a) In a geotechnical laboratory an oedometer test on a saturated clay soil was conducted. The results in the laboratory report stated that the Ce-0.2, C,-0.04 and OCR = 4.5. The existing vertical effective stress in the field was 130 kPa. A shallow foundation was designed to construct above the soil condition. This will increase the vertical stress at the center of the clay by 50 kPa. The thickness of the clay layer is 2 m and its water content is 28%. Solve the primary consolidation settlement and determine the difference in the settlement if OCR value were 1.5 instead 4.5.

a) In a geotechnical laboratory an oedometer test on a saturated clay soil was conducted. The results in the laboratory report stated that the Ce-0.2, C,-0.04 and OCR = 4.5. The existing vertical effective stress in the field was 130 kPa. A shallow foundation was designed to construct above the soil condition. This will increase the vertical stress at the center of the clay by 50 kPa. The thickness of the clay layer is 2 m and its water content is 28%. Solve the primary consolidation settlement and determine the difference in the settlement if OCR value were 1.5 instead 4.5.

Fundamentals of Geotechnical Engineering (MindTap Course List)

5th Edition

ISBN:9781305635180

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter8: Stresses In A Soil Mass

Section: Chapter Questions

Problem 8.10P: The soil profile at a site consists of 10 m of gravelly sand underlain by a soft clay layer. The...

See similar textbooks

Similar questions

A 300 mm 450 mm plate was used in carrying out a plate loading test in a sand, during which the plate settled 5 mm under the applied pressure of 250 kN/m2. a. What is the coefficient of subgrade reaction for a 300 mm wide square plate? b. What would be the coefficient of subgrade reaction of a 2 m 3 m foundation?
Problem 1. A rectangular foundation 4m x 6m transmits a stress of 100 kPa on the surface of a soil deposit. Plot the distribution of increases of vertical stresses with depth under points A, B, and C up to a depth of 20m. At what depth is the increase in vertical stress below A less than 10% of the surface stress?
The soil profile at a site consists of 10 m of gravelly sand underlain by a soft clay layer. The water table lies 1 m below the ground level. The moist and saturated unit weights of the gravelly sand are 17.0 kN/m3 and 20.0 kN/m3, respectively. Due to some ongoing construction work, it is proposed to lower the water table to 3 m below the ground level. What will be the change in the effective stress on top of the soft clay layer?
The subgrade reaction of a sandy soil obtained from the plate load test (plate dimensions 1 m × 0.7 m) is 18 MN/m3. What will be the value of k on the same soil for a foundation measuring 5 m × 3.5 m?
Q. 12 A soil profile at a certain location is as shown in figure. A rigid circular foundation of 4 m diameter rests on the sand. The contact pressure at the underside of the foundation is 230 kN/m?. The average coefficient of compressibility of the clay is 0.65 × 10-3 m2/kN for the stress range encountered. The ultimate settlement of the foundation assuming 45° load distribution
A square footing foundation, 3 m by 3 m, and positioned on the ground surface of a soil deposit, supports a column load of 1,350 kN. Determine the vertical stress resulting from the foundation loading at a depth 3 m below the base of the footing for locations beneath the center and beneath the edge, assuming:(a) Boussinesq conditions apply.(b) Westergaard conditions apply.
In the soil profile shown, the clay layer is normally consolidated and the ground water location maybe assumed to remain constant. The raft foundation is 15 m x 15 m with a uniform loading of 192 kPa. a) Compute the initial effective stress at the mid-point of clay layer. b) Compute the change in stress at the mid-point of the clay layer if it has an influence factor of 0.90. c) Compute the approximate settlement due to placement of the raft foundation.
Note : This is not an assignment question. Discuss the significance of knowing the vertical stress increase in soil due to various types of loadings.
A planned construction site is underlain by a thick deposit of normally consolidated clay soil. A building foundation 6 ft square will be located on the ground surface and carry a total loading of 180,000 lb. Determine the foundation settlement (beneath center) by analyzing the volume changes due to primary compression in layers that are 2, 4, and 6 ft thick, respectively, from the foundation level downward. For simplification, assume a soil unit weight of 115 pcf constant with depth, an inplace void ratio of 1.05, and a compressio index of 0.35 for each layer analyzed. Use Boussinesq conditions.
Three foundations are located next to each other. Determine the stress increases at A, B, and C at a depth of 2 m below the ground surface.
The initial principal stresses at acertain depth in a clay soil are 200 kPa on the horizontal plane and 100 kPa on the vertical plane.Construction of a surface foundation induces additional stresses consisting of a vertical stress of 45 kPa, a lateral stress of 20 kPa, and a clockwise(with respect to the horizontal plane) shear stress of 40 kPa. Determine the change in shearing stress in kPa.
The initial principal stresses at a certain depth in a clay soil are 100 kPa on the horizontal plane and 50 kPa on the vertical plane. Construction of a surface foundation induces additional stresses consisting of a vertical stress of 45 kPa, a lateral stress of 20 kPa, and a counterclockwise (with respect to the horizontal plane) shear stressof 40 kPa. Determine the change shearing stress in kPa.