systems Question: In case of modeling a Long Transmission Line, what are the available procedures? Which one is the best and why? Explain.
Compare Equivalent- π and Nominal-π in transmission lines. What are their diffirences? When we use them, in order to do what ?Thank you
If the branch is added between old bus to the reference bus then the size of Zbus,new increased by 1. Select one: True False
Explain the concept of dynamic line rating (DLR) and its significance in optimizing power transmission capacity.
How do you calculate the design of a transmission line? What equations?
Design a ‘π’ equivalent circuit for 320 km long 3-φ, 50 Hz transmission line.The line is composed of Drake conductors with the outside diameter of 2.8 cm and flat horizontal spacing of 3.65 m between adjacent conductors. The line has a resistance of 0.075 Ω/km.
b) Ghana Grid Company (GRIDCo) designed a short transmission line using the A, B, C, D line constant of a transmission line parameters in its analysis. The engineering planning department came up with the design and said that when they computed the line performance using the equation AD – BC the answer was equal to 1.As an employee at the Ministry of Energy (MoEn) having oversight responsibility over GRIDCo, how would you accept the answer and recommend the Government of Ghana (GoG) to go ahead to implement the short transmission line?
With the system shown in the figure, use 100MVA as system base, and 230 kV as base voltage along the transmission line. For the same system in the figure, build the Y-bus matrix without the Load. 1. What is the element Y11? Provide the susceptance value 2. What is the element Y22? Provide the susceptance value