A power station is designed to meet the load requirements of the consumers. Describe THREE (3) types of consumer loads and briefly explain the effect of variable load towards the operation of a power plant.

Q: An antenna used for transmitting has a power gain of 20, directive gain of 22, and an input power of...

A: Note:  As per the  guide lines of the bartleby we are supposed to solve 3 questions, when they are  ...

Q: With a neat logic diagram and shifting table, explain the shifting of given bit stream 1011001 enter...

A:

Q: Evaluste VCH in the transistor circuit ahown below. The transistor is of silicon and has B-150.

A: Disclaimer:  Since you have asked multiple questions, we will solve the first question for you. If y...

Q: Given resistors having the following color codes (as read from left to right), determine the resista...

A:

Q: Čalculate the THD for a repetitive wave with fundamental frequency amplitude of 10VRMS, second harmo...

A:

Q: 3. If the current flowing through an element is given by 3t A, 0<t<6 s 16A, 6<t < 10 s -12A, 10 <t< ...

A: The solution is given below 

Q: The current in a 960 W, 240 V heater operated at 200 V is ?

A: Given a heater having, Rated power, P = 960 W Rated voltage, V = 240 V Applied voltage, Vs = 200 V

Q: Use superposition to find the voltage v, in the circuit shown. 3 A 10Ω ww + V, 40 V (+ 10 Ω 2V

A: In this question,  We need to calculate the voltage Vx in the given circuit using the super position...

Q: Find the resistance of a conductor at 500 degrees Celsius given that its temperature coefficient at ...

A: 1. It is given that: R1=200 ΩT1=420°CT2=500°CT=0°Cα=1420/°C        

Q: For a semiconductor with a constant mobility ratio b=μ n /μ p &gt;1independent of impurity concentra...

A: Resistivity: It is the property of a material measures that how strongly it resist the current. Its ...

Q: 5Ω -j10 Ω 2Ω ww 60/120° V j20 2 Find Norton's Current. ll

A: This question belongs to circuit theory . It is based on the concept of Norton's theorem . Problem c...

Q: A certain temperature sensor experience a change in electrical resistance with temperature according...

A:

Q: Fourier Transform of x(t) is X(w) where X(w) has non-zero values for -2<w<2. Fourier Transform of y(...

A:

Q: 15. Find Vo. 35 V 2.2k Ohm Vo 18 M Ohm VGS(TH) = 5V VGS(ON) = 10V ID(on) = 3 mA 20 mv %3D yos = 20 u...

A:

Q: Given the following Resistances and Inductors in Series and Voltage Source: R1 = 14 ohms R2 = 20 o...

A:

Q: 10 0.05H 20 0.1H 50pF 0200V,50HZ O-

A:

Q: A 3-phase induction motor is running at 2% slip. If the input to rotor is 1000 W, then mechanical po...

A: Given a 3-phase induction motor is running at, Slip, s = 2 % = 0.02 Input power of rotor, Pin=1000 W...

Q: Construct and explain the operation of the following ripple counters with positive edge triggered D ...

A: Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for yo...

Q: 6. A short 3-phase, 34-kV power transmission line delivers a load of 10-MW at a power factor of 0.9 ...

A: The solution is given below 

Q: A receiver has a noise temperature of 150 K. What is its noise figure in decibels? a1.29 dB b.9.21 d...

A: The solution is given below 

Q: æ (t) = cos(50rt)is sampled at 40 Hz. The samples are then passed through a perfect low pass filter ...

A:

Q: 5. The following figure shows the eight-bit Adder-Subtractor. Your inputs for this combinational cir...

A:

Q: 2-Draw the equivalent circuit of single-phase Transformer ,and write each value on it. ?

A: Equivalent circuit of the single phase transformer is given below

Q: Consider the following second-order, SISO linear system with no input, described in terms of its out...

A: The equation are given asy..+4ty.+2t2y=0-----1a)lety=x2y.=x.2=x1y..=x.1from equation 1x.1=-2t2x2-4tx...

Q: Draw a full adder using only NAND gates.

A:

Q: a. Determine the time constant. b. Write the mathematical expression for the current i̟ after the sw...

