A pressurized tank contains water with some air above it. As shown on figure below. Multi-fluid manometer is used to determine the pressure at the air-water interface If hi= 0.7 m, h2= 0.4 m, h3= 0.55 m and ha 0.85 m. Also, specific gravity of water = 1 and specific gravity of crude oil = 1.8 and specific gravity of mercury = 12.5 and specific gravity of shale oil = %3D 2.5 Determine the absolute pressure at point 5 in Pascal unit. [Given: g=9.81 m/s? and atmospheric pressure 101300 Pa] Mercury S.G. 12.5 Water S.G. 1 h Crude oil Shale oil S.G. 18 S.G. 2.5

A pressurized tank contains water with some air above it. As shown on figure below. Multi-fluid manometer is used to determine the pressure at the air-water interface If hi= 0.7 m, h2= 0.4 m, h3= 0.55 m and ha 0.85 m. Also, specific gravity of water = 1 and specific gravity of crude oil = 1.8 and specific gravity of mercury = 12.5 and specific gravity of shale oil = %3D 2.5 Determine the absolute pressure at point 5 in Pascal unit. [Given: g=9.81 m/s? and atmospheric pressure 101300 Pa] Mercury S.G. 12.5 Water S.G. 1 h Crude oil Shale oil S.G. 18 S.G. 2.5

Engineering Fundamentals: An Introduction to Engineering (MindTap Course List)

5th Edition

ISBN:9781305084766

Author:Saeed Moaveni

Publisher:Saeed Moaveni

Chapter10: Force And Force-related Variables In Engineering

Section: Chapter Questions

Problem 20P

See similar textbooks

Similar questions

SAE 30 oil is contained in a cylinder with inside diameter of 1 in. and length of 1 ft. What is the pressure required to decrease the volume of the oil by 2%?
An astronaut has a mass of 68 kg. What is the weight of the astronaut on Earth at sea level? What are the mass and the weight of the astronaut on the Moon, and on Mars? What is the ratio of the pressure exerted by the astronauts shoe on Earth to Mars?
As shown in the figure, water flows in the horizontal pipe. The pipe consists of two different sections, 60 mm and 30 mm in diameter, connected by a smooth reduction. The pressure difference between the two sections is measured with a mercury manometer. Friction effects are neglected. The height between the mercury levels in the two sections of the pipe was determined as 1.4m. Find the velocity and mass flow at points 1 and 2. (Density of mercury: 13.6 grams / cm3, Density of water: 1gr / cm3)
A manometer is used to measure the pressure in a tank filled with air. The fluid has a specific gravity of 0.95, and the manometer column height is 65cm. If the local atmospheric pressure is 96 kPa, determine the absolute pressure within the tank. answer in kPa abs
For the manometer shown in the image, all fluids are at 20 degrees C. If PB-PA = 89.5 kPa, determine the height H in centimeters. The specific weight of water is 9790 N/m^3 and the specific weight of mercury is 133100 N/m^3
The Venturi meter shown in the sketch below, contracts the flow down to one quarter of its original area. Cold air at 0 deg C flows in the pipe through the Venturi meter. The velocity of the air upstream of the Venturi meter is equal to 40 ft/s and the pressure at the same point is equal to 30 psia. What is the manometer reading if the fluid of the manometer is water with density 1000 kg/m3 . Assume that the air behaves as an ideal gas with molecular weight equal to Mw=29 kg/kmol and constant density evaluated at upstream conditions. Use Bernoulli's equation for your calculations. please respond asap!
A container is filled with different layers of various liquids, as shown in the figure,Determine: a) the pressure difference between the top surface and the bottom of the cylinder and b) the pressureabsolute at the bottom of the cylinder if the atmospheric pressure is equal to 100Kpa. solve step by step
Refer to the flow shown in the figure. The velocity before the contraction is 1.51m/s. Given: h=0.20m D1=0.103m D2=0.057m Determine the height of the fluid in the manometer, H, in meters
The water flow rate in the pipe will be measured using the pitot tube system given in the figure. At point 1, the velocity is zero and represents the stationary point. Since there is mercury with a density of 13600 kg/m3 in the manometer and the height of the manometer is read 0.06, calculate the volumetric flow rate of the water flowing in the pipe with a diameter of 0.2 m. (ρwater = 1000 kg/m3)
What is the absolute pressure inside the tank after it was submerged in a liquid if the volume of the air inside decreased by 25%? Atmospheric pressure = 101.325 kPa 135.100 kPa 145.778 kPa 152.353 kPa 141.638 kPa
Fluid Mechanics: (a) Convert a pressure head of 4.60 m of water to meters of oil, s.g. 0.750. (b) Convert a pressure head of 24 in of mercury to feet of oil, s.g. 0.750.
) Consider a double - fluid manometer attached to an air pipe shown in Figure. If the specific gravity of one fluid is 13.55, determine the specific gravity of the other fluid for the indicated absolute pressure of air. Take the atmospheric pressure to be 100 kPa. (