A reaction mixture that consisted of 0.20 mol N2(g) and 0.20 mol H2(g) was introduced into a reactor of volume 25.0 L and heated. At equilibrium, 5.0% of the nitrogen gas had reacted. What is the value of the equilibrium constant KC for the reaction N2(g) + 3H2(g) ⇋ 2 NH3(g) at this temperature?

A reaction mixture that consisted of 0.20 mol N2(g) and 0.20 mol H2(g) was introduced into a reactor of volume 25.0 L and heated. At equilibrium, 5.0% of the nitrogen gas had reacted. What is the value of the equilibrium constant KC for the reaction N2(g) + 3H2(g) ⇋ 2 NH3(g) at this temperature?

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter24: Introduction To Spectrochemical Methods

Section: Chapter Questions

Problem 24.4QAP

See similar textbooks

Related questions

Q: What partial pressure of hydrogen results in a molar concentration of 1.0 mmol dm-3 in water at 25…

A: The ideal gas equation is,

Q: Calculate the equilibrium concentration of carbon dioxide in fat given that the Henry's law constant…

A: Henry's law can be expressed as, C x KH = Pgas Where, C is the concentration…

Q: Consider Palmitic acid C16H32O2, a common fatty acid used in the manufacture of soap. A solution of…

Q: What is the mass concentration of water vapor (g H2O per m3 of air) in a liquid-water cloud at a…

A: Saturation water vapor pressure, P at 273 K = 611.6 Pa 1 Pa = 1 kg/m.s2 1 J = 1 kg.m2/s2. Molar mass…

Q: DESCRIBE THE PREPARATION OF 1.0L OF NaOH SOLUTION THAT HAS A NORMALITY OF 0.25N AND (MW NaOH =…

A: The preparation of 1 L of 0.25 N NaOH solution has to be given,

Q: The partial molar volumes of two liquids A and B in a mixture in which the mole fraction of A is…

Q: 6. Derive the following relationship that describes the variation of calcium concentration in water,…

A: To derive the given relation:

Q: What is the molar fraction of CO in a container with a molar fraction of H2 of 0.22 and a molar…

A: The mole fraction can be defined as the number of moles of a particular species divided by the total…

Q: For the calculation of the solubility c of a gas in a solvent, it is often convenient to use the…

Q: A solution contains 5% w/v Al2(SO4)3.14H20 (MW = 600). Assuming there is complete ionization,…

Q: The concentration of O2 in water required to support aerobic aquatic life is about 4 .0 mg dm-3 .…

A: The minimum partial pressure of oxygen in the atmosphere that can achieve this concentration of…

Q: The osmolarity of physiological saline solution is 0.300 osmol/L. Assuming a membrane that is…

A: Osmotic concentration, also recognized as osmolarity, is an indicator of solute concentration that…

Q: P-Galactosidase (B-gal) is a hydrolase enzyme that catalyzes the hydrolysis of B-galactosides into…

A: Given: Mass of beta galactoside, m = 0.607 g Volume of solution, V= 0.171 L Temperature, T= 25 +…

Q: In a study of the properties of aqueous solutions of Th(NO3)4 a freezing-point depression of 0.0703…

Q: At 20 °C, the mass density of a 20 per cent by mass ethanol–water solution is 968.7 kg m−3. Given…

Q: Calculate the molality of a solution where 144 grams of C6H12O6 were dissolved in 1500 g of water.

A: Concentration determined in different methods Molarity Notmality Molality Mole fractionl m=w…

Q: Consider Palmitic acid C16H32O2, a common fatty acid used in the manufacture of soap. A solution of…

A: Mass of palmitic acid= 112g Volume of benzene= 725mL Density of solution = 0.902 g/mL Palmitic acid…

Q: mole fraction

Q: The molal freezing point constant for copper is 23 °C/m. If pure copper melts at 1083°C, what will…

A: Brass is made up of 33.1 mass percent Zn and remaining Cu. This means that 33.1 g is Zn and…

Q: __________ is a measure of energy randomization or energy dispersal in a system.…

