prove in Parkial dereuation Cis)= =- (2/7)+

Q: The following data were obtained when a 25 kVA, 2300/460 V, 50 Hz transformer was subjected to open-...

A:

Q: ) Using the information provided in Figure 2, find the branch resistors R1 and Rs, the total resista...

A:

Q: A water jet cinsume 3450 W for 126 hours a week.  1. What is the energy consumed (kWh) for one-year...

A:

Q: Given the full-wave rectifier circuit shown below and given that the diode is made up of Silicon and...

A: According to Bartleby guidelines we are supposed to solve the first 3 subparts at a time kindly repo...

Q: What are the expected readings of the following in the figure below? (R640 0, Av7.00 V) R. AV 10.0 0...

A:

Q: Express the Boolean function, F(X, Y, Z) = Z' + XY', as a) a sum of Minterms b) a product of Maxt...

A: The given boolean function is shown below: FX,Y,Z=Z+XY¯

Q: 2. Determine the energy gap for Germanium at 45 °C

A: 2. Determine the energy gap for Germanium at 45°C ?

Q: Write solutions neatly so I can understand. Thankyou very much! guaranteed thumbs up !!!!

A: Electrical machines can be either generator, transformer or motors. They can be either Ac machines o...

Q: A resistance of 20 ohms and an unknown capacitance are connected in parallel across a 110 V, variabl...

A:

Q: ) Consider He following system %3D a) find the equili brium points of Hhe nonhincar syskem b) plot p...

A: In this section multipart question i have done only one part. Nonlinear systems are frequently appro...

Q: Describe an inductor and the how an inductor stores energy

A: Inductor is a passive bilateral element which has two terminals and it is wound in the form of coil....

Q: Q3/ Using nodal analysis, find the branch currents in circuit below. V3 12 8 R1 R3 R5 10 V1 12 R2 6....

A:

Q: 7-15 An FM tone-modulated signal has a frequency deviation of 12 kHz and a modulating froquency of 2...

A: This question belongs to basic  communication system . It is based on the concept of FM tone modulat...

Q: Please provide a full solution, draw an illustration, and label each resistor. A circuit consisting...

A: The solution is given below 

Q: 40/60° V V1 4Ω V2 30/0° V j4 Q -j1 N 2 2 Calculate V1 and V2 in the circuit shown.

A: This problem comes under electrical network theory . It is based on the super node concept . By usin...

Q: A choking coil of inductance 0.08 H and resistance 12 ohms, is connected in parallel with a capacito...

A:

Q: An LTI Sys tem described the defference Equation Iyin-2)=25n) is intially 16 write the tranefer fund...

A: Given  Difference equation of the LTI system  y(n)-116y(n-2)=x(n)

Q: Determine the output of the LTI system for the input x n and impulse response of the system hn] h[n]...

A: Givenxn={2,7,1,5}h[n]={6,2,5,9,1}

Q: A coil has a resistance of 4 ohms and an inductance of 2H. It is connected to a 20V dc supply. Calcu...

A: Given: A coil have Resistance, R=4 Ω Inductance, L=2 H Supply V=20 V dc

Q: Question 1 Find the current, I which pass through 52 resistor by using Norton equivalent circuit. 2Ω...

A:

Q: Three identical capacitors of 15 micro farad are connected in star across a 425 volts, 50HZ, 3-phase...

A: Three identical capacitors are linked in a star configuration with a supply voltage of 400 volts, 50...

Q: 10 Ω 24 2 50 Ω ww 25 2 15 V 20 Ω 30 2 60 Q 20 Q ww ww

A:

Q: Problem 1 What elevation or height of a column of mercury will cause a pressure of 667.08 kPag?

A: Given, Gauge pressure (Pg) = 667.08kPag i.e kilo Pascal gauge  

Q: A choking coil of inductance 0.08 H and resistance 12 ohms, is connected in parallel with a capacito...

A:

Q: A ring having a cross-sectional area of 500 mm?, a circumference of 400 mm and D=800microWb has a co...

