A small piece of iron with a mass of 52.7 grams is heated from 20 degrees Celsius to 31.7 degrees Celsius. How much heat did the iron absorb? The specific heat of iron is 0.450 J/gºC. Remember to round to the nearest 0.01 and include units, capitalized and abbreviated properly.

A small piece of iron with a mass of 52.7 grams is heated from 20 degrees Celsius to 31.7 degrees Celsius. How much heat did the iron absorb? The specific heat of iron is 0.450 J/gºC. Remember to round to the nearest 0.01 and include units, capitalized and abbreviated properly.

Introductory Chemistry For Today

8th Edition

ISBN:9781285644561

Author:Seager

Publisher:Seager

Chapter6: The States Of Matter

Section: Chapter Questions

Problem 6.104E

See similar textbooks

Similar questions

During a recent winter month in Sheboygan, Wisconsin, it was necessary to obtain 3500 kWh of heat provided by a natural gas furnace with 89% efficiency to keep a small house warm (the efficiency of a gas furnace is the percent of the heat produced by combustion that is transferred into the house). (a) Assume that natural gas is pure methane and determine the volume of natural gas in cubic feet that was required to heat the house. The average temperature of the natural gas was 56 F; at this temperature and a pressure of 1 atm, natural gas has a density of 0.68 1 g/L. (b) How many gallons of LPG (liquefied petroleum gas) would be required to replace the natural gas used? Assume the LPG is liquid propane [ C3H8 : density, 0.5318 g/mL; enthalpy of combustion, 2219 Id/mo for the formation of CO2(g) and H2O(l) ] and the furnace used to burn the LPG has the same efficiency as the gas furnace. (c) What mass of carbon dioxide is produced by combustion of the methane used to heat the house? (d) What mass of water is produced by combustion of the methane used to heat the house? (e) What volume of air is required to provide the oxygen for the combustion of the methane used to heat the house? Air contains 23% oxygen by mass. The average density of air during the month was 1.22 g/L. (f) How many kilowatt—hours ( 1kWh=3.6106 J) of electricity would be required to provide the heat necessary to heat the house? Note electricity is 100% efficient in producing heat inside a house. (g) Although electricity is 100% efficient in producing heat inside a house, production and distribution of electricity is not 100% efficient. The efficiency of production and distribution of electricity produced in a coal-fired power plant is about 40%. A certain type of coal provides 2.26 kWh per pound upon combustion. What mass of this coal in kilograms will be required to produce the electrical energy necessary to heat the house if the efficiency of generation and distribution is 40%?
aIs the process of boiling water exothermic or endothermic with respect to the water? bA charged object is moved closer to another object that has the same charge. The energy of the system changes. Is it a change in kinetic energy or potential energy? Is the energy changes an increase or a decrease?
A particulate-level illustration of the reaction AB+CDAD+CB is shown below. a Identify the reactants and products in this reaction. b Is the change shown chemical or physical? c Is the mass of the product particles less than, equal to, or greater than the mass of the reactant particles? d If the reaction takes place in a container that allows no energy to enter or leave, how does the total energy in the container after the reaction compare with the total energy in the container before the reaction?
What are the differentiating factors between potential and kinetic energy? a.Properties-physical or chemical b.State-solid or liquid c.Temperature-high or low d.Activity-in motion or in storage
A hot metal block is plunged into water in a well-insulated container. The temperature of the metal block goes down, and the temperature of the water goes up until their temperatures are the same. A total of 1500 J of energy' is lost by the metal object. By how much did the energy of the water increase? What law of science is illustrated by this problem?
During a very cold winter, the temperature may remain below freezing for extended periods. However, fallen snow can still disappear, even though it cannot melt. This is possible because a solid can vaporize directly, without passing through the liquid state. Is this process (sublimation) a physical or a chemical change?
Classify each pure substance represented below by a capital letter as an element or a compound. Indicate when such a classification cannot be made, and explain why. a. Two elements when mixed combine to form only substance L. b. An element and a compound when mixed form substances M and Q. c. Substance X is not changed by heating.
Energy conservationists suggest that air conditioners should be set so that they do not turn on until the temperature tops 78 F. What is the Celsius equivalent of this temperature?
The following photo shows the element potassium reacting with water to from the element hydrogen, a gas, and a solution of the compound potassium hydroxide. (a) What states of matter are involved in the reaction? (b) Is the observed change chemical or physical? (c) What are the reactants in this reaction, and what are the produces? (d) What qualitative observations can be made concerning this reaction?
1-86 The specific heats of some elements at 25oC are as follows: aluminum = 0.215 cal/g · oC; carbon (graphite) = 0.170 caI/g oC; iron = 0.107 cal/g mercury = 0.033 1 caI/g oC. (a) Which element would require the smallest amount of heat to raise the temperature of 100 g of the element by 10oC? (b) If the same amount of heat needed to raise the temperature of 1 g of aluminum by 25oC were applied to 1 g of mercury, by how many degrees would its temperature be raised? (c) If a certain amount of heat is used to raise the temperature of 1.6 g of iron by 10oC, the temperature of 1 g of which element would also be raised by 10oC, using the same amount of heat?