A: According to the first law of thermodynamics, the energy cannot be created or destroyed but the…

Q: Calculate the Volume of Carbon Dioxide gas that was produced in the reaction of baking soda and…

Q: The addition of 100 g of a compound to 750 g of CCl4 lowered the freezing point of the solvent by…

A: Given details, The mass of the compound is 100 g. The mass of CCl4 is 750g. Lowered the freezing…

Q: Describe the preparation of 500 mL of 2.45%(v/v) aqueous ethanol

A: The volume percentage is determined as the volume of solute upon volume of the solution multiplied…

Q: 3. The vapor pressure of methanol (1) at 298 K is 16.94 x 10³ Pa. Calculate A, G° (CH30H, g) –…

Q: 6. Derive the following relationship that describes the variation of calcium concentration in water,…

A: To derive the given relation:

Q: Which has the greatest vapour pressure at 25°C? SiO2 CO2 H2O

A: At constant temperature, vapor pressure depends on the intermolecular forces. Vapor pressure will be…

Q: 5. What is the approximate molarity, molality and normality of a 13% w/w solution of H2SO4…

A: Given: percentage solution of sulfuric acid=13% Density of the solution=1.090g/ml The 13% solution…

Q: Calculate the molar concentration of the polycyclic aromatic hydrocarbon (PAH), anthracene (178.23…

A: Given: Concentration of well water sample = 2.18 ppb Density of well water sample =1.00 g/mL To…

Q: Determine the final concentration in mol dm–3 of K+ and SO42– when the following three solutions in…

A: Their are three volumetric flask of volume 500cm3 contain 0.20 mol/dm3 KAl(SO4)2 and second flask of…

Q: Consider Palmitic acid C16H32O2, a common fatty acid used in the manufacture of soap. A solution of…

A: Hello. Since the question contains more than three sub-parts, the first three sub-parts shall be…

Q: HCl and NH3 react to form a white solid, NH4Cl. If cotton plugs saturated with aqueous solutions of…

A: HCl and NH3 forms NH4Cl. Taking aqueous solution of HCl and NH4OH, HCl and NH3 gases are released…

Q: Illustrate the calculation of the ppm concentration of a known amount of vaporised liquid in 1 L of…

A: ppm stands for parts per million. ppm indicates that how many part of a chemical compound is present…

Q: The boiling point of amphetamine, C₉H₁₃N, is 201°C at 760 torr and 83°C at 13 torr. What is…

A: Given that the vapor pressure at 201oC is 760 torr and vapor pressure at 83oC is 13 torr To…

Q: you dissolve 1.0g of the enzyme in water to make 250mL of solution. You measure the osmotic pressure…

A: Mass of enzyme = 1 g Osmotic pressure = 3.5 torr = 0.0046 atm Temperature, T = 298 K Volume of…

Q: Glucose from molasses is fermented to alcohol using S. cerevisiae where 500 ml of CO2 (at standard…

Q: What is the vapor composition of an equal molar mixture of acetone (Pvap = 285 mmHg @ 30 °C) and…

A: Given, The vapor composition of an equal molar mixture of acetone (Pvap = 285 mmHg at 30 °C) and…

Q: You are given a 27 % (w/v) solution of psicose. Molar…

A: Given, Note: 1 μmoles = 10-6 moles moles of psicose = 450 μmoles = 450 × 10-6 moles % (w/v) of the…

Q: What would be the vapor pressure for a mixture of 15 mL of benzene (f.w. = 78.1 g/mol, d=0.878 g/mL,…

A: The vapor pressure of the mixture can be obtained by the summation of partial pressure due to each…

Q: An aqueous solution of mass of 100 g of aqueous copper II sulfate CuSO4.xH₂O was prepared by…

Q: The partial molar volumes of two liquids A and B in a mixture in which the mole fraction of A is…

A: The Partial Volume of a substance in a mixture is defined as the increase of volume that occurs when…

Q: A certain mixture contains 60% pentane, 30% hexane, and 10% heptane by mass. What is the mole…

Q: What are the mole fractions of hydrochloric acid (HCl) and water in 20% w/w) aqueous HCl solution?

A: Answer: Mole fraction of a compound in a solution is the ratio of its mole with total number of…

Q: Osmotic pressures are often reported in units of atmospheres or mm Hg. The latter implies that the…

A: One torr is approximately equal to the pressure required to raise the column of mercury by 1 mm.…

Q: Give an example of Calcination?

A: The process of converting an ore into oxide by heating it strongly below its melting point in a…

Q: Consider Palmitic acid C16H32O2, a common fatty acid used in the manufacture of soap. A solution of…

Q: mixture of NaOH, NaCL and MgCl2 contains 34.6% by mass chloride and 20.0% by mass hydroxide. What…

A: From the hydroxide mass we can calculate the moles of Hydroxide and hence the moles of NaOH. And…

Q: Determine the molality of a 6.930 wt % aqueous solution of LiCl

Question

A reaction mixture that consisted of 0.20 mol N₂(g) and 0.20 mol H₂(g) was introduced into a reactor of volume 25.0 L and heated. At equilibrium, 5.0% of the nitrogen gas had reacted. What is the value of the equilibrium constant K_C for the reaction N₂(g) + 3H₂(g) ⇋ 2 NH₃(g) at this temperature?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

What partial pressure of hydrogen results in a molar concentration of 1.0 mmol dm-3 in water at 25 °c?
The mole fraction of sodium chloride, NaCl, in a saturated aqueous solution is 0,220. What is the molarity (molar concentration) of this solution if it has a density of 1,150 g.cm–3?
The average concentration of chloride ion in seawater is 19.353g Cl-/kg. The world health organization recommends that the concentration of Cl- ions in drinking water not exceed 250ppm. How many times as much chloride ion is there in seawater than in maximum concentration allowed in drinking water?
Illustrate the calculation of the ppm concentration of a known amount of vaporised liquid in 1 L of closed vessel?
One tenth of a kg of an aqueous solution of HCl is poured into 0.2 kg of an aqueous solution of NaOH. The mole fraction of the HCl solution was 0.1, whereas that of the NaOH solution was 0.25. What are the mole fractions of each of the components in the solution after the chemical reaction has come to completion?
Determine the molality of a 5.001 wt % aqueous solution of LICl.
What is the molar concentration of potassium chloride (Formula Weight: 74.55g/mole) in a 25% (w/v) solution?
Calculate the osmotic pressure in (atm) for 490mM K3PO4 at 300.7 K.
5 In a mixture of ethyl alcohol in water, what is the mole fraction of ethyl alcohol if it is 10% by mass in the mixture?
What is the molality of a 24.4% (by mass) aqueous solution of phosphoric acid?
Consider Palmitic acid C16H32O2, a common fatty acid used in the manufacture of soap. A solution of palmitic acid is prepared by mixing 112 g palmitic acid with 725 mL of benzene C6H6. The density of the resulting solution is 0.902 g/mL. Palmitic acid (molar mass = 256 g/mol and density = 0.852 g/mL); Benzene (molar mass = 78 g/mol and density = 0.879 g/mL) What is the mole fraction of the solvent? Final answer must be rounded off to 2 decimal places, and shall NOT have any unit. What is the mass percentage of the solution? Final answer must be rounded off to 2 decimal places, and shall NOT have any unit. What is the molarity of the solution? Final answer must be rounded off to 2 decimal places, and shall NOT have any unit.
Consider Palmitic acid C16H32O2, a common fatty acid used in the manufacture of soap. A solution of palmitic acid is prepared by mixing 112 g palmitic acid with 725 mL of benzene C6H6. The density of the resulting solution is 0.902 g/mL. Palmitic acid (molar mass = 256 g/mol and density = 0.852 g/mL); Benzene (molar mass = 78 g/mol and density = 0.879 g/mL) What is the mole fraction of the solvent? Final answer must be rounded off to 2 decimal places, and shall NOT have any unit.