Answered: A hydraulic jack is used to raise a…

A hydraulic jack is used to raise a 10KN car. A force of 400N applied on a 25mm diameter jack plunger. What diameter of jack in mm is required to raise the car?

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter3: Transient Heat Conduction

Section: Chapter Questions

Problem 3.37P

See similar textbooks

Related questions

Q: Given that the weight density of water is 9810 N/m3, calculate the fluid force (in Newtons) on a…

A: Given data :- weight density = 9810 N/m^3 dimension of the plate = 1.1 m× 2.7 m depth = 4 m find the…

Q: Find the compression length of a spring if a 100 pound weight if dropped from 8 ft onto a spring…

Q: 1. A hydraulic press has a ram of 30 cm diameter and a plunger of 4.5 cm diameter. Find the weight…

A: Diameter of ram, D1=30cm⇒0.3m Diameter of plunger, D2=4.5cm⇒0.045m Force applied at plunger, F2=500N…

Q: The quarter circle gate BC in Fig. is hinged at C.Find the horizontal force P required to hold the…

A: Let's consider the gate has unit length. The data given is Radius of the gate, r = 2 m width of…

Q: 4. Note that the gravity acceleration at equatorial sea level is g = 32.088 fps and that its…

Q: 1) Calculate the buoyant force on 10 tons of solid steel completely submerged in water and compare…

A: Given:mass of steel, m=10 tons or 10000 kgdensity of steel, ρ=7800 kg/m3displaced water volume,…

Q: A hydraulic press has a ram of 30 cm diameter and a plunger of 4.5 cm diameter. Find the weight…

A: Data given- Ram diameter = 30 cm Plunger diameter = 4.5 cm Fp = 800 N

Q: Find the work done if a force of 2 N displace crate of box by 2 m

A: Given data : Force=F Displacement=d To find : Work done

Q: A pail and its contents weigh 80 lb. The pail is attached to the end of a 100 ft rope that weighs 10…

A: Any action that can change the state of motion of the object is known as force. The force is…

Q: A 500kg bucket is lifted by a crane at a certain position shown below. What is the magnitude of the…

A: Given data: Mass of bucket, m = 500 kg. Calculate the weight of the bucket, W=mg=500 kg×9.81…

Q: Use Newton's law of universal gravitation to calculate the weight of a 75-kg person standing on the…

A: Newton's law of gravitation can be stated as: WN=G×me×mR2 Here, the gravitational constant is G =…

Q: How much deformation does a mass of 1 kg falling from a height of 6 meters cause to the built-in…

Q: a cylinder that is 500 mm in diameter and 2.0 m long has a specific weight of 535 N/m3 . It is held…

A: given; diameter of cylinder(d)=500mm =0.5mlength of…

Q: a. A rigid object is acted upon by a point on its surface. Explain, with d happens to the object…

A: Given Data→ Rigid body Acted upon by a force applied at a point on its surface.

Q: In a hydraulic press machine the diameters of the effort and load pistons are respectively 25 cm and…

Q: A 10 ft chain weighs 35 lb and hangs from a ceiling. Find the work done (in ft-lb) in lifting the…

Q: In a hydraulic press, the small cylinder has the diameter of 8 cm while the larger piston has the…

A: Given Data The diameter of the smaller piston is: d=8 cm The diameter of the larger piston is: D=22…

Q: A hydraulic press has a ram of 26 cm diameter and plunger of 6.5 cm diameter. How much weight can be…

A: According To Pascals Law, Pressure intensity at a point in any point is equal in any direction i.e,…

Q: Rolex threw a certain type of rock into a freshwater lake. As a dare, one of his friend would need…

A: Submerged body When body is submerged in the water then some force exerted by the water that is…

Q: Find the work done if force 11 N displace object by 1 m

A: Given data : Displacement of object=d Force applied on object=F To find : Work done

Q: The diameters of a small piston and a large piston of hydraulic jack are 2 cm and 10 cm…

Q: What is the magnitude of the Right Reaction force in pounds?

A: GIVEN: F=1.5 kpis =1500 lbf TO FIND: The reaction on the right side. Rb

Q: A 1—ft cable weighing 5 lb / ft supports a safe weighing 500 lb. Find the work done in winding 80 ft…

Q: A 100 ft cable weighing 5 lb / ft supports a safe weighing 500 lb. Find the work done in winding 80…

Q: lem 1. A 6m diameter cylinder rests on the bottom of the tank (lowest point is A) which is 4m…

Q: A 100 kN block slides down a plane inclined at an angle of 30° with the horizontal. Neglecting…

A: Given data as per question Mass of the block =100 kg Inclination angle =300

Q: 2. The large piston in a hydraulic lift has a radius of 250 cm2 . What force (kgf) must be applied…

A: The mentioned unit is in cm2 therefore it is area not radius

Q: Trina is a gym goer with a leg length of 84 cm. Suppose that she is in the gym doing straight leg…

