A trapeze artist with swing weighs 800n; he is momentarily held to one side by his partner so that the swing ropes make an angle of 25.0 degrees with the vertical. In such a condition of static equilibrium, what is the horizontal force being applied by the partner?

A trapeze artist with swing weighs 800n; he is momentarily held to one side by his partner so that the swing ropes make an angle of 25.0 degrees with the vertical. In such a condition of static equilibrium, what is the horizontal force being applied by the partner?

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter14: Static Equilibrium, Elasticity, And Fracture

Section: Chapter Questions

Problem 31PQ: A wooden door 2.1 m high and 0.90 m wide is hung by two hinges 1.8 m apart. The lower hinge is 15 cm...

See similar textbooks

Related questions

Q: A 80kg carpenter stands on a 30ON scaffold (a uniform rectangular board) with one rope supporting…

A: The situation can be described here where length of scaffold is 2L.

Q: A ladder of length 3.00m and mass 25.00 kg leans against a smooth vertical wall so that the angle…

A: The free-body diagram of a ladder is shown below. Here, m denotes the ladder’s mass, H denotes the…

Q: The light boom AB is attached to a vertical wall by a ball and socket joint at A and supported by…

A: Calculate the position coordinates of points O, A, B, C, and D.

Q: A trapeze artist, with swing, weighs 800 N; he is momentarily held to one side by his partner so…

A: Given: The weight is 800 N. The angle made by the rope with the vertical is 30o. The free-body…

Q: How much compression acts on the hip during two-legged standing, given that the joint supports 250 N…

A: Looking at the components Rcosα=Fmcos70=600cos70Rsinα=mg+Fmsin70=250+600sin70

Q: What is the magnitude and direction of the single force applied to make the two concurrent forces…

A: A set of forces whose lines of action come through a common point iscalled concurrent forces.…

Q: An 800-N billboard worker stands on a 4.0-m scaffold weighing 500 N and supported by vertical ropes…

Q: A uniform horizontal beam with a length of 9.3 m and a weight of 234.9 N is attached to a wall by a…

A: Given:- A uniform horizontal beam with a length ofL= 9.3 m a weight of 234.9 N is attached to a…

Q: What would be the maximum weight W of the block, shown in the following figure, so that the tension…

A: ∑Fx = 0TBC cos40 = TAC sin 30TBC = TAC sin 30cos40 ............eq(1)

Q: A 60 kg diver stands at the end of a 30 kg springboard, as shown. The board is attached to a hinge…

A: Given data The mass of the springboard is, M1= 30 kg The mass of the diver is, M2= 60 kg Step 1 The…

Q: F= 5.2+35 Q5/ Compute the magnitude of force (F) and the vertical reaction at point (A) of…

A: The applied force at the point B is given as, The x and y-components of an applied force are given…

Q: During a walk on a rope, a tightrope walker creates a tension of 3.94 × 103 N in a wire that is…

Q: e and 40 kN vertical force is directed 53 degrees wrt x axis to the upper right, at what angle (in…

A: The horizontal force F1 = 30 KN The vertical force is directed 53 degrees wrt x-axis to the upper…

Q: An 700N window cleaner stands on a 3.0 m uniform scaffold that weighs around 400 N. It is supported…

A: Write a given values of this question. Draw a free body diagram. T=540NL=3m Weight of scaffold is…

Q: A child with a mass of 46 kg sits at a distance of 2.0 m from the pivot point of a seesaw. Where…

Q: A 10 m ladder with a mass of 15 kg leans against the wall. If the ladder is in static equilibrium,…

A: We have a ladder of length L=10 m having mass M=15 kg which leans on a frictionless wall. Assuming…

Q: A person with 100kg mass is standing erect on the tip of both feet. Find the contact force Cexerted…

A: Mass of person, m=100kg Let contact force be C Muscle force F at 37° to horizontal Distance between…

Q: A uniform platform with mass M=30kg and length L=15m is placed on two supports as shown. The…

