A solenoid having an inductance of 6.05 µH is connected in series with a 1.17 k2 resistor. (a) If a 18.0 V battery is connected across the pair, how long will it take in seconds for the current through the resistor to reach 80.7% of its final value? (b) What is the current through the resistor at a time t = 1.00TL? (a) Number (b) Number Hint i 8.504 eTextbook and Media Save for Later 9.72E-3 Last saved 1 hour ago. Units Units A times ♦ Attempts: 2 of 4 used Submit Answer

A solenoid having an inductance of 6.05 µH is connected in series with a 1.17 k2 resistor. (a) If a 18.0 V battery is connected across the pair, how long will it take in seconds for the current through the resistor to reach 80.7% of its final value? (b) What is the current through the resistor at a time t = 1.00TL? (a) Number (b) Number Hint i 8.504 eTextbook and Media Save for Later 9.72E-3 Last saved 1 hour ago. Units Units A times ♦ Attempts: 2 of 4 used Submit Answer

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter14: Inductance

Section: Chapter Questions

Problem 52P: In Figure 14.12, =12V , L = 20 mH, and R=5.0. Determine (a) the time constant of the circuit, (b)...

See similar textbooks

Similar questions

Check Your Understanding (a) Calculate the self-inductance of a solenoid that is tightly wound with wire of diameter 0.10 cm, has a cross-sectional area of 0.90 cm2, and is 40 cm long. (b) If the current through the solenoid decreases uniformly from 10 to 0 A in 0.10 s, what is the emf induced between the ends of the solenoid?
A long, cylindrical solenoid with 100 turns per centimeter has a radius of 1.5 cm. (a) Neglecting end effects, that is the self-inductance per unit length of the solenoid? (b) If the current through the solenoid changes at the rate 5.0 AJs, what is the emf induced per unit length?
Suppose that a rectangular toroid has 2000 windings and a self-inductance of 0.040 H. If h = 0.10 m, what is the ratio of its outer radius to its inner radius?
What resistance R must be connected in series with a 200-mH inductor of the resulting RLC oscillating circuit is to decay to 50% of its initial value of charge in 50 cycles? To 0.10% of its initial value in 50 cycles?
Show that for the circuit shown below, the initial energy stored in the inductor, LI2(0)/2 , is equal to the total energy eventually dissipated in the resistor 0I2(t)Rdt.
Check Your Understanding. A changing current induces an emf of 10 V across a 0.25-H inductor. What is the rate at which the current is changing?
Check Your Understanding How much energy is stored in the inductor of Example 14.2 after the current reaches its maximum value?
Check Your Understanding (a) What is the magnetic flux through one turn of a solenoid of self- inductance 8.0 × 10-5 H when a current of 3.0 A flows through it? Assume that the solenoid has 1000 turns and is wound from wire of diameter 1.0 mm. (b) What is the cross-sectional area of the solenoid?
A steady current flows through a circuit with a large induct3ve time constant. When a switch in the circuit is opened, a large spark across the terminals of the switch. Explain.
Show that the self-inductance per unit length of an infinite, straight, thin wire is infinite.
Check Your Understanding (a) If the current in the circuit of in Figure 14.12(b) increases to 909 of its final value after 5.0 s, what is the inductive time constant? (b) If R=20 , what is the value of the self-inductance? (c) If the 20 resistor is replaced with a 100 resister, what is the time taken for the current to reach 90% of its final value?
A small, rectangular single loop of wire with dimensions 1, and a is placed, as shown in the plan of a much larger, rectangular single loop of wire. The two short sides of the larger loop axe so far from the smaller loop that their magnetic fields over the smaller fields over the smaller loop can be ignored. What is the mutual inductance of the two loops?