A long solenoid with a circular cross section has n turns per unit length and radius R. The current in its windings increases at a constant rate such that = B. Find the magnitude of the induced electric field at a distance routside the solenoid. (r > R)a.HorBHyTBRe.2rO O o O •

step-1*A long solenoid with circular cross-section hes 'n' turns per unit length.*The current…

A long solenoid with a circular cross section has n turns per unit length and radius R. The current in its windings increases at a constant rate such that d = B. Find the magnitude of the induced electric field ata distance r outside the solenoid. (r > R) Anir O a. 2xR Ob. O c. Od. HnBR Oe.

A long solenoid with a circular cross section has n turns per unit length and radius R. The current in its windings increases at a constant rate such that d = B. Find the magnitude of the induced electric field ata distance r outside the solenoid. (r > R) Anir O a. 2xR Ob. O c. Od. HnBR Oe.

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter13: Electromagnetic Induction

Section: Chapter Questions

Problem 72AP: A long solenoid of radius a with n turns per unit length is carrying a time-dependent current...

See similar textbooks

Similar questions

A long solenoid of radius a with n turns per unit length is carrying a time-dependent current I(t)=I0sin(t) , where I0and are constants. The solenoid is surrounded by a wire of resistance R that has two circular- loops of radius b with b>a (see the following figure). Find the magnitude and direction of current induced in the outer
The conducting rod shown in the accompanying figure moves along parallel metal rails that are 25-cm apart. The system is in a uniform magnetic field of strength 0.75 T, which is directed into the page. The resistances of the rod and the rails are negligible, but the section PQ has a resistance of 0.25 . (a) What is the emf (including its sense) induced in the rod when it is moving to tire right with a speed of 5.0 m/s? (b) What force is required to keep the rod moving at this speed? (c) What is the rate at which work is done by this force? (d) What is the power dissipated in the resistor?
A reasonably uniform magnetic field over a limited region of space can be produced with the Helmholtz coil, which consists of two parallel coils centered on the same axis. The coils are connected so that they carry the same current I. Each coil has N turns and radius R, which is also the distance between the coils, (a) Find tire magnetic field at any point on the z-axis shown in the accompanying figure, (b) Show that dB/dz and d2Bdz2 are both zero at z = 0. (These vanishing derivatives demonstrate that the magnetic field varies only slightly near z = 0.)
In the circuit sho in the accompanying figure, the rtd slides along the conducting rails at a constant VelOCity v. The velocity is in the same plane as the rails and directed at an angle 6 to them. A uniform magnetic field Bis directed out of the page. What is the emf induced in the r?
The accompanying figure shows a metal disk of inner radius r1 and other radius r2 rotating at an angular velocity while in a uniform magnetic field directed parallel to the rotational axis. The brush leads of voltmeter are connected to the dark's inner and outer surfaces as shown. What is the reading of the voltmeter ?
A rectangular copper ring, of mass 100 g and resistance 0.2 1, is in a region of uniform magnetic field that is perpendicular to the area enclosed by the ring and horizontal to Earth’s surface. The ring is let go from rest when it is at the edge of the nonzero magnetic field region (see below). (a) Find its speed when the ring just exits the region of uniform magnetic field. (b) If it was let go at t = 0, what is the time when it exits the region of magnetic field for the following values: a=25cm,b=50cmB=3T , and g=9.8m/s2 ? Assume the magnetic field of the induced current is negligible compared to 3T.
Two long, parallel wires cy equal currents in opposite directions. The radius of each wire is a, and the distance between the centers of the wires is d, Show that if the magnetic flux within the wires themselves can be ignored, the self-inductance of a length 1 of such a pair of wires is L 0 l in d1 a (Hint Calculate the magnetic flux through a rectangle of length 1 between the wires and then use L=N/I
Determine the magnetic field on the central axis at the opening of a semi-infinite solenoid. (That is, take the opening to be at x = 0 and the other end to be at x= .)
The accompanying figure shows a conducting ring at various positions as It moves througli a magnetic field. What is the sense of the induced em! for each of those positions?
The normal to tt plane of a single-turn conducting loop is directed at an angle to a spatially uniform magnetic field B. It has a fixed area and orientation relative to the magnetic fleck Show that the emf induced In the loop is given by i = (dB/dt)(Acos),where A is the area of the loop.
Check Your Understanding What Is the magnitude of the induced electric field in Example 13.8 at t=0 if r= 6.0cm, R= 2.0cm,n = 2000 turnspermeter, I0= 2.0A, and a = 200s-1?
Shown below is a long rectangular loop of width w, length l, mass m, and resistance R. The loop starts tram rest at the edge of a uniform magnetic held B and is pushed into the Held by a constant force F function of time.