A projectile is launched from point A with the initial conditions shown in the figure. Determine the slant distances which locates the point B of impact. Calculate the time of flight t. ¹b = 129 m/s A 0=35° 795 m 12° B

A projectile is launched from point A with the initial conditions shown in the figure. Determine the slant distances which locates the point B of impact. Calculate the time of flight t. ¹b = 129 m/s A 0=35° 795 m 12° B

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: Hello let me ask what is T0 in part C in the formula for Wmax

A: This question was based on the concept of Otto cycle.

Q: If 5.0 m^3 of oil weighs 3,900 kgf, calculate its specific weight, density,and specific gravity? Use…

Q: Q5 The 2 kg block D is dropped from the position shown onto the end of a 16 mm diameter rod. Knowing…

Q: A projectile is launched from point A with speed vo= 20 m/s. Determine the value of the launch angle…

A: Given Velocity at point A is v = 20 m/s let us take acceleration due to gravity g = 9.8 m/s2 we know…

Q: Questions: 1. With the help of neat diagrams briefly explain the different types of roll mills.

A: Types of Roll mills: 1) 2- High Roll mill 2) 3-high Roll mill 3) 4-high Roll mill 4) Cluster Roll…

Q: The resistance force R of a supersonic plane during flight can be considered as dependent upon the…

Q: Heat in the amount of 100 kJ is transferred directly from a hot reservoir at 1350 K (TH) to a cold…

Q: What are the two mechanisms theoretically considered in turbulent flow?

A: The two theoretical mechanisms in turbulent flow are given as under,

Q: Answers were both incorrect can you help me correct them?

Q: Determine the support reactions and draw the Shear and Moment Diagram.

Q: A manufacturer claims that the average tensile strength of thread A exceeds the average tensile…

A: Given Two samples let A & B Sample size of A n1 = 50 Sample size of B n2 = 50 Average…

Q: A roofer tosses a small tool to the ground. What minimum magnitude vo of horizontal velocity is…

Q: Q2/ what the pressure within a droplet of water of 0.05 mm diameter if the pressure outside the…

A: Given Diameter of water droplet d 0.05 mm Pressure outside the droplet is standard atmospheric…

Q: The natural frequency of an undamped vibrating system is 100 rad/s. A damper with a damping factor…

A: Given data:Natural frequency, ωn=100 rad/sDamping factor, ξ=0.8

Q: Three equations of equilibrium are available to determine the unkowns. -Two dimensional force…

A: Three equation of equilibrium consist of the balance of forces in two dimensional and moment balance…

Q: We wish to produce a 0.3 inch thick plate of 3105 aluminum having a tensile strength of at least…

A: Given Data: Required Tensile Strength TS ≥ 25000 psi Required % Elongation ≥ 5% Original thickness…

Q: The spring constant of a helical compression spring DOES NOT depend on A coil diameter B material…

A: Spring constant also known as spring stiffness . It is denoted by K. For helical spring K= G…

Q: A projectile is launched from point A with speed vo = 34 m/s. Determine the value of the launch…

A: For the given projectile motion, initial velocity is 34 m/s. It is required to determine the launch…

Q: A projectile is launched from point A with speed vo= 36 m/s. Determine the value of the launch angle…

Q: Create the missing view given the two completed views. The frontvis missing for A, Top for B, and…

A: According to the two orthographic views of a projection, the third projection view is drawn with the…

Q: Two solid steel shafts (G = 77.2 GPa) are connected to a coupling disk B and to fixed supports at A…

Q: The percent elongation of a 1040 steel, cold worked 17% is

A: Given: Percent cold work is 17%. To find: Percent elongation = ? Concept:

Q: A 12-ft3 tank contains oxygen at 15 psia and 80◦F. A paddle wheel within the tank is rotated until…

Q: find centroid of the section if b =15 mm and h = 20 mm

Q: Figure 1.0 below is a diagram showing two cars, A & B, travelling along a straight road, and also a…

A: Given Data- VA=50km/hr VB=60km/hr we have to find all data given in table

Q: can u rewrite, cant read

Q: In the drawing shown the loads are as follows: F1= 851 N F2= 349 N Magnitude of the tension

