An ammeter measures current in a circuit. The switch in the circuit is originally opened and the ammeter reads 2.3 A. When the switch is closed, the reading on the ammeter (A) will (choose from below). R2₂ ww S R₁ a) be greater than 2.3 A. b) be less than 2.3 A. c) stay the same, 2.3 A. d) change in an unpredictable way.

An ammeter measures current in a circuit. The switch in the circuit is originally opened and the ammeter reads 2.3 A. When the switch is closed, the reading on the ammeter (A) will (choose from below). R2₂ ww S R₁ a) be greater than 2.3 A. b) be less than 2.3 A. c) stay the same, 2.3 A. d) change in an unpredictable way.

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter20: Induced Voltages And Inductance

Section: Chapter Questions

Problem 16P: Find the direction of the current in the resistor shown in Figure P20.16 (a) at the instant the...

See similar textbooks

Similar questions

Find the direction of the current in the resistor shown in Figure P20.16 (a) at the instant the switch is closed, (b) after the switch has been closed for several minutes, and (c) at the instant the switch is opened. Figure P20.16
Analog meters use a galvanometer, which essentially consists of a coil of wire with a small resistance and a pointer with a scale attached. When current runs through the coil, the point turns; the amount the pointer turns is proportional to the amount of current running through the coil. Galvanometers can be used to make a voltmeter if a resistor is placed in series with the galvanometer. Consider a galvanometer that has a resistance of 25.00 and gives a full scale reading when a 50A current runs through it. The galvanometer is to be used to make an voltmeter that has a full scale reading of 10.00 V, as shown below. Recall that a voltmeter is connected in parallel with the component of interest, so the meter must have a high resistance or it will change the current running through the component, (a) What is the potential drop across the series resistor in the meter? (b) What is the resistance of the parallel resistor? Av = lo.oo v
Consider the circuit shown below. (a)Determine the equivalent resistance and the current from the battery with switch S1 open, (b) Determine the equivalent resistance and the current from the battery with switch S1 closed.
Integrated Concepts Derive an expression for the current in a system like that in Figure 23.11, under the following conditions. The resistance between the rails is R, the rails and the moving red are identical in cross section A and have the same resistivity . The distance between the rails is l, and the rod moves at constant speed v perpendicular to the uniform field B. At time zero, the moving red is next to the resistance R.
In this problem, you will verify statements made at the end of the power losses for Example 20.10. (a) What current is needed to transmit 100 MW of power at a voltage of 25.0 kV? (b) Find the power loss in a 1.00 transmission line. (c) What percent loss does this represent?
The switch is closed in Figure 18.20. After a long time compared with the time constant, of the circuit, what will the current be in the 2- resistor? (a) 4 A (b) 3 A (c) 2 A (d) 1 A (c) More information is needed. Figure 18.20 (Quick Quiz 18.9)
A particle accelerator sends highvelocity charged particles down an evacuated pipe. Explain how a coil of wire wrapped around the pipe could detect the passage of individual panicles. Sketch a graph of the voltage output of the coil as a single particle passes through it.
A 0.0200- ammeter is placed in series with a 10.00- resistor in a circuit, (a) Draw a circuit diagram of the connection, (b) Calculate the resistance of the combination, (c) If the voltage is kept the same across the combination as it was through the 10.00- resistor alone, what is the percent decrease in current? (d) If the current is kept the same through the combination as it was through the 10.00-resistor alone, what is the percent increase in voltage? (e) Are the changes found in parts (c) and (d) significant? Discuss.
During open-heart surgery, a defibrillator can be used to bring a patient out of cardiac arrest. The resistance of the path is 500 and a 10.0-mA current is needed. What voltage should be applied?
You have been called in as an expert witness in a civil case. The case involves a dispute between neighbors. The plaintiff neighbor is complaining about a buzzing noise during the night that prevents the plaintiff from sleeping. He claims that the buzzing is coming from a light fixture on the defendants porch ceiling. The defendant likes to do installations and repairs himself and has done a sloppy job of installing the light fixture. The fixture hangs vertically from a single wire that is attached through the porch ceiling and down the wall to one connector in a nearby electrical outlet. The second wire is hung horizontally with strings at the level of the light and then runs down the wall to the other connector in the outlet. The defendant leaves the light on all night long for security. Recalling his high school physics, the plaintiff states that the combination of the 60-Hz household voltage and the magnetic field of the Earth results in an oscillating driving force on the single wire from which the light fixture hangs vertically. This, in turn, sets up a standing wave in the wire, and that is the cause of the buzz. You have been hired by the defense attorney. Upon hearing the details of the case, you obtain permission from the defendant and make measurements. The mass of the light fixture is 17.5 kg. The vertical wire from which it hangs is 0.150 m long and has a mass of 0.030 kg. Is the plaintiff correct that the magnetic field of the Earth is causing the buzzing of the wire? Ignore any effect of the second wire.
Integrated Concepts A short circuit to the grounded metal case of an appliance occurs as shown in Figure 23.60. The person touching the case is wet and only has a 3.00 k(resistance to earth/ground. (a) What is the voltage on the case if 5.00 mA flows through the person? (b) What is the current in the short circuit if the resistance of the earth/ground wire is 0.200 ? (c) Will this trigger the 20.0 A circuit breaker supplying the appliance? Figure 23.60 A person can be shocked even when the case of an appliance is grounded. The large short circuit current produces a voltage on the case of the appliance, since the resistance of the earth/ground wire is not zero.
While taking a bath, a person touches the metal case of a radio. The path through the person to the drainpipe and ground has a resistance of 4000- . What is the smallest voltage on the case of the radio that could cause ventricular fibrillation?