a- In the fig shown air entering a diffuserat 70 kpa , 27 °C , with a velocityof 100 m/s. and leaves at 20 m/s. IfAirthe inlet cross section area of 1cm?and the outlet 8.6 cm determinethe exit pressure and temperature ofair.( 1 kJ/kg = 1,000 m/s²)consider the case of ideal gas and CP = 1.004 kJ/kg.

a- In the fig shown air entering a diffuser at 70 kpa , 27 °C , with a velocity of 100 m/s. and leaves at 20 m/s. If Air the inlet cross section area of lcm and the outlet 8.6 cm determine the exit pressure and temperature of air.( 1 kJ/kg = 1,000 m/s²) consider the case of ideal gas and CP = 1.004 kJ/kg.

a- In the fig shown air entering a diffuser at 70 kpa , 27 °C , with a velocity of 100 m/s. and leaves at 20 m/s. If Air the inlet cross section area of lcm and the outlet 8.6 cm determine the exit pressure and temperature of air.( 1 kJ/kg = 1,000 m/s²) consider the case of ideal gas and CP = 1.004 kJ/kg.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Air flows isentropically through a converging nozzle into a receiver where the absolute pressure is 240 kPa. Air enters the nozzle with negligible velocity, 406 kPa (abs.) of pressure, at a temperature of 95 oC. Determine the mass flow rate through the throat of this nozzle wich area is 0.01 m^2.
Consider a converging nozzle, with exit air velocity of Ma=1. What could you do to accelerate the air further?
Assuming the clearance is negligible for a single stage compressor with the following data.Atmospheric pressure: 90 kPaAtmospheric temperature: 17 ˚CDelivery pressure: 7 barFree air delivery flow rate: 0.2 m3/min Take “n” as 1.3, cp = 1.005 kJ/kg K, cv = 0.718 kJ/kg K 1.Evaluate the mass flow rate of air inside the compressor operating isentropically in kg/min to 3 decimal places.
The static and stagnation pressures of a fluid in a pipe are measured by a piezometer and a pitot tube to be 200 kPa and 220 kPa, respectively. If the density of the fluid is 600 kg/m^3, the velocity (in m/s) of the fluid is ?"
Atmospheric air at 101kPa and 20OC is drawn isentropically through a convergent–divergent nozzle of exit area 0.033m2. If the pressure at the nozzle exit is 32kPa, the maximum mass flow rate through the nozzle is ________
Where necessary, assume air as an ideal gas and consider R = 287J/(kg.K), Cp = 1005 J/(kg.K), Cv = 718 J/(kg.K). A nozzle is a device that is used to increase the velocity of a fluidby varying the cross-sectional area. At the last section of a jetengine (Fig Q1.a, section 5), air with a mass flow rate of 50 kg/s ata pressure of 500 kPa and a temperature of 600 K enters a nozzlewith an inlet cross-sectional area of 5 m2. The exit area of thenozzle is 20% of its inlet area. The air leaves the nozzle at avelocity of 300 m/s. The nozzle is not well-insulated and duringthis process, 5 kJ/kg heat is lost. (iv) Determine the temperature of the air as it leaves the nozzle.(v) Calculate the pressure of the air as it leaves the nozzle.
Air at 1 MPa and 600°C enters a converging nozzle with a velocity of 150 m/s. Determine the mass flow rate through the nozzle for a nozzle throat area of 50 cm2 when the back pressure is (a) 7 MPa and (b) 4.0 kg/cm?.
Air flows into a turbine at a rate 30 [m 3 /s], a temperature of 1100 [K] anda pressure of 300 [kPa]. The turbine’s work output is 200 [kJ/kg]. Determine thetemperature of the air at the exit, the power output in [kW] and the isentropicefficiency. The pressure ratio of the turbine is 3. The specific gas constant, R, for airis 0.287 [kJ/kg-K].
What is the difference between Inlet velocity and superficial velocity?
A 0.2 m3 vessel contains 1265 kg of water at 90 ⁰C. Determine pressure, specific and total internal energy, specific and total enthalpy, and specific and total entropy
Consider a turbojet-powered airplane flying at a standard altitude of 4 km. The inlet and exit areas are 0.82 m^2 and 0.45 m^2. The velocity, pressure, and temperature of the exhaust gas are 300 m/s, 230,000 Pa, and 830 K, respectively. Calculate the thrust of the turbojet. Detailed solution pls
Q1: Air is isentropically expanded from initial values 1500 kPa and 60°C to 400 kPa. What is the ratio of the initial to final speed of sound? R= 0.287 kJ/kg-K and k 1.4