A stack gas fiowing at 80 m/nin (at T= 25 °C and 1 atm) con- tains approximately 75% N2, 5% O2, 8% H,0, and 12% CO2.
Q: B/ design circular tank to treat 5000m3/day of water with particles of 0.003cm, specific density…
A:
Q: Three cylinders are piled in a rectangular ditch as shown in the Figure 2 neglecting friction. Wa=…
A:
Q: A water plant treating 30000 m³/day. The rapid mixing is used tank blend 35 mg/L of alum with the…
A: The water treatment plant is used to remove bacteria or pathogenic substances from the tank.…
Q: Question Design high rate treickling ter for troeating a waste water with BOD of 160 mg|L The mate…
A:
Q: A vertical circular stack 100 ft. high converges uniformly from a diameter of 20 ft at the bottom to…
A:
Q: 3. The effective height of the stack of a power plant is 125 ft. The plant burns 5 ton of lignite (a…
A: Plume dimensions can be calculated as follows: The flame height correlation by Heskestand is given…
Q: y the gas during the expansion process. The E and 0.1 m/kg of specific volume. Final specifie…
A: Isothermal process data we have given that PV =1000 P1 = 1000 Kpa P2 = 500 Kpa P1V1…
Q: brine. tly to into the water table. The concentration of chloride in the be img/L. The flow in the…
A: In this question ,we have to find out Hydraulic gradient i from given data
Q: Efficiency of an ESP is a function of the flue gas characteristics (temperature and moisture),…
A: solution Given drift velocity W=1 msecArea A=100m2flow rate Q=40 m3sec
Q: (a) If 12 m³ of nitrogen at 30°C and 125 kPa abs is permitted to expand isothermally to 30 m³, what…
A:
Q: Problem 3 - 112 Would a wooden cylinder (sp. gr. be stable if placed vertically in oil (sp. gr. =…
A:
Q: 2. An activated sludge system is to treat wastewater from a population of 10,000 PE. The wastewater…
A: BODi=300 mglSSi=400 mglQ=10,000 m3d=10MLDηBOD removal=30%ηBOD removal =60%Y=0.5 kgkgkd=0.05 per…
Q: the energy correction co level in the tank luding secondary losses,
A:
Q: A flue gas contains mainly 15 micron sized particles (density 2000 kg/m3) to be removed by a cyclone…
A: INTRODUCTION- Flue gas also known as exhaust gas or stack gas is a gas emitted by combustion plants…
Q: 1. Steam at 2.0 kPa is saturated at 17.5C. In what state will the steam be at 40C if the pressure is…
A: Given data- 1. Case-(a) Steam at 2.0 kPa is saturated at 17.5C Case-(b) Temperature=40C , pressure…
Q: Glycerin (specific gravity 1.26) in a processing plant flows in a pipe at a rate of 805 L/s. At a…
A: Given data:
Q: roblem 3- 104 Vater in a tank is pressurized to 80 cmHg. Determine the total force per meter ridth…
A: Calculate the pressure at B and A using hydrostatics then force can be calculated as area of…
Q: 2. An activated sludge system is to treat wastewater from a population of 10,000 PE. The wastewater…
A: Given,Q=10000 PEBOD5 =300 mg/LSS=400 mg/LY=0.5 kg/kgkd=0.05 per day MLSS=3000 mg/LX=3000 mg/LFor…
Q: erage flow of 100,000 Itrated a pipe 1,500 ft d the concentration at is 5 mg/L. The storage
A: velocity in pipes =v =2.5 ft/sdistance of first point = 1500 ft-500 ft =1000 ftso that time taken…
Q: A black oil reservoir has been just discovered. The reservoir pressure is above the bubble point…
A: since reasevaior pressure is more than the bubble pressuretherefore the reservaior is undersaturated…
Q: A PFR is not meeting effluent requirements so baffles are going to be added to the tank to increase…
A: solution Given data The tank is 12 ft deep, 40 ft wide, and 120 ft long. current HRT is 0.5 d Ci= 9…
Q: A/Determine the dimensions of settling tank to treat 1000m/day of water with particles of 0.02mm and…
A:
Q: A full scale agitation system that has a flat blade turbine impeller with six blade-disk is used in…
A: The volume of the scale down system is one-fourth of the large scale volume. The ratio of the volume…
Q: Nitrogen gas at 50°C is under a pressure of 630 kPa. Assume a gas constant of 296.8 J/kg-K.…
A:
Q: Determine theoretical oxygen demand (mg/L) for 250 mg/L of methanol (CH3OH). CH,0H + 02→ C0, + H,0…
A:
Q: Q.68 An activated sludge tank is 30 m long 9 m wide and has liquid depth of 4 m. The influent sewage…
A: Given data- Dimensions of the sludge tank=30m×9m×4mInfluent sewage flow Qo=3.5 MLDBOD So=130mg/LMLSS…
Q: s in oil (op.gr.=o.82) e water sarface
A: Given data- Specific gravity (SG) = 0.82 Head at point A = 2m Difference between level of tubes (x)…
Q: The concentration of vinyl chloride 3.5 km downwind from a continuous release 10 m high is 8 mg/m3.…
A: Given, Concentration of vinyl chloride =3.5 km C1=8 mg/m3 Wind speed = 25 km/hour
Q: An electrostatic precipitator (ESP) with 5600 m² of collector plate area is 96 percent efficient in…
A: Given data- Area A1=5600 m2efficiency n1=96%efficiency n2=99%To Find-ESP collector area A2
Q: 3. Just below the point where a continuous discharge of pollution mixes with a river, the BOD is…
A:
Q: Small droplets of carbon tetrachloride at 68 °F are formed with a spray nozzle. If the average…
A:
Q: Small droplets of carbon tetrachloride at 68 °F are formed with a spray nozzle. If the average…
A: Given - Diameter of the Droplet = 240 um Temprature = 68 °F Find = Pressure difference between the…
Q: . A vertical circular stack 30 m high converges uniformly from a diameter of 6 m at the bottom and…
A: Given Data:Height of circular stack = 30mConverge dia at bottom=6mConverge dia at Top= 4.5mUnit…
Q: Small droplets of carbon tetrachloride at 68 °F are formed with a spray nozzle. If the average…
A:
Q: A settling tank having a depth of 3.5m and surface area of 1000m^2 is used to remove particle of…
A: Given:- The depth of the settling tank = 3.5 m The surface area of the tank = 1000 m2 The size of…
Q: A vertical circular stack 30 m high converges uniformly from a diameter of 6 m at the bottom and 4.5…
A:
Q: 3.40 WP To maximize production and minimize pumping costs, crude oil is heated to reduce its…
A:
Q: Determine theoretical oxygen demand (mg/L) for 250 mg/L of methanol (CH3OH). CH,0H + 02 → C0, + H,0…
A:
Q: The sulfur dioxide (SO 2 ) stack gas concentration from fossil fuel combustion is 2 ppmv. Determine…
A: 1 percent by volume is equal to 104 ppm.2 percent by volume is equal to 2*104 ppm.
Q: An oil of viscosity 0.4 stoke is transported through a pipe of diameter 30 cm and length 50 m at a…
A: Given: Viscosity of oil = 0.4 stoke = 0.4 x 10-4 m2/s Diameter of pipe, d = 30 cm = 0.3 m Length of…
Q: Problem A gas weighs 16 N/m³ at 25°C and at an absolute pressure of 0.25 N/mm². Deter- mine the gas…
A: Given: Weight Density w =16 N/m3, Temperature τ=25+273=288 K, Absolute Pressure p=0.25…
Q: What type of reactor meets with the following conditions? 1) complete mixing; 2) continuous flow
A:
Q: When analyzing the stack gases, the analysis is reported in what unit?
A: The stack gas is the gas released through processes of combustion and the composition of stack gas…
Q: 1. A 770,000 gal conventional activated sludge pro- cess has a recycle ratio of 0.25, an influent…
A: Volume of sludge (V) = 770 X 103 galons Recycle ratio (Xt / X – Xt) = 0.25 Influent flow rate = 1MGD…
Q: Calculate the discharge from a tube well of 20-cm diameter penetrating fully into a ined aquifer of…
A: given diameter of wall d1= 20 cm depth of aquifer = 20m k = 40 m/day Sw = 3m
Calculate the gas molecular weight.
