A ship of weight 1500 ton is entering into the canal from using a hydraulic press system where the canal is at higher level than the sea. The hydraulic press details as shown in figure. Ram wt = 500 ton Area 500 sqm F Force Applied & lunger wt = 200 ton Axc-5099m. Calculate the minimum force (kN) applied on the plunger to lift the ram when ship is on the ram.

Q: Aqueous hydrochloric acid (HC1) reacts with solid sodium hydroxide (NaOH) to produce aqueous sodium…

A: HCl + NaOH = NaOH + H2O Molar mass of NaOH = 40 g/mol Molar mass of HCl = 36.5 g/mol     x…

Q: Acrylonitrile is produced in the reaction of propylene, ammonia and oxygen C₂H6 + NH₂ + O₂- C₂H₂N+…

A: Given that- Acrylonitrile production reaction is- C3H6+ NH3+ 32O2→C3H3N + 3H2O Basis feed= 100 mol…

Q: Liquid L D Liquid ammonia at -20°C (rho=665.1

A:

Q: In an aqueous solution, reaction P→ Q occurs under isothermal conditions following first order…

A:

Q: 4. A solution is 2.00 mM analyte compound X and 3.50 mM internal standard compound S. Analysis of…

A: given = The concentration of Analyte (compound A) = 2 mM  The concentration of the internal standard…

Q: Exercise 4.1: CSTR Design Using Damköhler Number (Da) The elementary reversible reaction A + B 2 C…

A: A reversible, elementary reaction is carried out in a CSTR.

Q: A midsize steam-methane reforming plant is consuming methane at a rate of 125,000 mol/h and…

A:

Q: d'T' dx² 'T' 9⁰. m k

A: Aim: Solve the given second order differential equations. The given equation is linear differential…

Q: For SO2 at 600 K and 300 bar, estimate the fugacity and of G R /RT by using 2nd virial equation

A: Given data: T = 600 K P = 300 bar

Q: Pv=MRT, Aprove that?

A: Here It is required to prove Pv=mRT where P is the pressure of the gas, v is volume of the gas, m is…

Q: The following gas reaction (A is the reactant, B and C are the products) at 500K has Standard…

A: The standard Gibbs free energy for the reaction 2A(g) = B(g) + C(g) is ∆Go = 5.1 kJ/mol at a…

Q: Below is a diagram of fired heater used to pre-heat an oil stream before it is used in a different…

A: 1) (A) • Two control objectives for the given case are as follows: 1) Controlling the Feed…

Q: What is the answer for the calculation of a partial molar property in a binary mixture with molar…

A: It is required to calculate the partial molar property in a binary mixture with molar composition…

Q: Calculate the change in change in Gibbs energy of 15g of ik mass density 0.751 g/cm³) when the…

A:

Q: A soluble gas is absorbed in water using a packed tower. The equilibrium relation- ship may be taken…

A: Given that :ye=0.06xeHx=0.24m Hy=0.36 m xin=0yin=0.009xout=0.08yout=0.001

Q: A liquid is contained in a reactor vessel at 115 bar absolute pressure. It is transferred to a…

A: Given that, Absolute pressure in reactor vessel, P1=115 bar=115x105 N/m2 Pressure above liquid…

Q: 666 BOILING AND CONDENSATION 10-19 Water is boiled at atmospheric pressure by a horizon- tal…

A: Given, Diameter of Platinum plated rod = 10 mm Surface temperature of rod = 110°C

Q: Q.2: The combustion analysis using ORSAT apparatus, where the analysis indicated as 15% CO2, and…

A: Given data: Composition of CO2 in the dry stack gas = 15 %

Q: What is the formula for the Gibbs Free Energy of a non-ideal binary liquid mixture with composition…

A:

Q: (a) copy the reaction scheme for the synthesis of glycerol and biodiesel from vegetable oil via…

A: Dear User! Both part(a) and part(b) of the question involve the use of your lab notebook and an…

Q: A NiO-20 mol% MgO ceramic is heated to 2200 °C. Determine (a) the composition of the solid and…

A: Note = molecular mass of MgO = 40.312 g/mol molecular mass of NiO = 74.71 g/mol Draw a horizontal…

Q: ( Acetylene is produced from methane in the reaction: 2CH4 (g) → C₂H₂ (g) + 3 H₂ (g) An undesired…

A: Write the reaction as follows: 2CH4g → C2H2g +3H2g Two moles of CH4 is decomposed into 1 mole of…

Q: 9. If the rate of reaction is independent of the concentration of the reactants, the reaction is…

A: 9) In some reactions, the rate is apparently independent of the reactant concentration. The rates of…

Q: eprint to print an object la cells and biomaterials, crea

A:

Q: volume of the tank to store 683 kg of water

A: Given Data : Quality of wet steam, x = 0.42 Tank under pressure of , P = 15 bar Total mass of water…

Q: 2. According to the wettability picture, answer the following questions: a) The wettability for…

A: With the help of wettability picture, Find a)Wettability for both figures b)Factors that affect…

Q: ropylene oxide (C3H8O) is produced by reacting propylene (C3H6) with oxygen and hydrogen. A side…

A: A mixture of propylene, hydrogen, oxygen, and carbon dioxide is fed to a continuous reactor.