A: In this question we will find inductor current and inductor voltage at different times...

Q: The plates of thickness 1.5mm is joint by two 3.0mm diameter rivets as shown in the figure. Calculat...

A: We have given; The plates of thickness 1.5mm  diameter =3.0mm stress in the plates is limited to 15 ...

Q: H.W. For the circuit shown below, calculate the value ofRL which absorbs maximum power and then calc...

A:

Q: design a shift register which performs 1. Parallel load function, when input 00 will be applied in S...

A: It is required to construct a shift register that accomplishes the following functions:  (a) When in...

Q: a. For the network below, determine lg, Ic. VE and VCE

A: The required parameter for the given voltage divider bias circuit can be calculated by using the DC ...

Q: A coil of wire of resistace 50 ohm is embeded in a block of ice. What is the amount of ice melted in...

A:

Q: Use the node-voltage method to calculate the power delivered by the dependent oltage source in the c...

A:

Q: 2. Find the total current of the charge graph below q (C) A 10 1 2 4 t(s)

A: Given

Q: Question 12 of 28 Fill in the blanks: 12 V Si GaAs 4.7 k2 Vo= V, 1 decimal Which diode is OFF? Si or...

A:

Q: 3Ω 3Ω 15 V 4 A

A: For the calculation of Norton resistance We need to replace the voltage source by short circuit bran...

Q: 2.A three-phase, three-wire system, with an effective line voltage 100 V, has currents IA Ic = 15.41...

A: This question belongs to electrical power system . It is based on the concept of delta connected bal...

Q: What's the required bend radius for three-conductor, 3/0 AWG service entrance cable that's approxima...

A: Given, Three-conductor, 3/0 AWG service entrance cable that's approximately 1 inch in diameter.

Q: When would you use a pressure transducer coupled to an oscilloscope?

A: Pressure Transducer: Pressure transducer is an instrument which converts an applied pressure into a...

Q: Fill in the blanks: 12 V Si GaAs 4.7 k2 Vo= V, 1 decimal Which diode is OFF? Si or GaAs

A:

Q: Consider the system defined by i = Ax + Bu y = Cx 1 where, A = 1 -6 -11 -6| B = |0| and C =[10 5 1] ...

A: Given a system defined by x˙=Ax+Buy=Cx where, A=010001-6-11-6B=101C=1051

Q: Problem 2.24: If a system known to be linear and time-invariant has the response to x(t) = u(t) give...

A: The solution is given below 

Q: 3.. A coil of 1000 turns is uniformly wound on a ring of non-magnetic material, the mean diameter be...

A: self inductance of the coil = number of turns2×permebility×area of the coremean length of the core. ...

Q: Q1) Reduce the block diagram shown below and write the transfer function C(s) /R(s) Cls) G2 (s) Ge G...

A:

Q: If the power factor is 1/10 and the value of impedance is 20 ohm, calculate the resistance in the ci...

A: Given, Power factor, cosϕ=110 Impedance, Z=20 Ω  

Q: prove in Parkial dereuation Cis)= =- (2/7)+

A: In this question,  We need to prove that the partial fraction of the given system. This function is ...

Q: The current in a 960 W, 240 V heater operated at 200 V is ?

A: Consider the formula for resistance is, P=V2R Solve for the resistance as, 960 W=240 V2RR=240 V2960 ...

Q: G4 R(s) C(s) G G3 Hz

A:

Q: 120 20 Inad" 120 (e)

A:

Q: Using Gauss Jordan Elimination What is the value of i2? What is the value of i1? What is the pow...

A: Given,

Q: 3. Determine the voltage across R2 for the first and second diode approximations. Diode: Si, r = 10 ...

A:

Operational Amplifier

An operational amplifier also called op amp is an integrated circuit or analog circuit that takes input as a differential voltage and produces output as a single-ended voltage. It is an IC that can amplify weak electric signals.An op amp has one output pin and two input pins. The basic role of an opamp is to amplify the voltage difference between the two input voltages. It is also used in filtering or to perform mathematical operations or in signal conditioning.