A sinusoidal voltage wave is propagating on a low loss transmission line. The voltage as a function of position appears as shown below. From this plot, the phase constant B= Voltage 25 20 15 10 -15 -20 -25 10 20 30 40 50 60 70 80 90 100 Meters 0.562 0.314 0.625

A sinusoidal voltage wave is propagating on a low loss transmission line. The voltage as a function of position appears as shown below. From this plot, the phase constant B= Voltage 25 20 15 10 -15 -20 -25 10 20 30 40 50 60 70 80 90 100 Meters 0.562 0.314 0.625

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter13: Transmission Lines: Transient Operation

Section: Chapter Questions

Problem 13.14P

See similar textbooks

Related questions

Q: (=0.12 Z, = 502 Z Z, = 5+ j25 [S2] %3D 02 The 0.1 2 length line above has a characteristic impedance…

A: Reflection coefficient and angle of reflection coefficient…

Q: A 50 ohm distortionless transmission line has a capacitance of 10-10 F/m. What is the inductance per…

A: Given a distortion less transmission line having, Impedance, Zo=50 Ω Capacitance, C= 10-10 F/m

Q: A single phase transmission line has two parallel conductor 2.8 m apart, radius of each conductor is…

Q: 0,025 2. At a frequency of 4 MHz a parallel wire transmission line has the following parameters:…

A: Given data,R=0.025 Ω/mL=2 μH/mG=0C=5.56 pF/ml=100 mf=4 MHzZL=300 Ω

Q: The transmission line has the following data weight of the conductor = 6.5 kg/m, Tension in the…

A: For the given sag condition need to find the distance between the towers

Q: 02: A lossless transmission line of electric length 1= 0.35 A is terminated in a load impedance as…

A: Given that: i=0.35π , Zin = 60+30n Find Bl =2ππ× 0.35π…

Q: Solve for the admittance, Yab (magnitude only)

Q: 2.31 Plot the bounce diagram for the transient circuit shown in the accompanying figure. Include at…

Q: Q1. An equilateral transmission line has a total corona loss of 53 kW at 106 kV and a loss of 98 kW…

A: Given data, Corona loss P1=53 KW at V1=106 KV Corona loss P2=98 KW at V2=111 KV Phase voltage is…

Q: a) Certain measurements made at 5 kHz on a half kilometer long transmission line. The results show…

A: Given, length of transmission line, l = 0.5 km Frequency, f = 5kHz Characteristic impedance, zo=…

Q: Voltage reflection coefficient can be defined as: a) ratio of amplitude of reflected voltage wave to…

A: Voltage reflection coefficient is a very important parameter related to a transmission line. In the…

Q: Load impedance 30 + j10(N)is connected to the lossless transmission line 0.101 A and characteristic…

A: Load impedance 30+j10 Ω is connected to the lossless transmission line 0.101 λ and characteristic…

Q: A sinusoidal voltage wave is propagating on a low loss transmission line. The voltage as a function…

Q: At 29 MHz the characteristic impedance of a transmission line is (32- j2) ohm and the propagation…

A: Dear,as per company guidelines we can answer only one question at a time, kindly post other question…

Q: On a 150-2 lossless transmission line, the following observations were noted: distance of first…

A: The solution can be achieved as follows.

Q: I need the answer as soon as possible

Q: If Zo = 50 2, Vo* = 10 V, and the length of the line is 1.252, estimate the reflection coefficient…

A: given Z0= 50 ohm V+0= 10v Length of line = 1.25 Reflection coefficient at the load Cv = v/v =…

Q: A 3-phase transmission line has its conductors at the corners of an equilateral triangle with side…

A: Given, A 3 phase transmission line has its conductors at the corners of an equilateral triangle…

Q: 13. Find the reflection coefficient of a lossless transmission line with a Zo=50-j2592 is connected…

A: Given data, A lossless transmission line with, Z0=50-j25 Ω Connected to open circuit.

Q: 8. Assume a transmission line with Z = 75 – j25N and Zo = 502. Using the smith chart, find i) the…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: 1. Matching of a transmission line with a characteristic impedance (Zo) and a load impedance (Zn)…

A: Characteristics impedance in transmission line : The ratio of the voltage and current amplitudes of…

Q: Problem 14. A long transmission line has a char- acteristic impedance of (500-j40) № and is termin-…

A: Given a long transmission line with, Characteristics impedance, ZO=500-j40 Ω Terminated in an…

Q: Q) A transmission line of length 0.40X has a characteristic impedance of 100 n and is terminated in…

Q: Write a short note on each of the following 1) Propagation constant 2) Phase constant 3)…

A: Transmission line connection between the transmitter and receiver to permit signal transmission.…

Q: An antenna with a radiation resistance of 48 ohms, a loss resistance of 2 ohms, and a reactance of…

Q: The transmission line has the following data weight of the conductor = 8.2 kg/m, Tension in the…

A: Given, Weight of the conductor(w)=8.2 kg/m Tension in the conductor(T)=1765 kg Conductor sag(S)=4.2m…

Q: At a frequency of 4 MHz a parallel wire transmission line has the following parameters: R = 0.025…

Q: Q6: Calculate Zin at the load using smith chart for total transmission lines, while the wavelength…

Q: Q5: A lossless transmission line is terminated with (60+j30)Q load. The input impedance is…

A: In this question, Lossless transmission line Load impedance ZL = 60+j30 ohm Input impedance Zi =…

Q: A 3-phase transmission line has its conductors at the corners of an equilateral triangle with side 3…

A: we need to find out inductance of the line per phase per km.