Trending now
This is a popular solution!
Step by step
Solved in 3 steps
- What is the required free chlorine concentration to inactive 2 logs of Cryptosporidium at a water temperature of 25oC, if the flow rate is 1000 m3/day and the clearwell storage tank is 2 m wide by 2 m long and 1 m deep? (Assume plug flow conditions and full basin) *Hint : final answer C = 26 mg/LAn open cylindrical tank contains 1.2 m of salt water (sp.gr = 1.03), 0.9 m of gasoline (sp.gr = 0.70) and 1.2 m ofoil (sp.g r= 0.85).1. What is the pressure 1.5 m below the liquid surface?A PFR is not meeting effluent requirements so baffles are going to be added to the tank toincrease contact time. The tank is 12 ft deep, 40 ft wide, and 120 ft long. The engineer isgoing to add long baffles to the tank. The baffles will be 90% of the tank length. If thecurrent HRT is 0.5 d, and the influent concentration is 9 mg/L with an effluent limit of 1.5mg/L, how many baffles need to be added? Assume k=1.98/day
- A vertical circular stack 30 m high converges uniformly from a diameter of 6 m at the bottom and 4.5 m at the top. Gas with a unit weight of 0.12 N per cubic meter enters the bottom of the tank with a uniform velocity of 0.334 m/sec enters the stack. The unit weight increases by 7.5 percent every 2 meters. Find the velocity of flow at every 5 meters along the stack. Graph velocity at the abscissa against height at the ordinate (PLEASE USE COMPLETE SOLUTION AND FIGURES)The gauge pressure reading under a settling tank is 57 78 kilopascal. The settling tank has a radius of 4.2 meters Calculate the height of the fuel inside given that its SG is 0.88 MT/m 3The sulfur dioxide (SO 2 ) stack gas concentration from fossil fuel combustion is 2 ppmv. Determine the stack gas SO2 concentration in units of ug/m 3 . Assume 0°C and 1 atm pressure.
- A vulcanizing shop has a trapezoidal drum that is 5 meters long, 1.5 meter wide at the top, 1 meter wide at the bottom, and 1 meter deep. If the hose fills up the drum at 0.32 cubic meter per minute, find the rate of the rising water once it fills up half of the drum. Neglect the existence of the drum’s thickness.A settling chamber is to be used to collect particles with a density of 1200 kg/m3 from an air stream at 1.013 bars and 350 degrees kelvin. The volume flow rate is 2 m3/s. The overall chamber is 2.5m high, 3m wide. (a) What is the value of Re for the gas flow (b) How long a chamber is required for 85 percent removal efficiency of 60 micrometers diameter particles1. A 1.5” S40 pipe has a capacity of ______ cu. ft/sec. at a 1 ft/sec. velocity. A. 0.0031 B. 1.7672 C. 0.0332 D. 0.0123 2. The bulk density of impure alumina oxide in lb/ft3 is A. 0.70 B. 80 C. 90 D. 60 3. Tetrahydrofuran has a vapor pressure of ______ mmHg at 176 deg. F A. 200 B. 1518 C. 1173 D. 2 562
- The concentration of vinyl chloride 3.5 km downwind from a continuous release 10 m high is 8 mg/m3. It is sunny and the wind speed is 25 km/hr. Determine the average concentration at a point 0.6 km perpendicular and 3.5 km downwind of the plume. Assume the ambient emission condition is “rural”.and temperature. Calculate the density of the gas.Q.4: If the gas oil ratio = 560 Scf/STB at initial pressure of 4300 psia, calculate the GOR at bubble point pressure of 3500 psia and at pressure of 1900 psia.Provide a reasonable design for a 99,4% efficient ESP treating 30,000 m3/mm of gas, The dust has a resistivity of 7.1(10)10 ohm-cm.