A: GIVEN: Leg length = 84 cm = 0.84 m Distance of the muscle…

Q: *** A force of 75N is applied to a nutcracker to crack open a walnut. If the MA of the nutcracker is…

A: Given:Finput=75 NM.A.=5

Q: 5m 1m Water A wooden beam of specific gravity 0.64 is 150mm x 150mm x 5m is hinged as shown on one…

Q: The diameters of a small piston and a large piston of hydraulic jack are 2 cm and 10 cm…

Q: A rope 17 cm is suspended between two hooks, 13 cm apart and at the same level. What is the pull on…

Q: Weighted piston type accumulator is shown in the figure below. If area=340 cm², a lift of the ram…

Q: Q4. A 50 cm steel rod (cylinder) used for reinforced concrete has a radius of 0.46 cm and it has a…

Q: An elevator is accelerated upward at 2 ft/s², if the elevator weighs 500 lbs, what is the tension in…

A: Given that: Upward acceleration of the elevator = 2 ft/s2 weight of the elevator = 500 lbs It is…

Q: A hollow iron pipe is 21 cm long and its external diameter is 8 cm. If the thickness of the pipe is…

A: Given External diameter = 8 cm Thickness of the pipe = 1 cm

Q: 1.) Show that 1kg-m weights, 1kg-f on earth.

A: We will answer the first question since the exact one is not specified. Please submit a new question…

Q: A triangular sluice gate is fixed to Hinge A as shown below. The weight of the water door is 100N…

A: Draw the free diagram of the gate: Find the distance of center of gravity from free surface:…

Q: A truck weighing 50kN is not moving on a hill which is inclined at 22 degrees to the horizontal.…

Q: Calculate the total force exerted on the outside of a circular submarine window of diameter 30-em at…

A: Given:- Diameter of the window (d) = 30 cm Depth (h) = 1200 m To Find:- Total force exerted (F)

Q: Hamdan Auto uses hydraulic press to raise 3500 kg truck. If the area of the input piston is 10 em…

Q: The bottom of a swimming pool is an inclined plane. The pool is 2m deep at one end and 8m deep at…

Q: Find the height h for mechanical balance by taking the density of water as psu-998kg/m3 and the…

Q: Two spheres, each 1.20 m in diameter, weighs 4kN and 12kN respectively. They are connected with a…

A: Diameter of sphere, d = 1.2 m Weight of first sphere, W1 = 4kN Weight of second sphere, W2= 12 kN

Q: 1. What is the weight of a 12-shig boulder if it is brought to a place where the acceleration due to…

A: Given: The mass of boulder, m = 12 slug The acceleration due to gravity, g = 30.76 ft/s^2

Q: When one boy is sitting 1.20m from the center of a seesaw, another boy must sit on the other side…

Q: piston, on which rests a weight. . A gas is confined in a 1.25(ft) diameter cylinder by a The mass…

Question

A hydraulic jack is used to raise a 10KN car. A force of 400N applied on a 25mm diameter jack plunger. What diameter of jack in mm is required to raise the car?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

Why does an object weigh less on the moon than on earth?
A man weighs 170 lb on the surface of the earth. Compute his weight in an airplane flying at an elevation of 28 000 ft.
1.72 An ice chest (see sketch) is to constructed from styrofoam . If the wall of the chest is 5-cm thick, calculate its -value in . Problem 1.72
The thin-walled cylindrical can with a spherical dimple weighs 0.2 lb. Determine the force P required to push the can into water to a depth of 8 in. Use =0.036lb/in.3 for water.
The figure shows a steel bar being processed by a rolling mill. Given that P=80kN and r =0.016, determine the force F required to advance the bar at a constant speed.
A hollow iron pipe is 21 cm long and its external diameter is 8 cm. If the thickness of the pipe is 1 cm and iron 8/cm^3, then the weight of the pipe is?
The small piston of a hydraulic press has a cross-sectional area of 3cm2, and its larger piston has a cross-sectional area of 200cm2. What downward force must be applied to the small piston for the lift to raise a load of 15KN?
A force of 30 N is applied to the input piston of a hydraulic jack. If the input and output piston have areas of 0.2 m² and 0.8 m², respectively, what is the minimum weight that can be lifted by the jack?
A 300 cc solid weigh 180 grams in water and 240 grams in water and 240 grams in oil whose relative density or specific gravity is 83, Find a) the weight of the solid b) the density of the solid c) the loss of weight in water (Buoyant force in water) d) the loss of weigh-in oil (Buoyant force in oil)
A 500kg bucket is lifted by a crane at a certain position shown below. What is the magnitude of the force that is exerted on the hydraulic piston?
A hydraulic press has a ram of 30 cm diameter and a plunger of 4.5 cm diameter. Find the weight lifted by the hydraulic press when the force applied at the plunger is 800 N
A pail and its contents weigh 80 lb. The pail is attached to the end of a 100 ft rope thatweighs 10 lb and is hanging vertically. How much work is done winding up the rope with the pail attached?