Q: When the load impedance is equal to the characteristic impedance of the transmission lines, then the…

A: Calculation of reflection coefficient and standing wave ration, of the transmission lines when the…

Q: at 20 MHz the characteristic impedance of a transmission line is (20-j2) ohm and the propagation…

A: Given, Frequency (f) = 20 MHz Characteristic impedance of a transmission line, Zo = 20 - j 2 ohm…

Q: Derive the following formula for a transmission line's voltage reflection coefficient (all symbols…

Q: Use the Smith chart to find the following quantities for the transmission line circu below where ZL…

Q: Q6: Calculate Zin at the load using smith chart for total transmission lines, while the wavelength…

Q: On a distortionless line, the voltage wave is given by V(e') = 120e0025e cos(10°t + 20') +…

A: The given wave signal is combination of the incident and reflected wave. The first term is incident…

Q: A microstrip patch-type antenna has 240-j80 Ω input impedance at 1 GHz. Match this impedance to 50 Ω…

A: Given input impedance Zi= 240-j80 ohms Frequency =1GHz Load impedance ZL= 50 ohms For quarter wave…

Q: A 500 transmission line is biased with a load with impedance ZL=100-j20on. Its wavelength is 12cm.…

Q: Compute the voltage drop across the transmission line, ETL = E1 – E2, in both polar and cartesian…

A: A diagram of a two bas bur power system is shown in the question. We need to determine the voltage…

Q: Answer all subpart I will thumbs up... Consider a three-phase single circuit transmission line 362…

A: R = 0.1069 ohm/km L = 1.3549 mH/km C = 0.0085 microfarad/km G = 0 transmission line = 362 km long VR…

Q: what is expected VSWR for a transmission line with a reflection coefficient of 0.377

A: Given data Reflection coefficient is τ=0.377 Calculating expected VSWR…

Q: A transmission line has a characteristic impedance of 300 N and is terminated in a load of 300 -…

Q: An antenna with a radiation resistance of 48 ohms, a loss resistance of 2 ohms, and a reactance of…

Q: A transmission line of characteristic impedance of Zo=50 ohm with length of A/4 loaded by a load…

A: Given: A transmission line is having Characteristic equation, Z0=50 Ω Length, L=λ4 Load impedance,…

Q: The input impedance of a 75Ω lossless transmission line is measured to be (150- j75Ω) at 0.21λ away…

A: It is given that: Zo=75 ΩZin=150-j75 Ωl=0.21 λ

Q: Coaxial cable of an infinite produces reflection coefficient of – 0.3 + j0.4 when terminated in a…

A: Given: Coaxial cable of an infinite produces reflection coefficient of (-0.3+j0.4) when terminated…

Q: A lossless vacuum-filled transmission line of characteristic impedance R. = 1000 is terminated by a…

Q: :: A lossless transmission line is terminated with (80+j45) Q load. The characteristic impedance is…

A: We need to find out reflection coefficient and standing wave ratio .

Q: Q5: A lossless transmission line is terminated with (80+j45) Q load. The characteristic impedance is…

Concept explainers

Compensation Techniques

The compensation techniques are the methods that are employed in the electrical control systems to enhance the performance of the system. The performance are generally affected by the factors like lag in the compensating devices, slow response of the system of the components like sensors used in the control system. The basic compensation technique involves lag compensation, lead compensation or the combination of the both.

Question

A sinusoidal voltage wave is propagating on a low loss transmission line. The voltage as a function of position appears as shown below. From this plot, the phase constant B=
Voltage
25
20
15
10
-10
-15
-20
-25
10
20
30
40
50
60
70
80
90
100
Meters
0.562
0.314
0.625
0.489

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Compensation Techniques in Transmission Line

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The capacitance per unit length and the characteristic impedance of a lossless Transmission line are C and Z0 respectively. Express the velocity of travelling wave on the transmission line in terms of the two given parameters above.
A 105MHz, 90 v peak signal is incident on a 50-ohm transmission line. The line is 125m long and is terminated in 300-ohm load. What is the SWR for this situation? Find the reflection coefficient.
For a lossless trabsmisison line, the characteristic impedance is 80 ohm. If the capacitance per unit length is 1.5 mh/m then what will be the inductance per unit length.
A transmission line in air with characteristic impedance Z0=50 ohm is terminated with a load impedance ZL ohm. What is the propogation constant k of the transmission line (assuming a coaxial line) for a 100 MHz uniform plane wave? What is the equivalence impedance of Z(-l) at l=.75m when ZL=25-j200 ohm? Calculate the shunt admittance to be added at l=.75m so that the line matched.
Express the velocity of wave on a lossless line in terms of c and z0 with proper derivative. C is capacitance of transmission line
Derive an expression for sag in a transmission line of equal height poles
A transmission line is not properly terminated thereby causing a a reflection coefficient magnitude of 0.5 where the reflected current is in phase with the incident current at the point of reflection. What is the impedance of the termination if the characteristic impedance of the line is 50 ohms?
The capacitance per unit length and the characteristic impedance of a lossless transmission line is C and Zo, respectively. Find the velocity of a travelling wave on the transmission line.
The observed standing-wave ratio on a 100-Ω lossless line is 8. If the first maximum voltageoccurs at 0.3λ from the load, calculate the load impedance and the voltage reflection coefficientat the load. (use smith chart) How do you use a smith chart to solve this?
a) Discuss the effect of primary constants of a transmission lines onsignal propagation b) Using mathematical theories discuss how the standing wave phenomenon comes about and what can be done to eliminate it completely. c) Develop an expression for voltage and current traveling on atransmission line assuming all its primary constants are uniformlydistributed.
The observed standing wave ratio on a 100 Ω lossless line is 8. If the first voltage maximum occurs at 0.3λ from the load, calculate ZL and voltage reflection coefficient at the load.
In terms of line-to-line capacitance, the line-to-neutral capacitance of a single-phase transmission line is Same Twice One-half