A:

Q: 1. Find the equivalent capacitance across the terminals of the circuit in figure below 2.7 uF 2.7 uF...

A:

Q: Define in your own words what is a small signal FET when it comes to Av, Ai, ri, ro of the circuit.

A:

Q: 3. Explain Moving coil instrument with principle, operation, advantages, disadvantages and diagram. ...

A: Voltmeters are used to measure the voltage. Ammeters are used to measure the current in an electrica...

Q: Please find I and V values (Diodes are made of Si).

A: The given circuit is shown below:

Q: What is the dominant lower critical frequency of a three-stage amplifier in which fcl = 50 Hz for ea...

A:

Q: Q4 // Write the Boolean algebra laws for OR gates?

A: OR gate - A two input OR gate will give you a logic 1 output if EITHER or BOTH of its input are at l...

Q: A given load takes 40 kVA at 50 % lagging power factor while another load connected in parallel acro...

A:

Q: a) Design an NMOC inverter with a resistive load (Find the value of R and W/L) for VDD = 5 V and P =...

A: Given the circuit, as shown below: a) We need to design an NMOS inverter with a resistive load for ...

Q: 1 Obtain C(0.5), C(1.5) and C(2.5) under unit impulse input using the modified z-transform. (T=1) R(...

A: The block diagram is shown below,

Q: R, 5 kN 12 – R2 R3 1 kN 14 1 kN 15 + Vs R5 V5 R4 V4 5 kN 1 kN

A: Referring to the circuit below, Ammeter is connected in series with 16V source while a voltmeter is ...

Q: 1 out of 3 attemp Find the bandwidth and center frequency of the bandstop filter of the figure. Roun...

A: Given circuit,  

Q: 1. Identify the different symbols seen in the schematic diagram. Write it in a piece of paper and ca...

A: The given circuit is as shown below, We need to identify the symbols in the circuit and make a bloc...

Q: A hydropower station has a gross head of 14.4 meter Head loss in water conductor system is 0.5 meter...

A: According to Bartleby guidelines we are supposed to solve only 3 subparts at a time kindly repost th...

Q: Situation: An SUV is parked along the side of a roadway, while a van is traveling adjacent to the SU...

A: For SUV -The initial velocity is zero.The acceleration is a and total time taken is T.For van - The ...

Q: How to convert between transfer function and state-space models

A: Transfer functions and state space models- Transfer functions and state space models are mathematica...

Q: If “A”V=28,“B” V“=25,A1”A=47,“A2”A=93 1/The expected value of the voltage across a resistor is ‘A’V....

A: “Since you have asked multiple question, we will solve the first question for you. If you want any s...

Q: A two-core feeder 138 kilo meter long supplies a maximum current of 142 A at 400 volts. The demand i...

A:

Q: Electrical Engineering (1-item problem): R a R R Vị R v. Problem 1 a. Derive an expression for the e...

A:

Q: Two impedance Z, = 2+j3 and Z, = 3 +j6, are connected in parallel. The apparent power of the second ...

A:

Q: If the variable DC source is reversed, how does this affect the clipping?

A: Clipping - Clipping is another name for distortion. Any rapid change in a voltage or current associa...

Q: 1. What is the difference between Miswire and short in the cabling?

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source, eithe...

Q: 3. Using KVL method, find the current supplied by 12 V battery. R3$120 10 V E," 12 V Figure 4

A:

Q: Solve: (1-item) If R; = 27 Q and R2 = 66 N, determine the equivalent resistance of the circuit in oh...

A:

Q: *11. Find Vs for the network of Fig. 7.84. 20 V 2.2 k2 Ipss = 4.5 mA Vps Vp =-5 V I ss = 6 mA Vp = -...

A:

Q: An electronic device has a resistance of 30 Ohms and a current of 20,500 mA. What is the voltage acr...

A: The resistance of the device is given as, R=30Ω And, the current through the device is, I=20,500 mAI...

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.