a) Four reservoirs, L, M, N and P, in which the water levels are 17 m, 8 m, 3 m and 6 m above datum, respectively, are connected by pipes to a common junction at point O. Details of the pipes are tabulated in Table 1. Table 1: Pipe Details Pipe Length (m) Diameter (m) Friction (f) LO 150 500 0.005 Мо 300 300 0.006 NO 450 250 0.005 PO 850 450 0.006 i) Determine the head at O. ii) Calculate the flow in each pipe.

a) Four reservoirs, L, M, N and P, in which the water levels are 17 m, 8 m, 3 m and 6 m above datum, respectively, are connected by pipes to a common junction at point O. Details of the pipes are tabulated in Table 1. Table 1: Pipe Details Pipe Length (m) Diameter (m) Friction (f) LO 150 500 0.005 Мо 300 300 0.006 NO 450 250 0.005 PO 850 450 0.006 i) Determine the head at O. ii) Calculate the flow in each pipe.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Please anybody answer this ASAP,i need the answer in 40 min Air flows isentropically through a channel To = 310 ° C. The two ends have identical areas, namely A = 25 cm², pressure p1 = 160 kPa and p2 = 65 kPa Determine a). Mass flow rate, b). Throat area and C). Ma2
In the following figure, a machine is installed in the water drainage system. Knowing that the machine's efficiency is 75%, obtain the flow direction, whether the machine is a pump or a turbine and its power.The pressure measured by the manometer above the machine is equal to 150 kPa and the pressure loss is given by lw= K* u2b / 2(m2/s2). Between sections (1) and (2), K1-2 = 3.0, and between sections (2) and (3), K 2-3 = 1.5. D = 15 cm, ρ= 103 kg/m3 and 1HP = 745,7 W (watt)
A nozzle meter, with an orifice diameter of 3 cm, is being used to determine the velocity of ethanol (SG = 0.789, μ = 0.986*10-3 Pa.s) flowing through a smooth plastic pipe of diameter 6 cm. A differential mercury manometer is attached across the nozzle, showing a height from the bottom of the manometer of 10 mm Hg on one side of the nozzle meter and 150 mm Hg on the other. (ρHg =13600 kg/m3). What is the volumetric flowrate of the oil?
Water (density 1000 kg/m?) flows through an inclined pipe of unform diametar. The velocity. pressura and elevation at section A are V, = 3.2 mis, p, =186 kPa and 2, = 245 m respectively, and those at section B ara V = 3.2 /s, py = 260 kPa and 2y = 9.1 m, respectivoly. If accaleration due 1o gravity /s 10 m/s* then the head lost due to friction is ‘m (round off 1o one decimal place).
Oil of viscosity 10E-3 Pa-s and specific gravity 0.90, flows through 60 m of 100mm diameter pipe and the pressure drop 13.8 kPa. What will be the pressure drop for a second oil of viscosity 30E-3 Pa.s and the specific gravity 0.95 flowing at the same rate through the pipe? Assume the pipe wall to be smooth.A. 19.4 kPaB. 98.7 kPaC. 142.2 kPaD. 192.5 kPa
A fully-filled open storage tower of height 32 m and diameter 3.0m supplies water to a house. A horizontal pipe at the base of the tower has a diameter of 2.54cm. To satisfy the needs of the home, the supply pipe must be able to deliver water at a rate of 0.67 gal/s. a. If water were flowing at the maximum rate, what would be the pressure in the horizontal pipe?b. A smaller pipe, of diameter 1.27 cm supplies the second floor of the house, a distance of 7.2 m above the ground level. What are the flow speed and water pressure in this pipe?
The hydroelectric facility that has been proposed will consist of a turbine with anefficiency of 89.2%. The facility will be located at a vertical depth of 14.8 m belowthe riverbed. The river flows with the following properties:o hydraulic diameter of 6.25 mo slope of 0.031o wetted perimeter of 12.2 mo a Chezy coefficient of 4.85 m0-5s1.Thedensity of the river water is 998.2 kg m3, and the acceleration due to gravity is9.81 m s2.Assuming that the turbine operates for 94.0% of the time and one year isapproximately 3.1536 x 107s, calculate:i. the mass flow rate of the river(5 marks)ii. the maximum energy that could be extracted annually from the river flow.
An oil of specific gravity 0.9 is flowing through a venturimeter with inlet diameter of 300 mm and throat diameter of 205 mm. A differential manometer connected to the inlet and throat of the venturimeter gives a difference in the reading of 27 cm of mercury. Take coefficient of discharge of the venturimeter (Cd) as 0.96. Find the following Inlet area of the Venturimeter (in m2) Answer for part 1 Throat area of the Venturimer (in m2) Answer for part 2 Differential pressure head 'h', (in m of oil) Answer for part 3 Discharge of oil through Venturimeter (in m3/s) Answer for part 4 Discharge of oil through Venturimeter (in Litre/s)
Estimate pump power requirement for Hpump = 58.598 m and npump = 0.60. Use the following: v = 1 x 10-6 m2/s Kentrance = 0.5 Kexit = 1 Kelbow = 0.26 f = 0.019 γ = 9810 N/m3 Choices: 197 kW 179 kW 279 kW 297 kW None of the Choices
Please indicate the given and illustration A steel pipe, 3.5 km long x 80 cm diameter x 1 cm wall thickness, conveys water at the rate of 1.75 m3/s. Determine the increase in pressure when a valve provided at the downstream end of the pipe is closed instantaneously. Consider pipe to be elastic and take bulk modulus of water K = 2x109 N/m2; Modulus of elasticity of steel E = 2x1011 N/m2. After determining the surge of pressure in the pipe, compute the following: A) The Longitudinal Stress of the Pipe in Pascal. B) The Circumferential Stress of the Pipe in Pascal.
In the benzene plant, the pressure drop at some point of a pipeline in which benzene is passing through is measured with a U-tube manometer (Rm,1) as 10 cm (1stsituation). The manometer fluid is carbon tetrachloride(CCl4). Then, in order to avoid CCl4 poisoning, it is decided to add a layer of water to both arms of manometer (2nd situation). So, 4 cm of water is added to the left arm and 8 cm of water is added to right arm. In this newsituation, what will be the height difference of manometer fluid (CCl4) between the arms of the manometer (Rm,2)?Data: ρbenzene=876 kg/m3, ρwater=997 kg/m3, ρCCl4=1587 kg/m3
A pipe with unequal ends is used to transport a fluid. The pipe diameter at the larger end is 0.81 cm and the other end is 0.28 cm. The larger and smaller ends are located 10 m and 4 m, respectively, from the datum line. If the flow at the 10 m datum line is 1.60 m/s and the pressure is 5244 kN/m2, compute for the pressure, in kPa, at the smaller end. Express your answer in 3 decimal places.