A water jet with velocity of 15 m/sec leaving the 10 cm diameter nozzle strike to the plate in normal direction. Upon impact with the plate, the water is equally divided into two parts, i.e. one half leaves at 60° with respect to horizontal and the other half in a straight vertical direction. The density of water is 1000 kg/m3. Find the velocity at outlet neglecting change in elevation between inlet and outlet, gravity and friction between water and plate. Show your control volume a)15 m/sec, cv is plate with water

Q: Consider the incompressible flow of water through a divergent duct. The inlet velocity and area are…

A: Inlet velocity = 5 ft/s Inlet area = 10 ft2

Q: A fan running at 1480 rpm takes in 6 m^3/min of air at inlet conditions of P_1=950 mbar and T_1=15^0…

A: Given, Speed,  N=1480 rpm Volume rate, Q=6m3/min Inlet pressure, P1=950 m bar Inlet Temperature,…

Q: A 3-in-diameter horizontal jet of water, with velocity 140 ft/s, strikes a bent plate, which…

A: Given data: Diameter of jet ,D = 3 in. Velocity of jet, V = 140 ft/sec Density of water, ρ = 62.4…

Q: and it impinges normally on a flat plate moving away from it at 10 m/s. The cross-section

A: solution:velocity of water V=20m/sdensity ρ=1000kg/m3area A=0.01m2u=10m/s

Q: A jet of diesel with relative density 0.8 strikes normally a plate with a velocity of 12 m/s. The…

A:

Q: A 2.8 m3/s water jet hits a stationary splitter, such that half of the flow is diverted upward at…

A:

Q: Water enters and leaves the 6-cm-diameter pipe bend inFig. P3.45 at an average velocity of 8.5 m/s.…

A: Write the given data:

Q: 1. While watering plants, a home owner is experimenting with his water hose. He sprayed the water…

A: Answer: The plate can be suspended at the height of 3.98 m above the tip of hose.

Q: Q1. A jet of water is ejected vertically from a nozzle of diameter 15 mm with a velocity of 10 m/s.…

A:

Q: A 3 in diameter horizontal water jet having a velocity of 140 ft/s strikes a curved plate, which…

A:

Q: a) Is it true that if a flow doesn't change its magnitude or direction, there will be no net…

A: Given data: The length of the water sheet is l = 5 cm. The diagram of the scoop is given as,…

Q: An ideal water jet with volume flow rate of 0.02 m*3/s strikes a flat plate placed normal to its…

A:

Q: A free jet of water of velocity V strikes against a series of curved semi-cireular vanes…

A: Calculate the relative velocity of the water jet when it strikes the vanes. vr1=v1-u Here, vr1 is…

Q: Practice question Air flows steadily at low speed through a horizontal nozzle (by definition a…

A:

Q: A 5-cm-diameter horizontal jet of water, with velocity 30 m/s, strikes the tip of a horizontal cone,…

A: Write the given information. Write the expression of the area of the jet.

Q: A small cart that carries a single turning vane, with 0 = 45°, rolls on a level track. The cart mass…

A:

Q: (d) Water of density 998 kg/m is moving with a speed of 6 m/s through pipe with cross-sectional area…

A: Every real fluid existing in nature must satisfy the equation of continuity. The equation says that…

Q: A jet of water discharges into an open tank, and water leaves the tank through an orifice in the…

A:

Q: A jet of freshwater strikes a series of vanes of a turbine at 25 degrees with the direction of…

A:

Q: left ventricle into the aorta can be modeled as a reducing nozzle (Figur below). Model both the left…

A: Given data as per questionFor Left ventricle, Loaction 1d1=3.1 cm=0.031 mv1=120 cm/s=1.2 m/sP1=130…

Q: A 5-cm-diameter horizontal jet of water, with velocity 30 m/s, strikes the tip of a horizontal cone,…

A: Given data: The diameter of jet, d = 5 cm. The velocity, v = 30 m/s. The deflected angle, Ɵ = 60o.…

Q: If a jet is inclined upward 30O from the horizontal, what must be its velocity to reach over a 3-m…

A: Consider the diagram as shown below for the given system.

Q: The nozzle discharges fluid into atmosphere through two identical outlets at the same jet velocity…

A: Given :-ρ=616kg/m3U=5.9m/sA=336cm2 =0.0336m2Pgauge>0momentum flux correction factor β=1.12Cross…

Q: atm FR Out A water jet with a uniform velocity profile, whose average speed is increased to 8 m/s…

A: Given data  Average speed increased = 8m/s  Outlet diameter = 10cm  To calculate  Force = ??

