A laser beam (2 = 694 nm) is incident on two slits 0.100 mm apart. Approximately how far apart (in m) will the bright interference fringes be on the screen 5.00 m from the double slits? O 3.47 x 10-5 О 347 х 10-3 О 347 х 10-2 O 3.47 x 10-6

A laser beam (2 = 694 nm) is incident on two slits 0.100 mm apart. Approximately how far apart (in m) will the bright interference fringes be on the screen 5.00 m from the double slits? O 3.47 x 10-5 О 347 х 10-3 О 347 х 10-2 O 3.47 x 10-6

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter35: Diffraction And Interference

Section: Chapter Questions

Problem 44PQ

See similar textbooks

Related questions

Q: 4 Conductivity of Select Materials Conductivity Material (1/(2 m)) Aluminum 3.77 x 107 Copper 5.95 x…

A: If conductivity of material will be large then it's resistance will be low and therefore energy…

Q: Consider 3 point charges at the corners of a triangle, as shown below, where q1 = 6.00 x 109 C, q2 =…

Q: An oil refinery uses a Venturi tube to measure the flow rate of gasoline. The density of the…

Q: A vertical plate in the shape of a rectangle is submerged in water. The top of the rectangle is 3…

Q: The figure shows a two-ended "rocket" that is initially stationary on a frictionless floor, with its…

A: (a) Here, The velocity of block L (in the frame of reference indicated in the figure) is (v1 -…

Q: Four particles, each of mass 0.15 kg, are placed at the vertices of a square with sides of length…

Q: ich of the following is increased when light waves pass from a dense to a less dense medium a)…

A: When light waves pass from a dense to a less dense medium

Q: A steel rod (p = 7860 kg/m³) has a length of 3.31 m. It is bolted at both ends between immobile…

A: Taking, Y = 2×1011N/m2 α=10−5/oC Q= 3130 J Heat capacity of steel, S =…

Q: 10. What is the (a) momentum (b) speed, and (C) de-Broglie wavelength of an electron with kinetic…

A: Given, Kinetic energy of an electron, KE = 120 eV charge on an electron, q = 1.6×10-19 C mass of an…

Q: This time we have a non-rotating space station in the shape of a long thin uniform rod of mass 4.07…

Q: What is the (a) momentum (b) speed, and (C) de-Broglie wavelength of an electron with kinetic energy…

Q: A ball is vertically launched. Where is the most kinetic energy? Where is the ball–Earth system's…

Q: A laser beam (2. = 694 nm) is incident on two slits 0.10 m) will the bright interference fringes be…

A: wavelength = 694 nm = 694 x 10-9 m distance between slits = d = 0.1 x 10-3 m distance from slits to…

Q: How much tension must a rope withstand if it is used to accelerate a 1910-kg car horizontally along…

A: Given: The mass of the car is 1910 kg. The acceleration of the car is 1.4 m/s2.

Q: The loudest sound produced by a living organism on Earth is made by the bowhead whale (Balaena…

Q: A stone is released from a height of 180 m, reached the ground with the speed of 60m/s. How long did…

A: height of stone, s= 180 m final velocity of stone near ground, v=60 m/s let t be the time taken

Q: A bar of aluminum (bar A) is in thermal contact with a bar of iron (bar B) of the same length and…

Q: A block of mass 1.86 kg is placed on a frictionless floor and initially pushed northward, whereupon…

Q: S A bolt with a 1.25 cm radius needs to be tightened to a torque of 75 m N. A wrench that has a…

Q: Horizontal Displacement (m) +9.8 --9.8 -9.8 -9.8 D) -9.8 -9.8 4. Our equations of motions for…

A: Given Initial speed for all three projectiles are same We have to find which projectile take longer…

Q: What is the gauge pressure in (a) kPa, and (b) N/cm2, at a distance 5.5 ft below the surface of a…

A: Given: The height of the water column is 5.5 ft = 1.6764 m.

Q: In the figure, block 1 of mass m, slides from rest along a frictionless ramp from height h = 2.5 m…

Q: If electric and magnetic field strengths vary sinusoidally in time, being zero at t = 0, then E =…

Q: is the (a) momentum (b) speed, and (C) de-Broglie wavelength of an electron with kinetic energy of…

A: Momentum is the product of the mass and velocity of an object. Here, we calculate the given as…

Q: ball thrown horizontally at 13.0 m/s from the roof of a building lands 22.0 m from the base of the…

Q: Gniven ola.ta. CA f ball = 21 : 2Ko Mass Velority Find Kinedtic energy orf =ms

A: Given data : Mass of boll = m Velocity of boll = v…

Q: In unit-vector notation, what is the net torque about the origin on a flea located at coordinates…

Q: A schematic of a homemade hydraulic jack is shown in the figure below, with cylindrical tube ends of…

Q: A student set up a simple circuit with an ohmic lightbulb, battery and switch. When the switch is…

A: initial voltage = V1= 4.2 V initial current = I1= 527 mA voltage = V2= ? V Final current = I2= 397…

Q: Q. A square aperture of 0.3 mm size is illuminated with light from a He-Ne laser (632 nm…

Q: This figure shows a double slit located a distance x from a screen, with the distance from the…

Q: A particle travels along a path where y = 8x3. The particle increases height with y = 27t3 where t…

Q: Consider a non-rotating space station in the shape of a long thin uniform rod of mass 4.08 x 10^6 kg…

Q: Why does carbon dating not give any useful data for dinosaurs?

A: Carbon dating is a technique to calculate the age of old objects by measuring the amounts of…

Q: If an x-ray field is 6 x 8 inches at 40 SID, at what SID would the field measure 15 x 20 inches?

A: X-rays are a type of radiation called electromagnetic waves. X-ray imaging creates pictures of the…

Q: A bowling ball traveling with constant speed hits the pins at the end of a bowling lane 16.5 m long.…

Q: A circular coil enclosing an area of 200 cm2 is made of 210 turns of copper wire. The wire making up…

Q: Problem 1: Suppose a man does 35.5 kJ of work with an efficiency of 4.95 %. How much food energy, in…

Q: A block of an unknown material floats in water with 54% of it below the surface. What is the density…

Q: Two slits separated by 0.10 mm are illuminated with green light (2 = 540 nm). Calculate the distance…

Q: How do you decide on a unit of measurement for a physical quantity

A: Unit of a physical quantity is defined as the established standard used for comparison of the given…

Q: What minimum speed would a rocket need to leave Earth's orbit if fired instead of a cannonball

A: The minimum velocity that needed to launch an object into space so that it does not return back to…

Q: A parallel plate, air filled capacitor, has plates of area 0.55 m2 and a separation of 0.05 mm. What…

Q: The threshold of hearing is defined as the minimum discernible intensity of the sound. It is…

A: Intensity, I = 10-12 W/m² Power, P = 0.06 W Distance from the car at which the sound from the stereo…

Q: A block of an unknown material floats in water with 13% of it below the surface. What is the density…

Q: hat is the highest-order maximum for 410 nm light falling on double slits separated by 25.0 µm? =___

A: Given that The wavelength of the light is λ = 410 nm The separation…

Q: 3. Consider three points in the path of a certain projectile as shown in the diagram at the right.…

Q: A capacitor holds a charge Q while in a circuit with a voltage supply V. If the distance between the…

Q: A 2.25 kg hoop rolls without slipping across a level surface, translating at 4.25 m/s. If the hoop's…

Q: Name and define the S.I. unit of mass

A: Dear student Mass is a fundamental quantity. As it does not depend on any other quantities.

Concept explainers

Diffraction of light

In physics, the term diffraction is defined as the bending of light around the corners of the obstacle. As a light ray passes by an aperture, it bends around the edges or through slits, it spreads out through a narrow opening. The diffracted light will produce fringes of bright and dark or colored bands which are labeled as a diffraction pattern.

Question

100%

A laser beam (2 = 694 nm) is incident on two slits 0.100 mm apart. Approximately how far apart (in
m) will the bright interference fringes be on the screen 5.00 m from the double slits?
3.47 x 10-5
O 3.47 x 10-3
3.47 x 10-2
3.47 x 10-6
O 3.47 x 10-4

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

$Diffraction of light$

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

A beam of monochromatic green light is diffracted by a slit of width 0.550 mm. The diffraction pattern forms on a wall 2.06 m beyond the slit. The distance between the positions of zero intensity on both sides of the central bright fringe is 4.10 mm. Calculate the wavelength of the light.
A Fraunhofer diffraction pattern is produced on a screen located 1.00 m from a single slit. If a light source of wavelength 5.00 107 m is used and the distance from the center of the central bright fringe to the first dark fringe is 5.00 103 m, what is the slit width? (a) 0.010 0 mm (b) 0.100 mm (c) 0.200 mm (d) 1.00 mm (e) 0.005 00 mm
Two slits are separated by 0.180 mm. An interference pattern is formed on a screen 80.0 cm away by 656.3-nm light. Calculate the fraction of the maximum intensity a distance y = 0.600 cm away from the central maximum.
A monochromatic beam of light of wavelength 500 nm illuminates a double slit having a slit separation of 2.00 105 m. What is the angle of the second-order bright fringe? (a) 0.050 0 rad (b) 0.025 0 rad (c) 0.100 rad (d) 0.250 rad (e) 0.010 0 rad
Red light (wavelength 632.8 nm in air) from a Helium-Neon laser is incident on a single slit of width 0.05 mm. The entire apparatus is immersed in water of refractive index 1.333. Determine the angular width of the central peak.
Monochromatic light is incident on a pair of slits that are separated by 0.200 mm. The screen is 2.50 m away from the slits. a. If the distance between the central bright fringe and either of the adjacent bright fringes is 1.67 cm, find the wavelength of the incident light. b. At what angle does the next set of bright fringes appear?
Eight slits equally separated by 0.149 mm is uniformly illuminated by a monochromatic light at =523 nm. What is the width of the central principal maximum on a screen 2.35 m away?
A monochromatic light of unknown wavelength is incident on a slit of width 20 m. A diffraction pattern is seen at a screen 2.5 m away where the central maximum is spread over a distance of 10.0 cm. Find the wavelength.
In Figure P37.18, let L = 120 cm and d = 0.250 cm. 0T he slits are illuminated with coherent 600-nm light. (Calculate the distance y from the central maximum for which the average intensity on the screen is 75.0% of the maximum.
A spacer is cut from a playing card of thickness 2.90 104 m and used to separate one end of two rectangular, optically flat. 3.00-cm long glass plates with n = 1.55, as in Figure P24.24. Laser light at 594 nm shine straight down on the top plate. The plates have a length of 3.00 cm. (a) Count the number of phase reversals for the interfering waves. (b) Calculate the separation between dark interference Kinds observed on the lop plate.
In Figure P36.10 (not to scale), let L = 1.20 m and d = 0.120 mm and assume the slit system is illuminated with monochromatic 500-nm light. Calculate the phase difference between the two wave fronts arriving at P when (a) = 0.500 and (b) y = 5.00 mm. (c) What is the value of for which the phase difference is 0.333 rad? (d) What is the value of for which the path difference is /4? Figure P36.10
Two slits are separated by 0.320 mm. A beam of 500-nm light strikes the slits, producing an interference pattern. Determine the number of maxima observed in the angular range 30.0 30.0.