A river 80 meters wide, with a depth d at a distance x measured from one of its banks is given by the following table. x0| 10 20 30 40 50 60 70 80 d 4 7 9 12 15 14 3 By Simpson's rule, find the cross-sectional area of the river.

A river 80 meters wide, with a depth d at a distance x measured from one of its banks is given by the following table. x0| 10 20 30 40 50 60 70 80 d 4 7 9 12 15 14 3 By Simpson's rule, find the cross-sectional area of the river.

Name: 7.8. Training questions.1. A river 80 meters wide, with a depth d at
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: 7.8. Training questions.1. A river 80 meters wide, with a depth d at a distance x measuredfrom one of its banks is given by the following table.x0 1020304050607080d479.12151483By Simpson's rule, find the cross -sectional area of theriver.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Water flows steadily and smoothly through an open-channel flow of varying width, as shown in Figure P10.21. The Froude number at the upstream station is subcritical and equal to F1, and the width and depth at this station are w1 and h1, respectively. At the point of minimum channel width (the “throat”), the Froude number F2 = 1, and the width and depth are w2 and h2. Downstream of the throat the channel expands to a constant width, and at this point the Froude number is F3 and the width and depth of the flow are w3 and h3. Note that h2/h1 = 3/4, and w3 = w1. State all your assumptions. (a) Find F1 (this is a number). (b) Find w2/w1 (this is a number). (c) Show that h1/h3 is approximately equal to 2.37.
What are the most efficient dimensions for a half-hexagoncast iron channel to carry 15,000 gal/min on a slopeof 0.16°?
Water at 65°F flows at a depth of 1.4 ft with an average velocity of 20 ft/s in a wide rectangular channel. Determine (a) the Froude number, (b) the critical depth, and (c) whether the flow is subcritical or supercritical. What would your response be if the flow depth were 0.2 ft
Water flows steadily over a bump of height h, as shown in Figure P10.23. The width of the channel is constant. At position 1, the depth of the water is H1 and its velocity is V1, and at position 2, the depth of the water is H2 and its velocity is V2. The Froude number at position 1 is F1 = 0.2. (a) Find the Froude number at position 2 if H1/H2 = 2 (this is a number).
Q 1(a) Use the below given data and calculate the metacentric height. Note: Explain each and every step. w= 200g W=2533.2g Displacement x (mm) 80 60 40 20 0 20 40 60 80 Tilt angle Ɵ (degree) 9.5 7.5 5.5 3 3 5.5 7.5 9.5 M.H (b) By using U-tube manometer how can you find out the pressure head? (c) If you are lacking of equipment, how can you determine the discharge of any channel?
For an open channel having a trapezoidal section, the most efficient is the one whose shape is that of semi-regular hexagon. If such channel carries 4 m3/s of water flowing at 50 cm/s, the base width in meters is
Five sewer pipes, each a 2-m-diameter clay tile piperunning half full on a slope of 0.25°, empty into a singleasphalt pipe, also laid out at 0.25°. If the large pipe is alsoto run half full, what should be its diameter?
An unfi nished concrete sewer pipe, of diameter 4 ft, isfl owing half-full at 39,500 U.S. gallons per minute. If thisis the normal depth, what is the pipe slope, in degrees?
A rectangular open channel has a base of length 2b, and the water is flowing with a depth of b. Sketch this channel. How would you sketch this channel?
Water flows uniformly in a rectangular channel with finished-concrete surfaces. The channel width is 3 m, the flow depth is 1.2 m, and the bottom slope is 0.002. Determine if the channel should be classified as mild, critical, or steep for this flow.
Water in a two-dimensional channel flows smoothly over a submerged obstacle of height H as shown in Figure P10.12. The water depth at the peak of the obstacle is Y2, where Y2 = Y1/3. (a) Find the value of the Froude number of the incoming flow, F1, given that the Froude number is unity at the point where the depth is Y2. (b) Find the nondimensional height of the obstacle, H/Y1.
Given a straight channel with a rectangular cross section, width = 200 μm, height = 120 µm, if the volumetric flow rate is 0.1 mL/min, and dynamic viscosity of the water is 1 CP. would it be a laminar flow? Under the same pressure gradient (), if we change to a circular cross section, what would be the diameter of the channel if we would like to maintain the same volumetric flow rate?