Q: Water enters a two-armed lawn sprinkler along the vertical axis at a rate of 150 L/s, and leaves the…

A: Given Data: The flow rate of water is, Q=150 L/s=150 L/s×10-3 m3L=0.15 m3/s. The diameter of the…

Q: Q3) A) A water jet issues from a nozzle 5 cm diameter, strikes a plate with a velocity of 30 m/sec.…

A:

Q: A jet of water 50 mm in diameter having a velocity of 20 m/s strikes normally a flat smooth plate.…

A: Given, Diameter of jet = d = 50 mm = 0.05 m Velocity of jet = v = 20 m/s Velocity of the plate in…

Q: n this situation, a 90 degree elbow pipe is used to direct water flow in an upwards direction, at a…

A:

Q: 50 kg Q6) A water jet hits horizontally a 50-kg block with a velocity of (20 m/s), see the figure.…

A:

Q: The water (density 1000 kg/m3) leaves the nozzle (area of the nozzle-0.01 m). Assuming steady,…

A:

Q: Q3. A pump draws water through a 20-cm suction pipe and discharges it through a 10- cm pipe in which…

A:

Q: garden hose attached with a nozzle is used to fill a 20 Liters bucket. The inner diameter of the…

A:

Q: Blood flow from the left ventricle into the aorta can be modeled as a reducing nozzle (Figure…

A: Given:Diameter at left ventricle, D1=3.1 cm=0.031 mDiameter at aorta, D2=2.7 cm=0.027 mPressure head…

Q: The water (density =1000 kg/m3) leaves the nozzle (area of the nozzle=0.01 m). Assuming steady,…

A: GIVEN :- height of stagnation tube : h= 50 cm area of nozzle : A= 0.01 m2 S.G = 10.4  ρ=10400 kg/m3…

Q: A horizontal jet of water issues from a nozzle 7.5 cm diamter under an effective head of 67.5 m and…

A:

Q: A 3-in-diameter horizontal water jet having a velocity of 90 ft/s strikes a curved plate, which…

A: Given: The diameter of jet, d = 3 in The velocity of the jet striking curved plate, v = 90 ft/s The…

Q: A water jet with velocity of 15 m/sec leaving the 10 cm diameter nozzle strike to the plate in…

A: Given Data: The velocity of the incoming jet is V1= 15 m/s. The diameter of the nozzle is d = 10…

Q: A 4-cm-diameter horizontal stationary water jet having a velocity of 50 m/s strikes a cone having in…

A:

Q: A horizontal pipe has a 180 degree bend with a uniform inside diameter of 150 mm (Cross Sectional…

A:

Q: A plate receives a jet of water (p = 1000 kg / m3) which it distributes symmetrically. The plate has…

A: ρ=1000 kgm3mass of plate M=756 KgQ=.4 m3secd=500 mm

Q: The water (density =1000 kg/m3) leaves the nozzle (area of the nozzle=0.01 m). Assuming steady,…

A: Given:ρ=1000 Kg/m3Area,A=0.01 m2S=12.2height of stagnation tube,x=0.5 m

Q: A jet is deflected by an angle of 90 degrees, as shown below. Before the impact on the blade (solid-…

A: Given: The angle of deflection, θ = 90° The velocity of jet, v = 17 m/s The diameter of jet, d = 10…

Q: Assuming that there are no heat effects and no frictional effects, find the kinetic and speed of a…

A:

Q: A 7.6 cm jet of water strikes a vertical plate in its centrod. Find the velocity of water through…

A:

Q: Homework A clrcular Jet of water at 20°C Implnges on the vane shown In figure. The Incldent jet has…

A:

Q: A jet of freshwater strikes a series of vanes of a turbine at 25° with the direction of motion and…

A:

Q: A fire hose discharges water through a nozzle having a diameter of 2.5 cm. The head lost in the…

A: Given: To determine the flow rate and maximum range to which the stream can be thrown.

Q: - Given: Water from a pressurized tank fows out and creates a vertical jet as shown. 2. Total head…

A: Datum is considered as the dotted line in the given Figure. Given, Air pressure inside the tank,…

Q: The water (density =1000 kg/m3) leaves the nozzle (area of the nozzle=0.01 m). Assuming steady,…

A: