a)Hand Written AnswerDistinguish between the characteristics of the two instruments in Fig. Q2(a). You may presentyour answer in a table format.Fig. Q2(a)b)Describe the characteristics of the Gray code that make it advantageous over the binary code forencoders.

Given questions are related to robotics engineering.

a) Distinguish between the characteristics of the two instruments in Fig. Q2(a). You may present your answer in a table format. Fig. Q2(a) HIT b) Describe the characteristics of the Gray code that make it advantageous over the binary code for encoders.

a) Distinguish between the characteristics of the two instruments in Fig. Q2(a). You may present your answer in a table format. Fig. Q2(a) HIT b) Describe the characteristics of the Gray code that make it advantageous over the binary code for encoders.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: Two steel spheres of diameters d, and d₂ where d₂ = 2d₁, are dropped from rest at the free surface…

Q: Calculate the maximum allowable pressure difference between the inside and outside of a sphere 50 mm…

Q: A flow of water at 1 atm with a vapor pressure of 0.2 psi and a critical cavitation number of 0.3…

Q: P d L R A square made of aluminum (density p = 2700 k m and has dimension L = 5.20 m and thickness e…

Q: 1-108 A pressure cooker cooks a lot faster than an ordinary pan by maintaining a higher pressure and…

Q: y boom m y: loomm Q/ Find centroid about x_axis 1/1/0 X x

A: Given that: The area is bounded by two curves: y = 1100x2 ---------------- (1)…

Q: Solve the moj and tabulation and state whether tensile or compress

Q: A copper-constantan thermocouple is connected to coppe wires and the reference junction is exposed…

A: Given data as per questionRoom temperature=20°COutput voltage measured=6.537 mV

Q: Arm AB has a constant angular velocity of 16 rad/s counterclockwise. The collar at D slides over the…

Q: For the simply supported steel beam [E = 200 GPa: I = 129 x 106 mm²] shown in the figure, use the…

Q: At a given instant, the position of a plane at A and a train at B are measured relative to a radar…

A: Given: Let us consider the given image,

Q: What is the relevance of this another level of (self-discovery) in enhancing our competency as…

A: Engineer Entrepreneur:- There are meticulous problem-solvers who take pride in the structures they…

Q: Part A Determine the maximum speed of the block for the steady-state vibration. Express your answer…

A: Given Mass = 40 kg k = 750 N/m F=100 cos2t N To find Maximum speed

Q: The image below shows a beam subject to two couples, F₁ = 7.5 N and F2 = 1.2 N. (Figure 4) The…

Q: By circle of mohr dij find: -main efforts [50 5 15 5 15] 20 10 MPC 10 20.

Q: What do u mean by the factor of safety 3,4....n?

A: Factor of safetyit is the ratio of the ultimate strength of a member to the actual working stress or…

Q: Use Gauss Elimination method to solve 0.3x₁ +0.52x₂ + X3=-0.01 0.5x1 + x₂ +1.9x3 = 0.67

A: Given

Q: A solid steel post is subjected to pure torsion. Given data: Post diameter = 75 mm Post length = 2.5…

A: Given data : Shear modulus of rigidity=G Post diameter=d Post length=L Required : Torsional…

Q: A long aluminum cylinder (p= 170 lbm/ft³, c= 0.22 Btu/lbm F, k = 140 Btu/h ft F) has a diameter of 3…

Q: B: The pump in Fig. Q3B increases the pressure in the water from 200 to 4000 kPa with a flow rate of…

Q: Write about of the following related to shell and tube heat exchanger: (i) Tube sheet and tube pitch…

A: Given Shell and tube exchanger To find Relation Tube sheet and tube pitch Baffle and baffle spacing…

Q: Every closed feedwater heater generates a condensate. Determine: a) If it is sent to the high…

A: (a) It is clear that every closed feedwater heater generates a condensate.

Q: Task 2: Is abrass >OR < aFe bimetallic strip since the bimetallic strip curves in towards iron side!…

A: Write the expression of coefficient of thermal expansion. α=Lf-LiLi1Tf-Ti

Q: Q2: A pump with flow rate 1000 US gpm, its impeller size of D1 inch rotates with N₁ rpm. If the…

A: GivenQ=100US gpm=100015850.323141=0.06309 m3/swhendia=D1speed=N1nowD2=1.20D1N2=1.25N1H=420ft=420…

Q: A valve incurs a head loss equal to 2.2 meters length of pipe having a diameter of 8.6 cm and a…

Q: (a) Write down the Bernoulli energy equation for a fluid flow. Explain all terms making up this…

Q: surface height is 25 inches from the floor. She lifts this box at a rate of four lifts per minute.…

A: Given data as per questionWeight of 55 year old female=120 lbBox with weight,(L)=18 pounds=8.165…

Q: You are tasked to supervise the design of 0.5MW wind turbine to be constructed in the Wind Farm in…

A: Given data: Diameter of the rotor blades = D = 125 m Density of air = ρ = 1.225 kg/m3 Average speed…

Q: A- Blood flow from the left ventricle into the aorta can be modeled as a reducing nozzle (Figure…

A: Given Inlet diameter = 3.1 cm Outlet diameter = 2.7 cm Inlet pressure = 130 mm Hg Outlet pressure…

Q: insulated. What is the minimum thickness of styrofoam insulation (k = 0.030 W/m K) that must be…

A: Given data as per question Side of the cube =2 m k =0.030 w/m k Heat load =500 w Inner temperature…

Q: D. What material will you choose to design the outer terminal (Part 4) to have a highest strength…

A: A spark plug is used to ignite the petrol engine .this device fits into the cylinder head of an…

Q: 1. Using the enthalpy of reaction he data at 3000K and the Kp value at 2800 K of the combustion…

A: The enthalpy of reaction is defined as the difference between the enthalpy of products and the sum…

Q: A certain gasoline weighs 46.5 lb/ft3. What is its specific gravity?

A: We have to find specific gravity of gasoline

Q: - Blood flow from the left ventricle into the aorta can be modeled as a reducing nozzle (Figure…

Q: Determine the power required (Watts) to drive a reciprocating pump running at 1 rps and discharges…

Q: A solid steel post is subjected to pure torsion. Given data: Post diameter = 75 mm Post length =…

Q: Derive an expression for the thermal resistance for one-dimensional heat conduction through a…

A: Draw the diagram of the spherical shell.

Q: 6. Find 0₁ (s)/T(S) 18 N-m-s/rad 8₁(1) kg-m² 1 N-m-s/rad T(1) 0₂(1) 3 kg-m2 0000 9 N-m/rad 0000 3…

A: Given,

Q: 8-137. The three stone blocks have weights of W, 600 16, Wa 150 lb, and We- 500 th Determine the…

Q: Determine the average bearing stress at Cin member BC. The average bearing stress at C in member BC…

Q: 2/208 Cylinder B has a downward velocity of 0.6 m/s and an upward acceleration of 0.15 m/s².…

A: We have to slove above questions Determine the velocity and acceleration of block A

Q: 10. The barometer reads 29 inches of mercury. What is the absolute pressure if a vacuum gauge reads…

A: Given data as per questionBarometer reads pressure, Patm=29 inch of HgPvacc=9.5 psi

Q: A Carnot heat pump delivers 2500 Btu of heat to a room maintained at 78°F by allowing room air to…

Q: The compression ratio in an air-standard Otto cycle is (8). At the beginn mpression: stroke, the…

A: Givenair standard otto cycler=8P1=0.1MPaT1=15oCQadd=1800 kJ/kg

Q: at 32 degree and 205 kpa gage the specific weight of a certain gas was 13.7 N\m3 Determine the…

A: Given:Gas temperature, T=32oCGas pressure, P=205 kPa gageSpecific weight of gas, γ=13.7 N/m3Find:…

Q: (5) The characteristic equation of gasses (PV-mRT) holds good for (a) Monoatomic gases (b) ideal…

Q: 2.11 Consider steady-state conditions for one-dimensional conduction in a plane wall having a…

Q: Identify the number of degrees of freedom of the following systems. Explain why. Specify…

A: Given: There are four mechanical system with different orientations of springs and masses. Degree of…

Q: A 2024-T4 aluminum tube with an outside diameter of 3.7 in. will be used to support a 24-kip load.…