A: A mass of a uniform platform,

Q: A person is standing on a section of uniform scaffolding as shown in the figure. The section of…

Q: sign is hung from the wall of a building using an angled beam and a support cable. The beam (mass =…

A: Solution

Q: A uniform horizontal beam with a length of 9.1 m anda weight of 235.3 N is attached to a wall by a…

Q: As shown in the figure below, a uniform beam is supported by a cable at one end and the force of…

A: Given Data: The length of a beam is, L=4.75 m The coefficient of static friction between the wall…

Q: How far would the worker stand from one of the supporting ropes

A: Given data: The weight of the billboard worker is: W = 650 N The length of scaffold is: L= 4.05…

Q: ent Attempt in Progress me drawing shows a uniform horizontal beam attached to a vertical wall by a…

Q: What would be the maximum weight W of the block, shown in the following figure, so that the tension…

Q: The 1,094 kg uniform beam is subjected to the three external loads shown. Compute the force reaction…

A: Given data- weight of beam W=mg=(1094 kg)(9.8 m/s2)=10721.2 N=10.7 kN at point A=1.4 kN=1400 N…

Q: A 3-meter rod with a weight of 1000 N is suspended by two cables and has a large box(3500N in weight…

A: Consider the free body diagram below.

Q: What would be the maximum weight W of the block, shown in the following figure, so that the tension…

Q: a beam of wood with mass 13 kg is supported at two points. The distances from the center of mass of…

A: SOlution: Given that m = 13 kg x1 = 3.1 m x2 = 2.2 m

Q: The 533 kg uniform beam is subjected to the three external loads shown. Compute the force reaction…

Q: fisherman has caught a fish on his pole, and to keep the pole steady he has to apply an upward force…

A: in this question we use conservation of tarque for one point and then net force of system is at…

Q: A uniform plank of length L=2.7m and weight W =735N is supported by three ropes as indicated in the…

A: Given information: The symbols have the same meaning as given in the question.

Q: A uniform beam of weight 12 N and length 10 m is mounted by a small hinge on a wall. The beam is…

Q: A window washer is standing on a scaffold supported by a vertical rope at each end. The scaffold…

Q: An 66 kg man is climbing up a 7.0 m ladder that is resting against a smooth, frictionless wall. The…

A: An 66 kg man is climbing up a 7.0 m ladder that is resting against a smooth, frictionless wall. The…

Q: A horizontal L=1.3 m long mb=15 kg uniform bar is hinged on the left end and pulled at the right end…

Q: CAN THE SYSTEM AS SHOWN IN THE FIGURE BE IN STATIC EQUILIBRIUM IN THE POSITION SHOWN? THE UNIFORM…

A: A system in static equilibrium is defined as the one, in which there is no acceleration in any…

Q: An elastic rope is stretched between the tops of two identical posts. A man is to walk along the…

Q: A uniform beam of length L = 7.70 m and weight 4.95 x 10² N is carried by two workers, Sam and Joe,…

A: Given data: Length of the beam is, L= 7.70 m Weight of the beam is, W= 4.95×102 N Formula used: At…

Q: The 1,094 kg uniform beam is subjected to the three external loads shown. Compute the force reaction…

A: In this question we are given that The 1,094 kg uniform beam is subjected to the three external…

Q: Cable AB passes over the small ideal pulley C without a change in its tension. What length of cable…

Q: As shown in the figure, a 10 m long bar is attached by a frictionless hinge to a wall and held…

A: Given: The length of the rod is 10 m. The weight of the rod is 66.5 N. The tension in the rope is…

Q: The upper end of a wide-skid W 8 × 21 steel column (E = 30 × 103 ksi) is supported laterally between…

A: Write the given values of the problem- E=30x103 ksi W 8X21 L=13 ft

Q: bridge, with L, consists of a weight neld up one suppor and a second support 80% of the way across…

Q: A safe mass M = 430kg hangs by a rope from a boom has a mass m = 85kg. Find the tension T, in the…

Q: A trapeze artist weighs 8 x 102 N. The artist is momentarily held to one side of a swing by a…

A: Weight (w) = 800 N θ = 30o

Concept explainers

Rotational Equilibrium And Rotational Dynamics

In physics, the state of balance between the forces and the dynamics of motion is called the equilibrium state. The balance between various forces acting on a system in a rotational motion is called rotational equilibrium or rotational dynamics.

Equilibrium of Forces

The tension created on one body during push or pull is known as force.

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

An aluminium (=2.7g/cm3) wire is suspended from the ceiling and hangs vertically. How long must the wire be before the stress at its upper end reaches the proportionality limit, which is 8.0107N/m2 ?
A uniform horizontal strut weighs 400.0 N. One end of the strut is attached to a hinged support the wall and the other end of the strut is attached to a sign that weighs 200.0 N The strut is also supported by a cable attached between the end of the strut and the wall. Assuming that the entire weight of the sign is attached at the very end of the s find the tension in the cable and the force at the hinge of the strut.
A trapeze artist, with swing, weighs 800 N; he is momentarily held to one side by his partner so that the swing ropes make an angle of 30.0° with the vertical. In such a condition of static equilibrium, what is the horizontal force being applied by the partner?
A 650-N billboard worker stands on a 4.05-m scaffold weighing 600 N and supported by vertical ropes at each end. How far would the worker stand from one of the supporting ropes to produce a tension of 660 N in that rope?
An 700N window cleaner stands on a 3.0 m uniform scaffold that weighs around 400 N. It is supported by ( vertical)ropes at each end. How far would the cleaner stand the supporting rope to produce a tension of 540 N in that rope?
A 30 kN horizontal force and 40 kN vertical force is directed 53 degrees wrt x axis to the upper right, at what angle (in degrees) will forces of the same magnitude be directed to the lower left to produce equilibrium?
From the step ladder shown in the figure, sides AC and CE are each 2.44 m long and hinged at point C. Bar BD is a tie-rod 0.762 m long, halfway up. A man weighing 845 N climbs 1.8 m along the ladder. Assuming the floor is frictionless and neglecting the mass of the ladder, find the tension (in N) in the tie-rod.
As shown in the figure below, a uniform beam is supported by a cable at one end and the force of friction at the other end. The cable makes an angle of ? = 30°, the length of the beam is L = 4.75 m, the coefficient of static friction between the wall and the beam is μs = 0.520, and the weight of the beam is represented by w. Determine the minimum distance x from point A at which an additional weight 2w (twice the weight of the rod) can be hung without causing the rod to slip at point A.X =. m
As shown in the figure below, a uniform beam is supported by a cable at one end and the force of friction at the other end. The cable makes an angle of ? = 30°,the length of the beam is L = 2.75 m,the coefficient of static friction between the wall and the beam is ?s = 0.460, and the weight of the beam is represented by w. Determine the minimum distance x from point A at which an additional weight 2w (twice the weight of the rod) can be hung without causing the rod to slip at point A.x = _________m
As the angle between two concurrent angles decreases, does the magnitude of the force required to produce equilibrium increase, decrease, or the stay the same?
A fisherman has caught a fish on his pole, and to keep the pole steady he has to apply an upward force of F_{2} = 205N at an angle of 50.5with respect to the pole (see figure). The length of his pole is 3.5 mand he is holding it a distance 0.75 m from the end, where he is applying a downward force F_{1}. Part A : with how much force , F1 in newtons does he have to push downward on the end of his pole to keep the pole from moving? You may assume the pole is massless. Part b: what is the mass of the fish on the end of the pole in kilogram ?
As shown in the figure below, a uniform beam is supported by a cable at one end and the force of friction at the other end. The cable makes an angle of ? = 30°, the length of the beam is L = 2.00 m, the coefficient of static friction between the wall and the beam is ?s = 0.460, and the weight of the beam is represented by w. Determine the minimum distance x from point A at which an additional weight 2w (twice the weight of the rod) can be hung without causing the rod to slip at point A.x =______ m