A sign for a pizza restaurant hangs from a 2.60-m long rod extended out from a building. A cable, attached to the building, is attached to the rod at a point that is 2.10 m from the hidge. (See the figure.) The mass of the rod is 4.80 kg. The mass of the sign is 7.10 kg. The angle between the building and the rod is 50.0 degrees. The angle between the cable and the horizontal is 38.0 degrees. The tension in the cable is 90.27 N. What is the vertical component of the reaction force from then hinge on the rod

Q: A horizontal beam of length 4 m and mass 4.0 kg has a mass of 5.0 kg and width 0.8 m sitting at the…

A: The torque due to gravity of the beam-block system will be equal to the sum of the torque due to…

Q: A spade is modelled as a uniform rod, of mass 2kg and length 90cm, attached to a uniform square…

A: Gardener is holding the spade horizontally. This shows that weight of spade = force by gardner’s…

Q: The drawing shows a rectangular peice of wood. The forces applied to corners B and D have the same…

A: Given,The length of the shortest side is ‘L’.The length of the longest side is ‘2L’.Let the third…

Q: A tightrope walker is walking between two buildings holding a pole with length L = 14.5 m, and mass…

A:

Q: Determine the net torque (about point P at one end) of the 4.0-m-long uniform beam shown in the…

A:

Q: A man weighing 1200 N sits 2.0 m to the left of the center of a see-saw. His 1 point friend weighs…

A:

Q: A uniform rod of length 100cm and mass 0.4 kg is placed on a fulcrum at a distance of 80cm from the…

A: Draw the free-body diagram of the rod.

Q: A gymnast with mass 46.0 kg stands on the end of a uniform balance beam as shown in the figure. The…

A: Concept Apply the torque concept  Torque=Distace*Force

Q: The topic is torque A uniform horizontal beam is attached to a wall by a pin connection that allows…

A: Let the Tension be T Weight of beam (Wb) = Mg Wb = 35.7×10 =357 N Weight of the person (Wp) = mg=600…

Q: A mechanic is screwing a bolt and applies a force ?⃗ of magnitude 12.0 N to the end of the wrench.…

A: The torque τ be defined as, τ→=r→×F→r→=rFsinθ Where, r is distance. F is force.

Q: A beam resting on two pivots has a length of L = 6.00 m and mass M = 89.0 kg.The pivot under the…

A:

Q: A beam resting on two pivots has a length of L = 6.00 m and mass M = 92.0 kg.The pivot under the…

A: (a) Condition for rotational equilibrium τnet=0n2l-mgx-MgL2=0n2=mgx+MgL2l

Q: In the figure, what magnitude of force F→ applied horizontally at the axle of the wheel is necessary…

A: Consider the perpendicular distance of the weight of the wheel from the point of contact P be x. The…

Q: The uniform seesaw shown below is balanced on a fulcrum located 3.0 m from the left end. The smaller…

A:

Q: 4. A 3.0-kg ball and a 1.0-kg ball are placed at opposite ends of a massless beam so that the system…

A: The value of a=30cm  The mass of the left end =3kg The mass of the right end =1kg

Q: A beam resting on two pivots has a length of L = 6.00 m and mass M = 94.0 kg. The pivot under the…

A:

Q: Determine the net torque (about point P at one end) of the 4.0-m-long uniform beam shown in the…

A:

Q: A 0.120 kg, 50.0-cm-long uniform bar has a small 0.055 kg mass glued to its left end and a small…

A: Given: Mass of the bar = 0.120 Kg Length of the bar = 50 cm Mass at the other end = 0.110 Kg

Q: A pole is attached to a wall with a hinge as shown. A sign is suspended at the other end of a pole,…

A:

Q: Consider a see-saw with a total length of 8 m. A child with a mass of 31 kg sits on the very end of…

A: The free-body diagram of the see-saw is shown below.

Q: Determine the net torque (about point P at one end) of the 4.0-m-long uniform beam shown in the…

A:

Q: A 49.4 kg man walks to the end of a 34.0 kg, 12.6 m long diving board, that is being supported at…

A:

Q: A beam resting on two pivots has a length of L = 6.00 m and mass M = 92.0 kg. The pivot under the…

A:

Q: The plant in the picture has mass of 27 kg, and is hanging at a distance of 2.1 meters from the…

A:

Q: A beam resting on two pivots has a length of L = 6.00 m and mass M = 79.0 kg. The pivot under the…

A: Given: Length of beam= 6.00 m Mass of beam = 79.0 kg Distance between two pivots (l)=4 m Mass of…

Q: Calculate the net torque (magnitude and direction) on the beam in Figure PS.5 about (a) an axis…

A: Torque of a system is is given by- τ→=∑F→i×r→i Net torque through O axis, perpendicular to the page…

Q: Two children hold opposite ends of a lightweight, 1.8-m-long horizontal pole with a water bucket…

A:

Q: An irregularly shaped object 10 m long is placed with each end on a scale. If the scale on the right…

A: This is a question from classical mechanics. In this problem, we have to use the concept of the…

Q: Jackey is standing terrified and trembling at the end of a diving board, which is high above the…

A: Given data:  Mass (m) = 114 kg Distance from pivot point (r) = 2.9 m Required: Torque (τ)

Q: Suppose a person wishes to lift a large rock with the lever. If the rock has a mass Of 250 kg and is…

A:

Q: A rod is laying on top on two poles. The rod is uniform and has a length of 3.22 m. The left pole is…

A:

Q: A beam resting on two pivots has a length of  L = 6.00 m  and mass  M = 89.0 kg.  The pivot under…

A:

Q: 9. A rod of mass m is on a point support. The distance from theis point to one of the rod's ends is…

A:

Q: A see-saw consists of a uniform board with mass 43.6kg and length l = 2.01m. It supports two friends…

A: For the see-saw to balance, the torques due to the forces acting on either sides should balance each…

Q: A 5.0 kg cat and a 2.0 kg bowl of tuna fish are at opposite ends of a 4.0 m long seesaw. How far to…

A: In order to keep the seesaw in balance, the moment about the pivot point must be equal. Let the 4 Kg…

Q: A carpenter's square has the shape of an L as shown in the figure below. Locate its center of…

A:

Q: A beam resting on two pivots has a length of L = 6.00 m and mass M = 79.0 kg. The pivot under the…

A: Tipping Point: The tipping point is a position in which an object is placed such that, even a small…

Q: A beam resting on two pivots has a length of L = 6.00 m  and mass M = 89.0 kg.The pivot under the…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: The plant in the picture has mass of 29 kg, and is hanging at a distance of 2.2 meters from the…

A: In this question we are given that the plant in the picture has mass of 29 kg, and is hanging at a…

Q: A 6.20 [kg] square plate has side length of 3.25 [m] and is pivoted about an axis through its center…

A:

Q: The drawing below shows two forces acting on a rigid beam. The blue dot is the center of mass of the…

A: The net force is 0 The net torque is 0

Q: The cantilevered W530x 150 beam shown is subjected to a 8.3-kN force F applied by means of a welded…

A: The magnitude of force is 8.3 kN

Q: A 32.0 kg child sits on one end of a long uniform beam having a mass of 18.0 kg, and a 40.0 kg child…

A:

Q: At what distance from the fulcrum should a 20 N weight be placed to balance the system?

A: A beam is placed evenly on pivot point(fulcrum) On one side a 50N weight is placed 20cm from the…

Q: The larger ball in the picture has a mass m1 = 30 kg while the smaller ball has a mass m2 = 10 kg.…

A: The solution is given below

Q: A beam resting on two pivots has a length of L = 6.00 m and mass M = 87.0 kg. The pivot under the…

A: (f) -0.14 Nm

Q: A uniform plank of length 5.35 m and mass 26.9 kg rests horizontally across two horizontal bars of a…

A: suppose, the right scaffold part is free to walk by the painter.the distance from the center of mass…

Q: A beam resting on two pivots has a length of L = 6.00 m and mass M = 94.0 kg. The pivot under the…

A: The length of the beam, L = 6.00 m The mass of the beam, M = 94.0 kg The distance of separation…

Center of Gravity of a system

The centre of gravity is a property that is based on the geometry of a rigid body or any particle. It is described as an equilibrium point or a hypothetical location where the total weight of the body is concentrated.