A pure inductance connected across a 250 V, 50 Hz supply consumes 100 W. This consumption can be attributed to The current flowing in the inductor The reactance of the inductor The big size of the inductor The given statement is false

A pure inductance connected across a 250 V, 50 Hz supply consumes 100 W. This consumption can be attributed to The current flowing in the inductor The reactance of the inductor The big size of the inductor The given statement is false

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter17: Resistive-inductive Series Circuits

Section: Chapter Questions

Problem 2PA: You are a journeyman electrician working in an industrial plant. Your task is to connect an inductor...

See similar textbooks

Related questions

Q: A current of 5 A in primary coil of a circuit is reduced to zero at a uniform rate in 10-3 seconds.…

A: Given, Current in the primary coil reduced from 5 A to 0 A at a uniform rate in 10-3 seconds. So,…

Q: Que 4.20. Find the Y-parameter model. A the Y-parameter I 13 YA of the following -circuit and draw…

Q: 1. Find the trigonometric and compact trigonometric Fourier series for periodic signals shown in the…

A: Given: Two different wave forms of periodic signals. we have to determine the Trigonometric Fourier…

Q: ΤΗ ΠΩ 70 Ω 10 Ω ΦΩΣ 240 V 20 Ω 1=0) 10mF

Q: Find the parameters for the circuit in the figure. Take R₁ = 3, R₂ = 5, and R3 = 14. (Figure 1) V₁…

A: Given: Circuit diagram Z-parameter equation will be: V1=Z11I1+Z12I2V2=Z21I1+Z22I2

Q: R(s) + G1 G2 G3 G4 +1 + G5 G1 FIGURE P5.5 Anter +A G6 day bindell C(s)

A: Given diagram,

Q: PA.5. Express each of these complex numbers in rectangular form and in exponential form: a. Za =…

A: a, Za=5∠450 In rectangular form it is written as, Za=5∠450=5cos450+jsin450=50.707+j0.707=3.53+j3.53…

Q: Problem: A series RLC circuit is compose of R = 50 , XL = j40 , Xc = -j15 Q. The supply voltage is…

A: It is given that: R=50 ΩXL=j40 ΩXC=-j15 ΩVrms=240∠0° V

Q: Multi-Source Circuit Analysis 2 Consider the circuit shown with the following parameters: Vs = 13 V…

Q: a.1) In a certain UJT, r'B1 = 2.5 k and r'B2 = 4 KQ. What is the intrinsic standoff ratio? a.2)…

A: The unijunction transistor is a electronic device which is used as an electrically controller…

Q: Frequency modulated signal with single-tone modulation has a frequency deviation of 15 kHz and…

Q: Find i (in Amperes) for t=0.26 sec, if V 37 V and L=4.0 H. Use 3 decimal places. (Unit is not…

Q: A coil of inductance 100 mH and resistance 800 ohm is connected in parallel with a variable The…

A: Given data, L=100 mH R=800 ohm V=12V f= 50Hz C=? Zdynamic=? I=? Q- factor = ?

Q: :Calculate the demand factor for a building with the following Electrical Loads Lighting = 367 w Air…

A: Given, The electric loads of a building are Lighting, 367 W Air conditioner, 6.7 kW Appliances, 4.8…

Q: Design an 8-4-2-1 BCD code converter to drive a seven-segment indicator. The four inputs to the…

A: We need to design an 8-4-2-1 BCD code converter circuit to drive a seven-segment display as shown…

Q: 2) What is the current through the LED of Figure 3) If the supply voltage of Figure 5-12 increases…

Q: 12 V (+ 4Ω ΜΕ 6Ω Μ + Τα 2% 4V rig-

A: Solution- Given circuit diagram,

Q: ated at 70 Ah? 0 5 0

A: Given data, Battery delivers 2A current and rated for 70Ah So, I= 2A t = ?

Q: In a microcontroller program, a subroutine starts at address 016F and ends with a 'return'…

A: Below find the solution !!

Q: tate the other names of amplitude shift keying and the reason why the names is given

A: Given: State the other names of amplitude shift keying and the reason why the names are given.

Q: A lossless transmission line having 50 Ω characteristic impedance and length λ/4 is short-circuited…

Q: In case of a 4-pole machine, 1 mechanical degree corresponds to (i) 2 (ii) 4 (iii) 8 electrical…

A: Given a machine having, Total number of pole, P = 4 Mechanical degree, θm=1° Electrical degrees,…

Q: Find Leq (in Henry). Give only the numeric value. 4 H 20 H m Leq m 8 H 7 H m 10 H 12 H

Q: Que 2.23. What should be the value of R, so the maximum po can be transferred from the source to R,…

A: In this question, We need to determine the value of load resistance RL as shown the circuit for…

Q: But what precisely is meant by the term "digital audio"? The procedure through which analog sound…

A: Analog to digital converter : Analog signals get converted into digital signals. amplitude…

Q: A balanced, three-phase circuit is characterized as follows: Y-A connected; • Source voltage in the…

Q: What is voltage at the load?

Q: A full Wave rectifier shown in the circuit has 120V (rms) 50 Hz input through a transformer. RL = 2k…

A: Given: Input at primary of transformer, Vprms=120 V RL=2 kΩ

Q: Under dc conditions, find it in Amperes.

A: Given- DC source voltage= 9 V Inductor = 2 H To find- Current, iL =?

Q: A current of 5 A in primary coil of a circuit is reduced to zero at a uniform rate in 10 seconds. If…

Q: To which, current and resistance are directly proportional? a. Voltage b. Power c. Current d.…

A: In these questions, We need to choose the correct options We are solving this questions using the…

Q: Two impedances Z1 = (10 + j5) Qand Z2 = (25 - j10) Qare connected in parallel to a 100 V, 50 Hz…

Q: You have been given the following function: V = ax+By2² It describes the electric potential in a…

Q: Find the voltage across 20 resistor due to 20V source 20 W 20V 10

A: Given circuit,

Q: Determine the Norton's current from the Thevenin's equivalent circuit as shown.

Q: Use nodal analysis to determine current in the capacitor in the figure below. (40+/50) £2 25/0° V O…

Q: A coil of inductance 0.20H and resistance 60 ohm is connected in parallel with a 20μF capacitor…

Q: 8 Ω 2V 2Ω + S 4Ω Va 1 ЗА

Q: A harmonic analysis of the current drawn by a CFL yields the following data. Find the rms value of…

A: We have an data of CFL lamp with harmonics as shown in table and corresponding currents of that…

Q: Design an 8-4-2-1 BCD code converter to drive a seven-segment indicator. The four inputs to the…

A: We need to design an 8-4-2-1 BCD code converter circuit to drive a seven-segment display as shown…

Q: A balanced delta-connected load with impedance 20 - j15 ohms is connected to a positive-sequence…

Q: IR lc R C V ICA IR V

Q: In figure the SCR has a trigger voltage of 0.75 V and a trigger current of 7mA. What input voltage…

Q: From the following three-wire circuit let Van = Vnb = 120 ∟0° Vrms, determine: a.) InN b.) The…

A: Given: Van=Vnb =120∠0° Vrms Circuit

Q: The quantum efficiency (n) and responsivity (R) at a wavelength λ (in um) in a p-i-n photodetector…

A: Responsivity (R) the ratio of the photon current to the optical power.We know that quantam…

Q: image

A: Given:

Q: Find the square root of (6 + j7) in polar form, 3.04<24.70° in rectangular form, 2.76 +j1.27 O NFTOC…

Q: 1. True or false: In direct current (DC), the electric charge (current) only flows in one direction.…

Q: When using a digital multimeter, you accidentally connected the red lead to the negative terminal of…

A: Answer: C. Negative reading Explanation: a. It is not a valid option. The red and black probes…

Q: 1. True or false: In direct current (DC), the electric charge (current) only flows in one direction.…

A: Electrons flow from the negative terminal to the positive terminal and the current flows in the…

Question

A pure inductance connected across a 250 V, 50 Hz supply consumes 100 W. This consumption can be
attributed to
The current flowing in the inductor
The reactance of the inductor
The big size of the inductor
The given statement is false

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
You are a journeyman electrician working in an industrial plant. Your task is to connect an inductor to a 480-V, 60-Hz line. To determine the proper conductor and fuse size for this installation, you need to know the amount of current the inductor will draw from the line. The nameplate on the inductor indicates that it has an inductance of 0.1 H. An ohmmeter reveals that it has a wire resistance of 10 . How much current should this inductor draw when connected to the line?
An AC circuit contains a 24 resistor, a 15.9-mH inductor, and a 13.3F capacitor connected in parallel. The circuit is connected to a 240-V, 400-Hz power supply. Find the following values. XL=XC=IR=AIL=AIC=AP=WVARsL=VARsC=IT=AVA=PF=%=
You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
Show that the two expressions for the self-inductance, namely NΦ/i and ε/(di/dt) have thesame unit
A 1-H inductor is connected in series with a 6-ohm resistor. If the connection is energized from a 9-V DC source, determine the current (in amperes) through the circuit for a long time. The initial current is 100 mA. Express your answers accurate to four decimal places. No need to put the units.
A small capacitor of 100 pF is charged by a steady current of 1 µA for 1 ms. At that time, the charging circuit is disconnected. a) What is the voltage across the capacitor when the charging finishes? b) A 10 MΩ resistor is connected across the capacitor to discharge it. Sketch a graph of the voltage V across the resistor as a function of time, with appropriate numbers and units marked on the axes.
1.) Find the equivalent capacitance of the figure below. (SHOW COMPLETE SOLUTION)
Find the equivalent inductance as seen from the terminals shown in the figure.
What value of inductance (having zero initial current) corresponds to an open circuit?Explain your answer. Repeat for a short circuit.
2. Solve for the equivalent capacitance and total charge for the circuit below.
Using a simple series circuit with a capacitor of capacitance C and a resistor, R connected across a battery pack with total voltage V, derive the equation governing the capacitor's voltage response (charging cycle).