A gas consisting of 25% methane, 25% ethane, 30% nitrogen, and the remainder hydrogen gas, by mole What is the theoretical (adiabatic) flame temperature if the mixture is burned with 100% excess air? weather and gas mixture at 25 °C

Q: Diffusion of CO₂ in a Binary Gas Mixture. The gas CO₂ is diffusing at steady state through a tube…

A: Given data: Length of tube = 0.2 m Diameter of tube = 0.01 m Partial pressure of CO2 at one end of…

Q: Assume in the last question,  ∆rG°,  K and ∆rH° at 25°C are -70.11kJ/mol, 1.9×1012  and…

A: Given that:△G =-70.11  KJmol△H =--65.19  KJmolk =1.9  x 1012T1  =25 C=298.5 k T2=670 C=943.15 K

Q: for question C, why is the dot at when the atm is 1 rather than 0.0001?

A: Phase diagram of a compound is given.

Q: A certain gasoline gives a hydrometer reading of 66.5 oBaume at 15.6 oC. Using the Bureau of…

A:

Q: 59: A metal wire of 0.01m diameter and thermal conductivity 200 W/(m.K) is exposed to a fluid stream…

A:

Q: People use 502 lb polystyrene (M = 30200 g/mol) dissolved in 4060 lb styrene (M = 104 g/mol). Find…

A:

Q: Professor Modyn's reactor produces 115.4115.4 mol/s of methanol by the stoichiometric reaction

A: C(s) + ½ O2(g) --> CO (g) ΔHf1 = -110.53 kJ/mol ΔHf2 (H2(g)) = 0 C(s) + ½ O2(g) + 2H2 (g) -->…

Q: percentage of O₂ on a wet basis.

A:

Q: The extent of chemical reaction has the value for all components in the same reaction. O a.…

A: The correct option is to be chosen.

Q: A liquid is contained in a reactor vessel at 115 bar absolute pressure. It is transferred to a…

A: Given that, Absolute pressure in reactor vessel, P1=115 bar=115x105 N/m2 Pressure above liquid…

Q: 8. B. friction factor imbers 7 to 9, e given U-tube manometer, mercury was used in the manometer to…

A: Density of Hg mercury Dhg = 13600 kg/m3 Density of water Dw = 1000 kg/m3

Q: 1. A parallel reaction system looks like the following: 2 A S R In the above reaction system, R is…

A: A parallel reaction is carried out in a CFTSR.

Q: Prepare a Layout of plant items, Process flow sheet and Process Instrumentation diagram of the Vinyl…

A: Introduction Vinyl acetate is a colorless, flammable liquid that also has a characteristic fruity…

Q: 3. Under constant-volume conditions of heat of combustion of glucose,C6H₁2O6, 1s 15.57 KJ/g. A…

A:

Q: Calculate the change in change in Gibbs energy of 15g of ik mass density 0.751 g/cm³) when the…

A:

Q: -3 Q.29 Consider a rigid solid sphere falling with a constant velocity in a fluid. The following…

A:

Q: One of the methods to increase oil recovery from reservoir is injection of Carbone Dioxide. Explain…

A: Oil recovery techniques fall into three categories: 1) Primary oil recovery: It is employed during…

Q: Two hundred mol/h of (CS1112) and 7000 moth of air Ped in to a combusition reactor Calculate the…

A: Given that, Molar flow rate of C5H12 = 200 mol/h Molar flow rate of air = 7000 mol/h It is required…

Q: (a) copy the reaction scheme for the synthesis of glycerol and biodiesel from vegetable oil via…

A: Dear User! Both part(a) and part(b) of the question involve the use of your lab notebook and an…

Q: A process vessel is to be designed for the maximum operating pressure of 500 kN/m². The vessel has…

A:

Q: W = RT₁1₁ (P2 8-1|\P- 8-1 8 -

A:

Q: 4.22 A heat engine absorbs 260 kJ of heat from a source at 325 K and yields a work output of 72 kJ…

A: Given data for the heat engine are as follows: Heat absorbs from source of 325 K = 260 kJ Work…

Q: Butane (C4H10)(C4H10) and dry air are fed to a combustion reactor at a steady rate of 45.9 mol/s45.9…

A: Given that, The molar flow rate of butane in the feed stream nC4H10,F = 45.9 mols The molar flow…

Q: # 1 2 4 5 3 Citric acid 6 7 8 Chemical process/ product manufacture Biodiesel 9 Methanol Aspirin…

A: The question asked is which three topics are easiest for this report writing.

Q: List three types of annealing used in thermal processing of metals, and describe ONE in detail.