Q: A mass of 8 kg of helium undergoes a process from an initial state of 3.9 m³/kg and 15°C to a final…

A: Introduction The increase in usable work potential as the process moves from the beginning state to…

Q: What is the Reynolds number of air at 250F (120C) and 14.7 psia (101kPa) flowing through a 2-inch…

Q: P₁ pg 2g + Z₁ = P₂ pg 2 2g +22 (4.8) Equation 4.8 is known as Bernoulli's equation. In this text we…

A: p1ρg+v122g+z1=p2ρg+v222g+z2The above Bernoulli's equation is applicable for ideal fluids only. Ideal…

Q: An aircraft performs a maneuver called an "aileron roll." During this maneuver, the plane turns like…

Q: The 200-kg snowmobile with passenger is traveling down the hill such that when it is at point A, it…

Q: On a T-V diagram sketch the constant specific volume through the reference state (state 0) T = 250C,…

A: given; draw T-V diagram for water at different temperature ?

Q: Value of n for constant temperature 0 0 O > 1 Ок 1 4

Q: 6-73. The wind turbine has an efficiency of 48% in an 8 m/s wind. If the air is at a standard…

A: Givenη=48%V=8m/sair at standard atmospheric pressure and a temperature 20oCd=35m

Q: The swing door is held in the position shown in the figure, by means of two cables AB and AC and,…

A: Here, A(2,0,4) B(5, 3cos20, 3sin20) =B(5,2.819,1.026) C(0, 3cos20, 3sin20) =C(0,2.819,1.026) Now,…

Q: Exercise 7.1 Compression and expansion of an ideal gas 50 mol/s of an ideal gas at 300 K and 1 bar…

A: Given: n˙=50 mol/sT1=300 KP1=1 barP2=10 barηadiabatic=80%P3=1 barT4=300 KTref=298 KPref=1 bar To…

Q: Calculate the change in entropy for one mole of Cl₂ as it goes from the solid phase 3. at 172.12 K…

Q: In a basketball game, the point guard A intends to throw a pass to the shooting guard B, who is…

A: Given data: constant speed 13 ft/secheight 6.7 ft

Q: 1. Determine the components of all forces acting on member ABCD of the assembly shown. E 120 lb

Q: A single-stage rocket is launched vertically from rest, and its thrust is programmed to give the…

Q: Car A is traveling at a location where the speed limit is 100 km/h. The police officer in car P…

Q: 20 kg of hot water enters a mixing chamber at 90 oC where it is mixed with cold water which entered…

A: Given data: m1=20 kgT1=90°CT2=10°CM=33 kg Need to determine the enthalpy of the water after mixing.

Q: The disk has an angular acceleration a = 7 rad/s² and angular velocity w = 3 rad/s at the instant…

Q: 06) An air standard Otto cycle has a compression ratio of 7.5. The maximum and minimum cycle…

Q: Vhat is the accuracy for the given scale in meter (m)? 0 0.5 1.0 1.5 2.0 cm

A: Given,

Q: Add the vectors using triangle rule or parallelogram rule

A: Draw the diagram of the vector system.

Q: Steam enters a turbine at 10 MPa and 600°C and exits at 0.1 bar. If the isentropic turbine…

Q: Indicate how velocity, water temperature, and pipe area affect the Reynolds number.

A: Viscosity: The measure of the resistance to fluid flow (continuous shear deformation) is known as…

Q: For general projectile motion, the horizontal component of a projectile's acceleration remains a…

A: Projectile motion: The motion of the object is known as projectile motion, when an object through at…

Concept explainers

Conservation of Energy

In physics, the rule of the conservation of energy states that energy doesn’t disappear from the atmosphere; instead, it changes its form from one type to another. Energy is one of the most important physical quantities in nature, and it cannot be created or destroyed — only transformed.