Q: for question C, why is the dot at when the atm is 1 rather than 0.0001?

A: Phase diagram of a compound is given.

Q: Three moles of an ideal gas compresses from 3 atm, 49.2 liters to 5 atm isothermally and reversibly.…

A: Given Details:  Ideal Gas goes through Isothermal and reversible Compression. n=3 moles Initial…

Q: Air expands adiabatically in a piston-cylinder assembly from an initial state where p₁ = 100…

A: Given that- Air expands adiabatically in a piston-cylinder assembly for which initial states are,…

Q: CHAPTER 10 10-15 Water is to be boiled at atmospheric pressure in a mechanically polished steel pan…

A: Given:  Water is to be boiled in a polished pan of d = 30 cm or 0.3 m at atmospheric pressure. At…

Q: Butane (C4H10)(C4H10) and dry air are fed to a combustion reactor at a steady rate of 45.9 mol/s45.9…

A: Given that, The molar flow rate of butane in the feed stream nC4H10,F = 45.9 mols The molar flow…

Q: A stream of methane (CH4, Cp = 4R) flowing at 3.0 kmol/min is isobarically heated in a…

A: gIVEN THAT For methane Cp  of methane =4Rm1=3 kmolminT1 =20  CT2=1.60 x 102 CTsurr  =27 C

Q: A plane wall is a composite of two materials, A and B. The wall of material A has uniform heat…

A: Given data: Heat generation in wall A, q. = 1.5 *106 W/m3 Thermal conductivity of A, k­A = 75 W/m.K…

Q: Which of the following statements about recrystallisation of metals are true? Select one or more: a.…

A: a) False, Recrystallization helps to enhance ductility, not plastic deformability b) True, the cold…

Q: One of the methods to increase oil recovery from reservoir is injection of Carbone Dioxide. Explain…

A: Oil recovery techniques fall into three categories: 1) Primary oil recovery: It is employed during…

Q: Using Raoult's Law estimate the dew point pressure and liquid composition at 80°C of a vapor mixture…

A: A vapor mixture of methanol, ethanol and 1-butanol is given.

Q: Explain Principle, Merits and Demerits of Quadrupole Mass Analyzer? Please answer at your own easy…

A: The quadrupole mass analyzer or the quadrupole mass filter is a mass analyzer that is used in mass…

Q: Minimum Liquid Flow in a Packed Tower. The gas stream from a chemical reactor contains 25 mol %…

A: Given data are as follows: Mole fraction of ammonia in entering gas stream y1 = 0.25 Entering molar…

Q: the amount of excess combustion air is normally determined by analysis of stack_____ a) the fuel…

A: Excess air is the air which is used in excess for combustion of various fuels (solids, liquid, and…

Q: Using the rate equation k = 96 lit/hr kg cat, determine the amount of catalyst needed in a packed…

A: Given: The reaction given is, A → 4R, and the conversion is X = 0.35. The molar flow rate is FAo =…

Q: How do you know that the final pressure is 1atm ?

A: A mixture of methane, ethane, and propane is burnt in excess air.

Q: isochoric cooling process from an initial state of 8 bar and 160°C to a final state of 5  bar and…

A:

Q: Ethyl alcohol(C2​H5​OH)is burned with 70 percent excess air. The air is at 30∘C and70%relative…

A: Given that- Ethyl alcohol is burnt. Excess air= 70% Air temperature, T=300C Relative humidity,…

Q: . A tank with a capacity of 2m³ (2000 liters) is initially full of pure water. At time t = 0, salt…

A:

Q: The following mechanism has been proposed for the formation of phosgene, COCl2: Use the steady…

A: Rate equation for the formation of phosgene is to be calculated.

Q: An unknown polymer sample was found to have the following molecular weight distribution: Molecular…

A: The molecular weight distribution of an unknown polymer is given.

Q: Im sorry but how did u solve the equation for turnover? 4.8 = 2ln(1-x)-x isnt solvable

A: The production rate of desired product is calculated using the design equation of PFR.

Q: 10-32 A 1-mm-diameter nickel wire with electrical resis- tance of 0.129 2/m is submerged…

A: Given details: Diameter of wire, D=1 mm =0.001 m electrical resistance of wire , R=0.129 ohm/m…

Q: 2SO2 + O2 ⇌ 2SO2 equilibrium reaction with 21% SO2, 10% O2 oxygen and the remainder SO3 It is fed…

A: T = 301 0C P = 200 kPa