A fous slage Ceutrifugal pump has fourideutical impelles, ReyedThe shaf is ounningAtothe same shaft:at 400 spom. and themanometnc head deneloped by thetotalmutstage pu mpis 40 m The dicchargetheough pump is D 2 rms. The vanes ofhaving outlet angle as 45.dia meter at outleteach1epelle s areIf the oidh andS Scmscm and 60crm despechnely , hind themamometric offiuency.

A device which converts mechanical energy into pressure energy with the help of centrifugal force is…

A fous stage centrifugal pump has four ideutical empelles, keyed to the same shaft. The shaf in ounning at 400 spm. and the mamo metnc head deneloped by the is 40 m The diccharge total gmulhstage pump theough puamp is D.2 m?Is. The vanes of each 1pelle s are having outlet angle as 45- If the Loidth and diameter at outet U Scm and 60cm lespechnely, hind the mamometsic offiuency.

A fous stage centrifugal pump has four ideutical empelles, keyed to the same shaft. The shaf in ounning at 400 spm. and the mamo metnc head deneloped by the is 40 m The diccharge total gmulhstage pump theough puamp is D.2 m?Is. The vanes of each 1pelle s are having outlet angle as 45- If the Loidth and diameter at outet U Scm and 60cm lespechnely, hind the mamometsic offiuency.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A pump takes water at 60 F from a largereservoir and delivers it to the bottom of anopen elevated tank 25 ft above the reservoirsurface through a 3-in ID pipe. The inlet tothe pump is located 10 ft below the watersurface, and the water level in the tank isconstant at 160 ft above the reservoir surface.The pump delivers 150 gal/min. If the total loss of energy due to friction in the pipingsystem is 35 ft-lb, per 1bm of fluid, calculatethe horsepower required to do the pumping.The pump-motor set has an efficiency of 55%.
The pump in Fig. draws gasoline at 20 ° C from areservoir. Pumps are in big trouble if the liquid vaporizes(cavitates) before it enters the pump. ( a ) Neglecting lossesand assuming a fl ow rate of 65 gal/min, fi nd the limitationson ( x , y , z ) for avoiding cavitation. ( b ) If pipe frictionlosses are included, what additional limitations might beimportant?
Throughof the system that showsof the figure circlesa flow rate of 100L/slight oil(s=0.72), which ispowered by apump it upsupplies apower of 5.0 kW andworks with a85% efficiency.determine the timegauge mmdifferential
To avoid the bulky tower and impeller and generator inthe HAWT of the chapter-opener photo, we could insteadbuild a number of Darrieus turbines of height 4 m anddiameter 3 m. (a) How many of these would we need tomatch the HAWT’s 100 kW output for 15 m/s wind speedand maximum power? (b) How fast would they rotate?Assume the area swept out by a Darrieus turbine is twothirdsthe height times the diameter.
The nozzle which furnished the water to a certain hydraulicturbine 275 mm in diam. and has coefficients of velocity anddischarged of 0.975 and 0.96 respectively. The nozzle suppliedfrom a 60cm pipe in which the water approached the nozzle witha total head of 330m. a. Energy per second delivered by the jet to the turbine.b. Energy measured in hp lost in passing through the nozzle.
A centrifugal pump delivers 25 liters of water per second against a head of 10 meters and running at 1300 rpm requires 10 kW of power. Determine the discharge, head of the pump and power required if the pump runs at 1500 rpm. (Ans. 0.0288cumec or 1.73 cu.m./min , 13.31m, 15.36kw)
In order to drain the tank faster, a pump is installed near thetank exit. Determine how much power input is necessary toestablish an average water velocity of 4 m/s when the tank isfull at 2 m.
Air enters through a duct of a fan with a velocity of 4m/s and an inlet pressure of2cm of water less than atmospheric pressure. The air leaves the fan through aduct at a velocity of 12m/s and a discharge static pressure of 8cm of waterabove atmospheric pressure. If the specific weight of air is 1.2kg/m3 and the fandelivers1 2m3/s, what is the fan input power to the motor if the fan has amechanical efficiency of 70% and motor efficiency of 80%.
A four-stage centrifugal pump has four identical impellers, keyed to the same shaft. The shaftis running at 400 r.p.m. and the total manometric head developed by the multistage pump is 40m. The discharge through the pump is 0.2 m*3/s. The vanes of each impeller are having outlet angle as 45°. If the width and diameter of each impeller at outlet is 5cm and 60 cm respectively, Find the manometric efficiency.
The 28-in-diameter pump in Fig. at 1170 r/min isused to pump water at 20°C through a piping system at14,000 gal/min. (a) Determine the required brake horsepower.The average friction factor is 0.018. (b) If there is65 ft of 12-in-diameter pipe upstream of the pump, how farbelow the surface should the pump inlet be placed to avoidcavitation?
A hydraulic reaction turbine working under a head of 16 m develops 640 kW of power. What is the unit power of the turbine?
1. Assume a horizontal shaft handling water at 65 deg C (Pv=2.503 KPa, Density=980.5 m3/kg). The suction nozzle is 4.35 m below the pump centerline and the pressure gauge reading at this point is 221Kpag. Determine the NPSHa if the head loss is 0.82 m. If the NPSHr is 3m less than the NPSHa you got on question number 1, determine the pump suction specific speed at pump rotating at 1800rpm and Q=500gpm