Question

A projectile is launched from point A with the initial conditions shown in the figure. Determine the slant distances which locates the
point B of impact. Calculate the time of flight t.
¹b = 129 m/s
A 0=35°
Answers:
S=
t =
i
Mi
795 m
812.76
2.015
12
B
m
S

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1:

VIEW

Step 2:

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The 300N block rests upon a level plane for which the fk is 0.20. A force P = 100N, directed at 30° from the horizontal pulls the block and moves 80m starting from rest. If the 100N force is then removed, how much further will it travel? CHOICES: 48.803m 47.800m 40.780m none 40.078m
Q.1) A 50 kg block is dropped from a height of 2 m onto the the 20 kg pan of a spring scale.Assuming the impact to be perfectly plastic, determine the maximum deflection of the pan.The constant of the spring is k = 20 kN/m.Q.2) Answer the following questions:a) Why does any person lean towards right while carrying a bag in her left hand?b) Give the physical significance of moment of inertia.c) Two satellites of equal masses, which can be considered as particles areorbiting the earth at different heights? Will their moments of inertia be same ordifferent?Q.3) A 5-kg model rocket is launched vertically and reaches an altitude of 100 m with a speedof 40 m/s at the end of powered flight, time t=5 s. As the rocket approaches its maximumaltitude it explodes into two parts of masses mA=1.7 kg and mB=3.3 kg. Part A is observed tostrike the ground 50 m west of the launch point at t=6 s. Determine the position of part B atthat time.
13. An object (at earth) at rest with a mass of 3kg is being dropped 3m above the spring whose constant is 10N/mm. If the spring has to stopped the falling object, determine the magnitude of deflection of the spring right after the stoppage. Assume no energy loss during operation. draw a figure.
The unstretched length of each of the two elastic rubber bands of the sling is 180 mm. Determine the maximum height a 30g stone will reach when fired vertically upwards if they are stretched and released as shown in the figure. The stiffness of both rubber bands is k= 80 N/m.
In the figure, the 50-N ball and 40-N ball, moving as indicated meet in oblique impact. If e=0.6, . Assume the surfaces of the balls are smooth. a. determine the amount and direction of the resultant velocity of 50-N ball after impact b.determine the amount and direction of the resultant velocity of 40-N ball after impact
A bullet B of mass mBtraveling with a speed v0= 1200 m/s ricochets off a fixed steel plate A of mass mA.Let mAmBso that it can be assumed that mB/mA→0. If the incidence angle of the bullet isθ= 15◦and the CORof the impact ise= 0.5, determine the rebound angleφ, as well as the bullet’s rebound speed.Use conservation lawmethods to solve the problem.
Body A with a mass of 10 kg is in balance in the middle of the inclined plane with the help of the AB cable and friction force. The pulling force in the cable is 32.5N. Calculate the balancing friction force acting on the object in the light of the given vectors. (G = 9.81g /m2)
Ball B is being suspended by a 1000mm long elastic cord from a wooden ceiling. The ball’s mass is said to be at 1,500 grams. If this cord is suddenly stretched downward 0.25m and the ball is released from rest, determine the distance (in mm) that the cord stretches after the ball rebounds from the wooden ceiling. Let’s say that the ball makes a central impact with the ceiling. Use the provided data below:
The robot moves the particle A (mass M) in the vertical plane using polar coordinate formulas r(t) = 1,2-0,6sin(2πt) [m] θ(t) = 0,5-1,5cos(2πt) [rad] in accordance with. Determine the force acting on the part in the r-direction [N] at time t0 = 1.9 s The mass of the piece is 4.54 kg Use units [N] GIVE ANSWER TO THREE DECIMALS
When the coefficient of restitution equals 1, this means that the collision is pure elastic Select one True False
A team of engineering students designs a medium-size catapult which launches 8-lb steel spheres. The launch speed is vo = 80 ft/sec, the launch angle is ? = 35o above the horizontal, and the launch position is 6 ft above ground level. The students use an athletic field with an adjoining slope topped by an 8-ft fence as shown. Determine: (a) the time duration tf of the flight. (b) the x-y coordinates of the point of first impact. (c) the maximum height h above the horizontal field attained by the ball. (d) the velocity (expressed as a vector) with which the projectile strikes the ground (or the fence).
Determine the value of the launch angle a which maximizes the range R indicated in the figure.