Q: 4/35 Calculate the forces in members BC, BE, and EF. Solve for each force from an equilibrium…

Question

a)
Hand Written Answer
Distinguish between the characteristics of the two instruments in Fig. Q2(a). You may present
your answer in a table format.
Fig. Q2(a)
b)
Describe the characteristics of the Gray code that make it advantageous over the binary code for
encoders.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A furnace with an aperture of 30 mm diameter and emissive power of 4x10^5 W/m^2 is used to calibrate a heat flux gage having a sensitive area of 2x10^-5 m^2At what distance, measured along a normal from the aperture, should the gage be positioned to receive irradiation of 1000 W/m^2 ? If the gage is tilted off normal by 20^o what will be its irradiation?
Weather radar provides information on the intensity as well as the total amount of precipitation. Table A shows the relationship between radar reflectivity values and rainfall rates. If radar measured a reflectivity value of 47 dBZ for 2½ hours at a particular location, how much rain has fallen there?
A thin film of oil, on the surface of glass , results in destructive interference. If the wavelength of the incident light (650 nm) , find the thickness of the film. (Nair =1; Nott = 1.45; Nglass = 1.52)
Pertaining to Lab 3 Q14, why is the peak net radiation approximately the same on the two dates seen in figures 3-5 and 3-6? The weather conditions must have been the same on those dates (i.e. clouds, pressure, temperature, etc.) The data for both days must have been taken on surfaces with the same albedo Botswana is right on the equator so it has very little variation throughout the year The latent heat, sensible, heat, and soil fluxes when averaged together are about the same on both days The sun angles are similar on both dates
The speed of sound in air is 340 m/s, and the speed of light is 3.0 X 108 m/s. What frequency oflight has the same wavelength as a 200.0 Hz sound wave?
The sun is the only star whose size we can easily measure directly; astronomers therefore estimate the sizes of other stars using Stefan's law. The spectrum of the star Betelgeuse, plotted as a function of energy, peaks at a photon energy of 0.8 eV, while Betelgeuse is approximately 10,000 times as luminous as the sun. How does the radius of Betelgeuse compare to the sun's radius? Why is Betelgeuse called a "red supergiant"?
Earth absorbs solar energy and radiates infrared energy. The intensity of the solar radiation incident on earth is J = 1350 Wm-2, also known as the solar constant. Assume earth’s surface (ground) temperature to be uniform at Ts, and that the ground and atmosphere are black (emissivity = 1) for infrared radiation. The radius of the earth is 6.378 x 106 m. The diagram shows the ground at the surface temperature Ts and the atmosphere, represented as a thin black layer, at temperature Ta . Suppose the atmosphere absorbs 100% of the infrared radiation emitted by the ground. Assume that the ground absorbs 47.5% of the incident solar energy, and that the atmosphere absorbs 17.5% of the incident solar energy (for a total of 65% absorbed by the planet). Calculate the "steady state” numerical values of the earth’s ground temperature Ts and the atmospheric temperature Ta taking into account the “greenhouse effect” of atmospheric infrared absorption and emission described above.
Radiant energy with an intensity of 800 W/m2 strikes a flat plate normally. The absorptivity is twice the transitivity and thrice the reflectivity. Determine the rate ofabsorption, transmission and reflection of energy
In a biprism experiment, the slit is illuminated by the light of wavelength 5890A.the distance between the slit and eye piece is 0.8m.the two virtual images of the slit are formed 0.2cm apart. Calculate the change in fringe width if the eye piece is displaced 10cm away from the slit.
Find the speed for a star in which this line appears at wavelength 121.1 nmnm.. Express your answer to three significant figures and include the appropriate units.
Absorptivity, reflectivity and transmissivity are three main properties inradiation heat transfer. With the help of illustration distinguished the differentbetween these three properties and conclude the relationship between them.
Extrasolar Planets. In the not-too-distant future, it should be possible to detect the presence ofplanets moving around other stars by measuring the Doppler shift in the infrared light they emit. If a planetis going around its star at 50 km/h while emitting infrared light of frequency 3.330 x 1014 Hz, whatfrequency light will be received from this planet when it is moving directly away from us? (Note: Infraredlight is light having wavelengths longer than those of visible light.)