A: according to Bartleby's guidelines, I can only solve one question at a time 3) three types of…

Q: Consider the following equilibria: 2SO3(g) 2SO2(g) + O2(g) Kc = 2.3 × 10-7 2NO3(g) 2NO2(g) + O2(g)…

A: Equilibrium constant of a desired reaction is to be calculated using the two given reactions.

Q: 2. According to the wettability picture, answer the following questions: a) The wettability for…

A: With the help of wettability picture, Find a)Wettability for both figures b)Factors that affect…

Q: one hundred fifty kmol of an aqueous phosphoric acid solution contains 5 mole% H3PO4. The solution…

A:

Q: from stoichiometry equation we can say that we have 8 molecules of water PH2OP = NH2ONTotal =…

A: Volume of fuel = 600 L or 0.6 m3 Density of fuel = 0.684 kg/m3 Note: Density of heptane is given…

Q: Calculate the heat required (in kJ,

A:

Q: 2. A gas contains 10% mol anthraquinone in nitrogen at 760 torr and 300 C. To what temperature does…

A: Vapor pressure and temperature data for solid anthraquinone is given.

Q: A continues fractionation column, operation at atmospheric pressure, is to be designed to separate a…

A: A mixture of CS2 and CCl4 is to be separated into distillate and bottom product with the help of…

Q: Follow the standard energy balance steps to determine the water condensed and the heat removed from…

A: a)  b) Degree of freedom analysis Number of unknowns = 4 (Q, n1, n2, y) Number of independent…

Q: 10.3% and flows at the rat alculate: ressure of each component.

A:

Q: How do you know that the final pressure is 1atm ?

A: A mixture of methane, ethane, and propane is burnt in excess air.

Q: Experimental Value of Hoc. Using the experimental data given in Problem 10.6-8, calculate the number…

A: Acetone is absorbed from the air. Operating conditions are, T = 293 K P = 101.32 kPa Packing = 25.4…

Q: Problem 1: Water at 400°C has a specific volume of 0.00700 m³/kg. Determine the pressure of the…

A: given = T = 400^C = 673KV = 0.00700 m3/Kg a) Ideal gas equation   We know that PV=RT Gas…

Q: Consider the following hypothetical chemical reaction: As (aq) + 4B (g) → C(s). An experimental run…

A: Given details, reaction, A+4B→C B consumed ,V=1500 mL=1.5 L P=2 atm T=50 C = 50+273 =323 K…

Q: In a plug flow reactor, a gaseous feed of pure A (2 mol/L, 100 mol/min) decomposes to give a variety…

A: Write the reaction as follows: A→2.5 products   The concentration of pure A, CA0 = 2 mol/L The molar…

Q: sample of coal was found to contain 1% N, 10% ash and 5.8% S. Analysis of the Residue showed uncoked…

A: Given that- Coal composition is- N= 1 % Ash=10% S=5.8% Resdue has uncoked coal with- VCM=20.71%…

Q: Follow the standard energy balance steps to determine the water condensed and the heat removed from…

A: A stream of humid air is fed to a condenser.

Q: Air enters a rectangular duct measuring 30 cm x 40 cm with a velocity of 8.5 m/s and a temperature…

A:

Q: The feed stream to a reactor contains ethylene 16%, oxygen 9%, nitrogen 31%, and hydrogen chloride.…

A:

Q: Example: A 40 kg steel casting ( Cp = 0.5 kJ/kg.K) at a temperature of 450°C is quenched in 150 kg…

A: Given data: Cp,casting = 0.5 kJ/kg.K Mass of the casting = 40 kg Initial temperature of casting =…

Q: Explain in your own words the phase change process at latm condition la 1kg of ice at -30°C to 1kg…

A:

Q: 1. Natural gas composed of 60. mol % methane, 30. mol % ethane, and 10. mol % propane at 25 °C and…

A: Given, The natural gas is composed of 60 mol% methane, 30 mol% ethane and 10 mol% propane.   Write…

Q: Couldn't you use these equations

A: The molar flux of a species (A diffusing through non-diffusing B) is calculated using the following…

Q: A heat exchanger will be used to cool 150 kg/h fruit juice containing 12% dry matter from 80 °C to…

A: A fruit juice is cooled in a heat exchanger with the help of water.

Q: What do you mean by an excess of the reactant?

A: we need to define the term Excess of reactant.

Q: Acrylonitrile is produced in the reaction of propylene, ammonia and oxygen C₂H6 + NH₂ + O₂- C₂H₂N+…

A: Given that- Acrylonitrile production reaction is- C3H6+ NH3+ 32O2→C3H3N + 3H2O Basis feed= 100 mol…